Merge tag 'media/v5.11-1' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media

Pull media updates from Mauro Carvalho Chehab:

 - some rework at the uAPI pixel format docs

 - the smiapp driver has started to gain support for MIPI CSS camera
   sensors and was renamed

 - two new sensor drivers: ov02a10 and ov9734

 - Meson gained a driver for the 2D acceleration unit

 - Rockchip rkisp1 driver was promoted from staging

 - Cedrus driver gained support for VP8

 - two new remote controller keymaps were added

 - the usual set of fixes cleanups and driver improvements

* tag 'media/v5.11-1' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media: (447 commits)
  media: ccs: Add support for obtaining C-PHY configuration from firmware
  media: ccs-pll: Print pixel rates
  media: ccs: Print written register values
  media: ccs: Add support for DDR OP SYS and OP PIX clocks
  media: ccs-pll: Add support for DDR OP system and pixel clocks
  media: ccs: Dual PLL support
  media: ccs-pll: Add trivial dual PLL support
  media: ccs-pll: Separate VT divisor limit calculation from the rest
  media: ccs-pll: Fix VT post-PLL divisor calculation
  media: ccs-pll: Make VT divisors 16-bit
  media: ccs-pll: Rework bounds checks
  media: ccs-pll: Print relevant information on PLL tree
  media: ccs-pll: Better separate OP and VT sub-tree calculation
  media: ccs-pll: Check for derating and overrating, support non-derating sensors
  media: ccs-pll: Split off VT subtree calculation
  media: ccs-pll: Add C-PHY support
  media: ccs-pll: Add sanity checks
  media: ccs-pll: Add support flexible OP PLL pixel clock divider
  media: ccs-pll: Support two cycles per pixel on OP domain
  media: ccs-pll: Add support for extended input PLL clock divider
  ...

1 files changed, 0 insertions, 53 deletions

diff --git a/Documentation/devicetree/bindings/media/i2c/sony,imx214.txt b/Documentation/devicetree/bindings/media/i2c/sony,imx214.txt
deleted file mode 100644
index f11f28a5fda4..000000000000
--- a/Documentation/devicetree/bindings/media/i2c/sony,imx214.txt
+++ /dev/null
@@ -1,53 +0,0 @@
-* Sony 1/3.06-Inch 13.13Mp CMOS Digital Image Sensor
-
-The Sony imx214 is a 1/3.06-inch CMOS active pixel digital image sensor with
-an active array size of 4224H x 3200V. It is programmable through an I2C
-interface.
-Image data is sent through MIPI CSI-2, through 2 or 4 lanes at a maximum
-throughput of 1.2Gbps/lane.
-
-
-Required Properties:
-- compatible: Shall be "sony,imx214".
-- reg: I2C bus address of the device. Depending on how the sensor is wired,
-       it shall be <0x10> or <0x1a>;
-- enable-gpios: GPIO descriptor for the enable pin.
-- vdddo-supply: Chip digital IO regulator (1.8V).
-- vdda-supply: Chip analog regulator (2.7V).
-- vddd-supply: Chip digital core regulator (1.12V).
-- clocks: Reference to the xclk clock.
-- clock-frequency: Frequency of the xclk clock.
-
-Optional Properties:
-- flash-leds: See ../video-interfaces.txt
-- lens-focus: See ../video-interfaces.txt
-
-The imx214 device node shall contain one 'port' child node with
-an 'endpoint' subnode. For further reading on port node refer to
-Documentation/devicetree/bindings/media/video-interfaces.txt.
-
-Required Properties on endpoint:
-- data-lanes: check ../video-interfaces.txt
-- link-frequencies: check ../video-interfaces.txt
-- remote-endpoint: check ../video-interfaces.txt
-
-Example:
-
-	camera-sensor@1a {
-		compatible = "sony,imx214";
-		reg = <0x1a>;
-		vdddo-supply = <&pm8994_lvs1>;
-		vddd-supply = <&camera_vddd_1v12>;
-		vdda-supply = <&pm8994_l17>;
-		lens-focus = <&ad5820>;
-		enable-gpios = <&msmgpio 25 GPIO_ACTIVE_HIGH>;
-		clocks = <&mmcc CAMSS_MCLK0_CLK>;
-		clock-frequency = <24000000>;
-		port {
-			imx214_ep: endpoint {
-				data-lanes = <1 2 3 4>;
-				link-frequencies = /bits/ 64 <480000000>;
-				remote-endpoint = <&csiphy0_ep>;
-			};
-		};
-	};