1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
|
STMicroelectronics SoC DWMAC glue layer controller
This file documents differences between the core properties in
Documentation/devicetree/bindings/net/stmmac.txt
and what is needed on STi platforms to program the stmmac glue logic.
The device node has following properties.
Required properties:
- compatible : "st,stih407-dwmac"
- st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
encompases the glue register, and the offset of the control register.
- st,gmac_en: this is to enable the gmac into a dedicated sysctl control
register available on STiH407 SoC.
- pinctrl-0: pin-control for all the MII mode supported.
Optional properties:
- resets : phandle pointing to the system reset controller with correct
reset line index for ethernet reset.
- st,ext-phyclk: valid only for RMII where PHY can generate 50MHz clock or
MAC can generate it.
- st,tx-retime-src: This specifies which clk is wired up to the mac for
retimeing tx lines. This is totally board dependent and can take one of the
possible values from "txclk", "clk_125" or "clkgen".
If not passed, the internal clock will be used by default.
- sti-ethclk: this is the phy clock.
- sti-clkconf: this is an extra sysconfig register, available in new SoCs,
to program the clk retiming.
- st,gmac_en: to enable the GMAC, this only is present in some SoCs; e.g.
STiH407.
Example:
ethernet0: dwmac@9630000 {
device_type = "network";
compatible = "st,stih407-dwmac", "snps,dwmac", "snps,dwmac-3.710";
reg = <0x9630000 0x8000>;
reg-names = "stmmaceth";
st,syscon = <&syscfg_sbc_reg 0x80>;
st,gmac_en;
resets = <&softreset STIH407_ETH1_SOFTRESET>;
reset-names = "stmmaceth";
interrupts = <GIC_SPI 98 IRQ_TYPE_NONE>,
<GIC_SPI 99 IRQ_TYPE_NONE>,
<GIC_SPI 100 IRQ_TYPE_NONE>;
interrupt-names = "macirq", "eth_wake_irq", "eth_lpi";
snps,pbl = <32>;
snps,mixed-burst;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_rgmii1>;
clock-names = "stmmaceth", "sti-ethclk";
clocks = <&CLK_S_C0_FLEXGEN CLK_EXT2F_A9>,
<&CLK_S_C0_FLEXGEN CLK_ETH_PHY>;
};
|
