1 files changed, 0 insertions, 52 deletions
diff --git a/Documentation/devicetree/bindings/gpio/brcm,kona-gpio.txt b/Documentation/devicetree/bindings/gpio/brcm,kona-gpio.txt
deleted file mode 100644
index 4a63bc96b687..000000000000
--- a/Documentation/devicetree/bindings/gpio/brcm,kona-gpio.txt
+++ /dev/null
@@ -1,52 +0,0 @@
-Broadcom Kona Family GPIO
-=========================
-
-This GPIO driver is used in the following Broadcom SoCs:
-  BCM11130, BCM11140, BCM11351, BCM28145, BCM28155
-
-The Broadcom GPIO Controller IP can be configured prior to synthesis to
-support up to 8 banks of 32 GPIOs where each bank has its own IRQ. The
-GPIO controller only supports edge, not level, triggering of interrupts.
-
-Required properties
--------------------
-
-- compatible: "brcm,bcm11351-gpio", "brcm,kona-gpio"
-- reg: Physical base address and length of the controller's registers.
-- interrupts: The interrupt outputs from the controller. There is one GPIO
-  interrupt per GPIO bank. The number of interrupts listed depends on the
-  number of GPIO banks on the SoC. The interrupts must be ordered by bank,
-  starting with bank 0. There is always a 1:1 mapping between banks and
-  IRQs.
-- #gpio-cells: Should be <2>. The first cell is the pin number, the second
-  cell is used to specify optional parameters:
-  - bit 0 specifies polarity (0 for normal, 1 for inverted)
-  See also "gpio-specifier" in .../devicetree/bindings/gpio/gpio.txt.
-- #interrupt-cells: Should be <2>. The first cell is the GPIO number. The
-  second cell is used to specify flags. The following subset of flags is
-  supported:
-  - trigger type (bits[1:0]):
-      1 = low-to-high edge triggered.
-      2 = high-to-low edge triggered.
-      3 = low-to-high or high-to-low edge triggered
-      Valid values are 1, 2, 3
-  See also .../devicetree/bindings/interrupt-controller/interrupts.txt.
-- gpio-controller: Marks the device node as a GPIO controller.
-- interrupt-controller: Marks the device node as an interrupt controller.
-
-Example:
-	gpio: gpio@35003000 {
-		compatible = "brcm,bcm11351-gpio", "brcm,kona-gpio";
-		reg = <0x35003000 0x800>;
-		interrupts =
-		       <GIC_SPI 106 IRQ_TYPE_LEVEL_HIGH
-			GIC_SPI 115 IRQ_TYPE_LEVEL_HIGH
-			GIC_SPI 114 IRQ_TYPE_LEVEL_HIGH
-			GIC_SPI 113 IRQ_TYPE_LEVEL_HIGH
-			GIC_SPI 112 IRQ_TYPE_LEVEL_HIGH
-			GIC_SPI 111 IRQ_TYPE_LEVEL_HIGH>;
-		#gpio-cells = <2>;
-		#interrupt-cells = <2>;
-		gpio-controller;
-		interrupt-controller;
-	};