blob: 10adeb0d703d486694468ae15ea906849a8afaa9 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
|
* HTS221 STM humidity + temperature sensor
Required properties:
- compatible: should be "st,hts221"
- reg: i2c address of the sensor / spi cs line
Optional properties:
- drive-open-drain: the interrupt/data ready line will be configured
as open drain, which is useful if several sensors share the same
interrupt line. This is a boolean property.
If the requested interrupt is configured as IRQ_TYPE_LEVEL_HIGH or
IRQ_TYPE_EDGE_RISING a pull-down resistor is needed to drive the line
when it is not active, whereas a pull-up one is needed when interrupt
line is configured as IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING.
Refer to pinctrl/pinctrl-bindings.txt for the property description.
- interrupt-parent: should be the phandle for the interrupt controller
- interrupts: interrupt mapping for IRQ. It should be configured with
flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or
IRQ_TYPE_EDGE_FALLING.
Refer to interrupt-controller/interrupts.txt for generic interrupt
client node bindings.
Example:
hts221@5f {
compatible = "st,hts221";
reg = <0x5f>;
interrupt-parent = <&gpio0>;
interrupts = <0 IRQ_TYPE_EDGE_RISING>;
};
|
