1 files changed, 0 insertions, 30 deletions
diff --git a/Documentation/devicetree/bindings/iio/humidity/hts221.txt b/Documentation/devicetree/bindings/iio/humidity/hts221.txt
deleted file mode 100644
index 84d029372260..000000000000
--- a/Documentation/devicetree/bindings/iio/humidity/hts221.txt
+++ /dev/null
@@ -1,30 +0,0 @@
-* HTS221 STM humidity + temperature sensor
-
-Required properties:
-- compatible: should be "st,hts221"
-- reg: i2c address of the sensor / spi cs line
-
-Optional properties:
-- drive-open-drain: the interrupt/data ready line will be configured
-  as open drain, which is useful if several sensors share the same
-  interrupt line. This is a boolean property.
-  If the requested interrupt is configured as IRQ_TYPE_LEVEL_HIGH or
-  IRQ_TYPE_EDGE_RISING a pull-down resistor is needed to drive the line
-  when it is not active, whereas a pull-up one is needed when interrupt
-  line is configured as IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING.
-  Refer to pinctrl/pinctrl-bindings.txt for the property description.
-- interrupts: interrupt mapping for IRQ. It should be configured with
-  flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or
-  IRQ_TYPE_EDGE_FALLING.
-
-  Refer to interrupt-controller/interrupts.txt for generic interrupt
-  client node bindings.
-
-Example:
-
-hts221@5f {
-	compatible = "st,hts221";
-	reg = <0x5f>;
-	interrupt-parent = <&gpio0>;
-	interrupts = <0 IRQ_TYPE_EDGE_RISING>;
-};