diff options
Diffstat (limited to 'Documentation/devicetree/bindings/usb/mediatek,mtu3.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/usb/mediatek,mtu3.txt | 12 |
1 files changed, 11 insertions, 1 deletions
diff --git a/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt b/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt index 3382b5cb471d..b9af7f5ee91d 100644 --- a/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt +++ b/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt @@ -16,7 +16,7 @@ Required properties: entry in clock-names - clock-names : must contain "sys_ck" for clock of controller, the following clocks are optional: - "ref_ck", "mcu_ck" and "dam_ck"; + "ref_ck", "mcu_ck" and "dma_ck"; - phys : see usb-hcd.txt in the current directory - dr_mode : should be one of "host", "peripheral" or "otg", refer to usb/generic.txt @@ -28,8 +28,13 @@ Optional properties: parent's address space - extcon : external connector for vbus and idpin changes detection, needed when supports dual-role mode. + it's considered valid for compatibility reasons, not allowed for + new bindings, and use "usb-role-switch" property instead. - vbus-supply : reference to the VBUS regulator, needed when supports dual-role mode. + it's considered valid for compatibility reasons, not allowed for + new bindings, and put into a usb-connector node. + see connector/usb-connector.txt. - pinctrl-names : a pinctrl state named "default" is optional, and need be defined if auto drd switch is enabled, that means the property dr_mode is set as "otg", and meanwhile the property "mediatek,enable-manual-drd" @@ -39,6 +44,8 @@ Optional properties: - maximum-speed : valid arguments are "super-speed", "high-speed" and "full-speed"; refer to usb/generic.txt + - usb-role-switch : use USB Role Switch to support dual-role switch, but + not extcon; see usb/generic.txt. - enable-manual-drd : supports manual dual-role switch via debugfs; usually used when receptacle is TYPE-A and also wants to support dual-role mode. @@ -61,6 +68,9 @@ The xhci should be added as subnode to mtu3 as shown in the following example if host mode is enabled. The DT binding details of xhci can be found in: Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.txt +The port would be added as subnode if use "usb-role-switch" property. + see graph.txt + Example: ssusb: usb@11271000 { compatible = "mediatek,mt8173-mtu3"; |