diff options
Diffstat (limited to 'Documentation/admin-guide/pm/cpufreq.rst')
| -rw-r--r-- | Documentation/admin-guide/pm/cpufreq.rst | 21 |
1 files changed, 18 insertions, 3 deletions
diff --git a/Documentation/admin-guide/pm/cpufreq.rst b/Documentation/admin-guide/pm/cpufreq.rst index a21369eba034..2d74af7f0efe 100644 --- a/Documentation/admin-guide/pm/cpufreq.rst +++ b/Documentation/admin-guide/pm/cpufreq.rst @@ -231,7 +231,7 @@ are the following: present). The existence of the limit may be a result of some (often unintentional) - BIOS settings, restrictions coming from a service processor or another + BIOS settings, restrictions coming from a service processor or other BIOS/HW-based mechanisms. This does not cover ACPI thermal limitations which can be discovered @@ -248,6 +248,20 @@ are the following: If that frequency cannot be determined, this attribute should not be present. +``cpuinfo_avg_freq`` + An average frequency (in KHz) of all CPUs belonging to a given policy, + derived from a hardware provided feedback and reported on a time frame + spanning at most few milliseconds. + + This is expected to be based on the frequency the hardware actually runs + at and, as such, might require specialised hardware support (such as AMU + extension on ARM). If one cannot be determined, this attribute should + not be present. + + Note that failed attempt to retrieve current frequency for a given + CPU(s) will result in an appropriate error, i.e.: EAGAIN for CPU that + remains idle (raised on ARM). + ``cpuinfo_max_freq`` Maximum possible operating frequency the CPUs belonging to this policy can run at (in kHz). @@ -293,7 +307,8 @@ are the following: Some architectures (e.g. ``x86``) may attempt to provide information more precisely reflecting the current CPU frequency through this attribute, but that still may not be the exact current CPU frequency as - seen by the hardware at the moment. + seen by the hardware at the moment. This behavior though, is only + available via c:macro:``CPUFREQ_ARCH_CUR_FREQ`` option. ``scaling_driver`` The scaling driver currently in use. @@ -484,7 +499,7 @@ This governor exposes the following tunables: represented by it to be 1.5 times as high as the transition latency (the default):: - # echo `$(($(cat cpuinfo_transition_latency) * 3 / 2)) > ondemand/sampling_rate + # echo `$(($(cat cpuinfo_transition_latency) * 3 / 2))` > ondemand/sampling_rate ``up_threshold`` If the estimated CPU load is above this value (in percent), the governor |