diff options
Diffstat (limited to 'drivers/spi')
| -rw-r--r-- | drivers/spi/spi-cs42l43.c | 6 | ||||
| -rw-r--r-- | drivers/spi/spi-imx.c | 14 | ||||
| -rw-r--r-- | drivers/spi/spi-stm32-qspi.c | 12 | ||||
| -rw-r--r-- | drivers/spi/spi.c | 16 |
4 files changed, 20 insertions, 28 deletions
diff --git a/drivers/spi/spi-cs42l43.c b/drivers/spi/spi-cs42l43.c index 9d747ea69926..8b618ef0f711 100644 --- a/drivers/spi/spi-cs42l43.c +++ b/drivers/spi/spi-cs42l43.c @@ -26,7 +26,7 @@ #include <linux/units.h> #define CS42L43_FIFO_SIZE 16 -#define CS42L43_SPI_ROOT_HZ (40 * HZ_PER_MHZ) +#define CS42L43_SPI_ROOT_HZ 49152000 #define CS42L43_SPI_MAX_LENGTH 65532 enum cs42l43_spi_cmd { @@ -54,7 +54,7 @@ static const struct software_node ampr = { static struct spi_board_info ampl_info = { .modalias = "cs35l56", - .max_speed_hz = 20 * HZ_PER_MHZ, + .max_speed_hz = 11 * HZ_PER_MHZ, .chip_select = 0, .mode = SPI_MODE_0, .swnode = &l, @@ -62,7 +62,7 @@ static struct spi_board_info ampl_info = { static struct spi_board_info ampr_info = { .modalias = "cs35l56", - .max_speed_hz = 20 * HZ_PER_MHZ, + .max_speed_hz = 11 * HZ_PER_MHZ, .chip_select = 1, .mode = SPI_MODE_0, .swnode = &r, diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c index f4006c82f867..33164ebdb583 100644 --- a/drivers/spi/spi-imx.c +++ b/drivers/spi/spi-imx.c @@ -660,18 +660,8 @@ static int mx51_ecspi_prepare_transfer(struct spi_imx_data *spi_imx, ctrl |= (spi_imx->target_burst * 8 - 1) << MX51_ECSPI_CTRL_BL_OFFSET; else { - if (spi_imx->usedma) { - ctrl |= (spi_imx->bits_per_word - 1) - << MX51_ECSPI_CTRL_BL_OFFSET; - } else { - if (spi_imx->count >= MX51_ECSPI_CTRL_MAX_BURST) - ctrl |= (MX51_ECSPI_CTRL_MAX_BURST * BITS_PER_BYTE - 1) - << MX51_ECSPI_CTRL_BL_OFFSET; - else - ctrl |= (spi_imx->count / DIV_ROUND_UP(spi_imx->bits_per_word, - BITS_PER_BYTE) * spi_imx->bits_per_word - 1) - << MX51_ECSPI_CTRL_BL_OFFSET; - } + ctrl |= (spi_imx->bits_per_word - 1) + << MX51_ECSPI_CTRL_BL_OFFSET; } /* set clock speed */ diff --git a/drivers/spi/spi-stm32-qspi.c b/drivers/spi/spi-stm32-qspi.c index f1e922fd362a..955c920c4b63 100644 --- a/drivers/spi/spi-stm32-qspi.c +++ b/drivers/spi/spi-stm32-qspi.c @@ -349,7 +349,7 @@ static int stm32_qspi_wait_poll_status(struct stm32_qspi *qspi) static int stm32_qspi_get_mode(u8 buswidth) { - if (buswidth == 4) + if (buswidth >= 4) return CCR_BUSWIDTH_4; return buswidth; @@ -653,9 +653,7 @@ static int stm32_qspi_setup(struct spi_device *spi) return -EINVAL; mode = spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL); - if ((mode == SPI_TX_OCTAL || mode == SPI_RX_OCTAL) || - ((mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) && - gpiod_count(qspi->dev, "cs") == -ENOENT)) { + if (mode && gpiod_count(qspi->dev, "cs") == -ENOENT) { dev_err(qspi->dev, "spi-rx-bus-width\\/spi-tx-bus-width\\/cs-gpios\n"); dev_err(qspi->dev, "configuration not supported\n"); @@ -676,10 +674,10 @@ static int stm32_qspi_setup(struct spi_device *spi) qspi->cr_reg = CR_APMS | 3 << CR_FTHRES_SHIFT | CR_SSHIFT | CR_EN; /* - * Dual flash mode is only enable in case SPI_TX_OCTAL and SPI_TX_OCTAL - * are both set in spi->mode and "cs-gpios" properties is found in DT + * Dual flash mode is only enable in case SPI_TX_OCTAL or SPI_RX_OCTAL + * is set in spi->mode and "cs-gpios" properties is found in DT */ - if (mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) { + if (mode) { qspi->cr_reg |= CR_DFM; dev_dbg(qspi->dev, "Dual flash mode enable"); } diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c index 9bc9fd10d538..fc13fa192189 100644 --- a/drivers/spi/spi.c +++ b/drivers/spi/spi.c @@ -689,10 +689,12 @@ static int __spi_add_device(struct spi_device *spi) * Make sure that multiple logical CS doesn't map to the same physical CS. * For example, spi->chip_select[0] != spi->chip_select[1] and so on. */ - for (idx = 0; idx < SPI_CS_CNT_MAX; idx++) { - status = spi_dev_check_cs(dev, spi, idx, spi, idx + 1); - if (status) - return status; + if (!spi_controller_is_target(ctlr)) { + for (idx = 0; idx < SPI_CS_CNT_MAX; idx++) { + status = spi_dev_check_cs(dev, spi, idx, spi, idx + 1); + if (status) + return status; + } } /* Set the bus ID string */ @@ -4156,7 +4158,8 @@ static int __spi_validate(struct spi_device *spi, struct spi_message *message) return -EINVAL; if (xfer->tx_nbits != SPI_NBITS_SINGLE && xfer->tx_nbits != SPI_NBITS_DUAL && - xfer->tx_nbits != SPI_NBITS_QUAD) + xfer->tx_nbits != SPI_NBITS_QUAD && + xfer->tx_nbits != SPI_NBITS_OCTAL) return -EINVAL; if ((xfer->tx_nbits == SPI_NBITS_DUAL) && !(spi->mode & (SPI_TX_DUAL | SPI_TX_QUAD))) @@ -4171,7 +4174,8 @@ static int __spi_validate(struct spi_device *spi, struct spi_message *message) return -EINVAL; if (xfer->rx_nbits != SPI_NBITS_SINGLE && xfer->rx_nbits != SPI_NBITS_DUAL && - xfer->rx_nbits != SPI_NBITS_QUAD) + xfer->rx_nbits != SPI_NBITS_QUAD && + xfer->rx_nbits != SPI_NBITS_OCTAL) return -EINVAL; if ((xfer->rx_nbits == SPI_NBITS_DUAL) && !(spi->mode & (SPI_RX_DUAL | SPI_RX_QUAD))) |