diff options
| -rw-r--r-- | drivers/net/ethernet/sun/cassini.c | 8 | ||||
| -rw-r--r-- | drivers/net/ethernet/sun/cassini.h | 16 | ||||
| -rw-r--r-- | drivers/net/ethernet/sun/sunbmac.h | 2 | ||||
| -rw-r--r-- | drivers/net/ethernet/sun/sungem.c | 4 | ||||
| -rw-r--r-- | drivers/net/ethernet/sun/sungem.h | 4 | ||||
| -rw-r--r-- | drivers/net/ethernet/sun/sunhme.c | 2 |
6 files changed, 18 insertions, 18 deletions
diff --git a/drivers/net/ethernet/sun/cassini.c b/drivers/net/ethernet/sun/cassini.c index 823870c999bf..9a8b5cf2d648 100644 --- a/drivers/net/ethernet/sun/cassini.c +++ b/drivers/net/ethernet/sun/cassini.c @@ -1027,7 +1027,7 @@ static int cas_pcs_link_check(struct cas *cp) * point a bit earlier in the sequence. If we had * generated a reset a short time ago, we'll wait for * the link timer to check the status until a - * timer expires (link_transistion_jiffies_valid is + * timer expires (link_transition_jiffies_valid is * true when the timer is running.) Instead of using * a system timer, we just do a check whenever the * link timer is running - this clears the flag after @@ -4545,7 +4545,7 @@ static int cas_get_link_ksettings(struct net_device *dev, } if (linkstate != link_up) { /* Force these to "unknown" if the link is not up and - * autonogotiation in enabled. We can set the link + * autonegotiation is enabled. We can set the link * speed to 0, but not cmd->duplex, * because its legal values are 0 and 1. Ethtool will * print the value reported in parentheses after the @@ -4797,7 +4797,7 @@ static void cas_program_bridge(struct pci_dev *cas_pdev) */ pci_write_config_word(pdev, 0x50, (5 << 10) | 0x3ff); - /* The Read Prefecth Policy register is 16-bit and sits at + /* The Read Prefetch Policy register is 16-bit and sits at * offset 0x52. It enables a "smart" pre-fetch policy. We * enable it and max out all of the settings since only one * device is sitting underneath and thus bandwidth sharing is @@ -4904,7 +4904,7 @@ static int cas_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) /* * On some architectures, the default cache line size set - * by pci_try_set_mwi reduces perforamnce. We have to increase + * by pci_try_set_mwi reduces performance. We have to increase * it for this case. To start, we'll print some configuration * data. */ diff --git a/drivers/net/ethernet/sun/cassini.h b/drivers/net/ethernet/sun/cassini.h index 2d91f4936d52..0c24547a4534 100644 --- a/drivers/net/ethernet/sun/cassini.h +++ b/drivers/net/ethernet/sun/cassini.h @@ -259,7 +259,7 @@ /* output enables are provided for each device's chip select and for the rest * of the outputs from cassini to its local bus devices. two sw programmable - * bits are connected to general purpus control/status bits. + * bits are connected to general purpose control/status bits. * DEFAULT: 0x7 */ #define REG_BIM_LOCAL_DEV_EN 0x1020 /* BIM local device @@ -404,7 +404,7 @@ GMII on SERDES pins for monitoring. */ #define SATURN_PCFG_FSI 0x00000200 /* 1 = freeze serdes/gmii. all - pins configed as outputs. + pins configured as outputs. for power saving when using internal phy. */ #define SATURN_PCFG_LAD 0x00000800 /* 0 = mac core led ctrl @@ -622,7 +622,7 @@ enabled */ #define RX_CFG_SWIVEL_MASK 0x00001C00 /* byte offset of the 1st data byte of the packet - w/in 8 byte boundares. + w/in 8 byte boundaries. this swivels the data DMA'ed to header buffers, jumbo buffers @@ -1248,7 +1248,7 @@ */ #define REG_MAC_TX_STATUS 0x6010 /* TX MAC status reg */ #define MAC_TX_FRAME_XMIT 0x0001 /* successful frame - transmision */ + transmission */ #define MAC_TX_UNDERRUN 0x0002 /* terminated frame transmission due to data starvation in the @@ -1414,7 +1414,7 @@ * when passed to the host. to ensure proper operation, need to wait 3.2ms * after clearing RX_CFG_EN before writing to any other RX MAC registers * or other MAC parameters. alternatively, poll RX_CFG_EN until it clears - * to 0. similary, HASH_FILTER_EN and ADDR_FILTER_EN have the same + * to 0. Similarly, HASH_FILTER_EN and ADDR_FILTER_EN have the same * restrictions as CFG_EN. */ #define REG_MAC_RX_CFG 0x6034 /* RX MAC config reg */ @@ -1670,7 +1670,7 @@ * programmed in frame mode. load this register w/ a