1 files changed, 0 insertions, 58 deletions
diff --git a/Documentation/devicetree/bindings/net/can/sja1000.txt b/Documentation/devicetree/bindings/net/can/sja1000.txt
deleted file mode 100644
index ac3160eca96a..000000000000
--- a/Documentation/devicetree/bindings/net/can/sja1000.txt
+++ /dev/null
@@ -1,58 +0,0 @@
-Memory mapped SJA1000 CAN controller from NXP (formerly Philips)
-
-Required properties:
-
-- compatible : should be one of "nxp,sja1000", "technologic,sja1000".
-
-- reg : should specify the chip select, address offset and size required
-	to map the registers of the SJA1000. The size is usually 0x80.
-
-- interrupts: property with a value describing the interrupt source
-	(number and sensitivity) required for the SJA1000.
-
-Optional properties:
-
-- reg-io-width : Specify the size (in bytes) of the IO accesses that
-	should be performed on the device.  Valid value is 1, 2 or 4.
-	This property is ignored for technologic version.
-	Default to 1 (8 bits).
-
-- nxp,external-clock-frequency : Frequency of the external oscillator
-	clock in Hz. Note that the internal clock frequency used by the
-	SJA1000 is half of that value. If not specified, a default value
-	of 16000000 (16 MHz) is used.
-
-- nxp,tx-output-mode : operation mode of the TX output control logic:
-	<0x0> : bi-phase output mode
-	<0x1> : normal output mode (default)
-	<0x2> : test output mode
-	<0x3> : clock output mode
-
-- nxp,tx-output-config : TX output pin configuration:
-	<0x01> : TX0 invert
-	<0x02> : TX0 pull-down (default)
-	<0x04> : TX0 pull-up
-	<0x06> : TX0 push-pull
-	<0x08> : TX1 invert
-	<0x10> : TX1 pull-down
-	<0x20> : TX1 pull-up
-	<0x30> : TX1 push-pull
-
-- nxp,clock-out-frequency : clock frequency in Hz on the CLKOUT pin.
-	If not specified or if the specified value is 0, the CLKOUT pin
-	will be disabled.
-
-- nxp,no-comparator-bypass : Allows to disable the CAN input comparator.
-
-For further information, please have a look to the SJA1000 data sheet.
-
-Examples:
-
-can@3,100 {
-	compatible = "nxp,sja1000";
-	reg = <3 0x100 0x80>;
-	interrupts = <2 0>;
-	interrupt-parent = <&mpic>;
-	nxp,external-clock-frequency = <16000000>;
-};
-