valid instruction * (as per IEEE 802.3u MII spec). poll this register to check for instruction * execution completion. during a read operation, this register will also - * contain the 16-bit data returned by the tranceiver. unless specified + * contain the 16-bit data returned by the transceiver. unless specified * otherwise, fields are considered "don't care" when polling for * completion. */ @@ -1734,7 +1734,7 @@ #define MIF_CFG_POLL_REG_SHIFT 3 #define MIF_CFG_MDIO_0 0x0100 /* (ro) dual purpose. when MDIO_0 is idle, - 1 -> tranceiver is + 1 -> transceiver is connected to MDIO_0. when MIF is communicating w/ MDIO_0 in bit-bang @@ -1750,7 +1750,7 @@ mode, this bit indicates the incoming bit stream during a read op */ -#define MIF_CFG_POLL_PHY_MASK 0x7C00 /* tranceiver address to +#define MIF_CFG_POLL_PHY_MASK 0x7C00 /* transceiver address to be polled */ #define MIF_CFG_POLL_PHY_SHIFT 10 diff --git a/drivers/net/ethernet/sun/sunbmac.h b/drivers/net/ethernet/sun/sunbmac.h index d379bd407eca..85778edcf8dc 100644 --- a/drivers/net/ethernet/sun/sunbmac.h +++ b/drivers/net/ethernet/sun/sunbmac.h @@ -205,7 +205,7 @@ #define FRAME_WRITE 0x50020000 #define FRAME_READ 0x60020000 -/* Tranceiver registers. */ +/* Transceiver registers. */ #define TCVR_PAL_SERIAL 0x00000001 /* Enable serial mode */ #define TCVR_PAL_EXTLBACK 0x00000002 /* Enable external loopback */ #define TCVR_PAL_MSENSE 0x00000004 /* Media sense */ diff --git a/drivers/net/ethernet/sun/sungem.c b/drivers/net/ethernet/sun/sungem.c index 234ffc3c6a61..b56a0d4cdb12 100644 --- a/drivers/net/ethernet/sun/sungem.c +++ b/drivers/net/ethernet/sun/sungem.c @@ -2179,7 +2179,7 @@ static void gem_do_stop(struct net_device *dev, int wol) * if we did. This is not an issue however as the reset * task is synchronized vs. us (rtnl_lock) and will do * nothing if the device is down or suspended. We do - * still clear reset_task_pending to avoid a spurrious + * still clear reset_task_pending to avoid a spurious * reset later on in case we do resume before it gets * scheduled. */ @@ -2362,7 +2362,7 @@ static int __maybe_unused gem_resume(struct device *dev_d) gem_do_start(dev); /* If we had WOL enabled, the cell clock was never turned off during - * sleep, so we end up beeing unbalanced. Fix that here + * sleep, so we end up being unbalanced. Fix that here */ if (gp->asleep_wol) gem_put_cell(gp); diff --git a/drivers/net/ethernet/sun/sungem.h b/drivers/net/ethernet/sun/sungem.h index 626302a9bc89..b921d3074017 100644 --- a/drivers/net/ethernet/sun/sungem.h +++ b/drivers/net/ethernet/sun/sungem.h @@ -352,7 +352,7 @@ #define MAC_HASH14 0x60F8UL /* Hash Table 14 Register */ #define MAC_HASH15 0x60FCUL /* Hash Table 15 Register */ #define MAC_NCOLL 0x6100UL /* Normal Collision Counter */ -#define MAC_FASUCC 0x6104UL /* First Attmpt. Succ Coll Ctr. */ +#define MAC_FASUCC 0x6104UL /* First Attempt. Succ Coll Ctr.*/ #define MAC_ECOLL 0x6108UL /* Excessive Collision Counter */ #define MAC_LCOLL 0x610CUL /* Late Collision Counter */ #define MAC_DTIMER 0x6110UL /* Defer Timer */ @@ -657,7 +657,7 @@ /* MIF Frame/Output Register. This 32-bit register allows the host to * communicate with a transceiver in frame mode (as opposed to big-bang - * mode). Writes by the host specify an instrution. After being issued + * mode). Writes by the host specify an instruction. After being issued * the host must poll this register for completion. Also, after * completion this register holds the data returned by the transceiver * if applicable. diff --git a/drivers/net/ethernet/sun/sunhme.c b/drivers/net/ethernet/sun/sunhme.c index 4c9d5d4dd8a0..a70f704eb9f3 100644 --- a/drivers/net/ethernet/sun/sunhme.c +++ b/drivers/net/ethernet/sun/sunhme.c @@ -1118,7 +1118,7 @@ static void happy_meal_transceiver_check(struct happy_meal *hp, void __iomem *tr * * We use skb_reserve() to align the data block we get in the skb. We * also program the etxregs->cfg register to use an offset of 2. This - * imperical constant plus the ethernet header size will always leave + * empirical constant plus the ethernet header size will always leave * us with a nicely aligned ip header once we pass things up to the * protocol layers. * |
