Merge tag 'hwparam-20170420' of git://git.kernel.org/pub/scm/linux/kernel/git/dhowells/linux-fs

Pull hw lockdown support from David Howells:
 "Annotation of module parameters that configure hardware resources
  including ioports, iomem addresses, irq lines and dma channels.

  This allows a future patch to prohibit the use of such module
  parameters to prevent that hardware from being abused to gain access
  to the running kernel image as part of locking the kernel down under
  UEFI secure boot conditions.

  Annotations are made by changing:

        module_param(n, t, p)
        module_param_named(n, v, t, p)
        module_param_array(n, t, m, p)

  to:

        module_param_hw(n, t, hwtype, p)
        module_param_hw_named(n, v, t, hwtype, p)
        module_param_hw_array(n, t, hwtype, m, p)

  where the module parameter refers to a hardware setting

  hwtype specifies the type of the resource being configured. This can
  be one of:

        ioport          Module parameter configures an I/O port
        iomem           Module parameter configures an I/O mem address
        ioport_or_iomem Module parameter could be either (runtime set)
        irq             Module parameter configures an I/O port
        dma             Module parameter configures a DMA channel
        dma_addr        Module parameter configures a DMA buffer address
        other           Module parameter configures some other value

  Note that the hwtype is compile checked, but not currently stored (the
  lockdown code probably won't require it). It is, however, there for
  future use.

  A bonus is that the hwtype can also be used for grepping.

  The intention is for the kernel to ignore or reject attempts to set
  annotated module parameters if lockdown is enabled. This applies to
  options passed on the boot command line, passed to insmod/modprobe or
  direct twiddling in /sys/module/ parameter files.

  The module initialisation then needs to handle the parameter not being
  set, by (1) giving an error, (2) probing for a value or (3) using a
  reasonable default.

  What I can't do is just reject a module out of hand because it may
  take a hardware setting in the module parameters. Some important
  modules, some ipmi stuff for instance, both probe for hardware and
  allow hardware to be manually specified; if the driver is aborts with
  any error, you don't get any ipmi hardware.

  Further, trying to do this entirely in the module initialisation code
  doesn't protect against sysfs twiddling.

  [!] Note that in and of itself, this series of patches should have no
      effect on the the size of the kernel or code execution - that is
      left to a patch in the next series to effect. It does mark
      annotated kernel parameters with a KERNEL_PARAM_FL_HWPARAM flag in
      an already existing field"

* tag 'hwparam-20170420' of git://git.kernel.org/pub/scm/linux/kernel/git/dhowells/linux-fs: (38 commits)
  Annotate hardware config module parameters in sound/pci/
  Annotate hardware config module parameters in sound/oss/
  Annotate hardware config module parameters in sound/isa/
  Annotate hardware config module parameters in sound/drivers/
  Annotate hardware config module parameters in fs/pstore/
  Annotate hardware config module parameters in drivers/watchdog/
  Annotate hardware config module parameters in drivers/video/
  Annotate hardware config module parameters in drivers/tty/
  Annotate hardware config module parameters in drivers/staging/vme/
  Annotate hardware config module parameters in drivers/staging/speakup/
  Annotate hardware config module parameters in drivers/staging/media/
  Annotate hardware config module parameters in drivers/scsi/
  Annotate hardware config module parameters in drivers/pcmcia/
  Annotate hardware config module parameters in drivers/pci/hotplug/
  Annotate hardware config module parameters in drivers/parport/
  Annotate hardware config module parameters in drivers/net/wireless/
  Annotate hardware config module parameters in drivers/net/wan/
  Annotate hardware config module parameters in drivers/net/irda/
  Annotate hardware config module parameters in drivers/net/hamradio/
  Annotate hardware config module parameters in drivers/net/ethernet/
  ...

6 files changed, 14 insertions, 14 deletions

diff --git a/drivers/tty/cyclades.c b/drivers/tty/cyclades.c
index 5e4fa9206861..104f09c58163 100644
--- a/drivers/tty/cyclades.c
+++ b/drivers/tty/cyclades.c
@@ -156,8 +156,8 @@ static unsigned int cy_isa_addresses[] = {
 static long maddr[NR_CARDS];
 static int irq[NR_CARDS];
 
-module_param_array(maddr, long, NULL, 0);
-module_param_array(irq, int, NULL, 0);
+module_param_hw_array(maddr, long, iomem, NULL, 0);
+module_param_hw_array(irq, int, irq, NULL, 0);
 
 #endif				/* CONFIG_ISA */
 
diff --git a/drivers/tty/moxa.c b/drivers/tty/moxa.c
index 4caf0c3b1f99..3b251f4e5df0 100644
--- a/drivers/tty/moxa.c
+++ b/drivers/tty/moxa.c
@@ -179,7 +179,7 @@ MODULE_FIRMWARE("c320tunx.cod");
 
 module_param_array(type, uint, NULL, 0);
 MODULE_PARM_DESC(type, "card type: C218=2, C320=4");
-module_param_array(baseaddr, ulong, NULL, 0);
+module_param_hw_array(baseaddr, ulong, ioport, NULL, 0);
 MODULE_PARM_DESC(baseaddr, "base address");
 module_param_array(numports, uint, NULL, 0);
 MODULE_PARM_DESC(numports, "numports (ignored for C218)");
diff --git a/drivers/tty/mxser.c b/drivers/tty/mxser.c
index 7b8f383fb090..8bd6fb6d9391 100644
--- a/drivers/tty/mxser.c
+++ b/drivers/tty/mxser.c
@@ -183,7 +183,7 @@ static int ttymajor = MXSERMAJOR;
 
 MODULE_AUTHOR("Casper Yang");
 MODULE_DESCRIPTION("MOXA Smartio/Industio Family Multiport Board Device Driver");
-module_param_array(ioaddr, ulong, NULL, 0);
+module_param_hw_array(ioaddr, ulong, ioport, NULL, 0);
 MODULE_PARM_DESC(ioaddr, "ISA io addresses to look for a moxa board");
 module_param(ttymajor, int, 0);
 MODULE_LICENSE("GPL");
diff --git a/drivers/tty/rocket.c b/drivers/tty/rocket.c
index d66c1edd9892..b51a877da986 100644
--- a/drivers/tty/rocket.c
+++ b/drivers/tty/rocket.c
@@ -250,15 +250,15 @@ static int sReadAiopNumChan(WordIO_t io);
 
 MODULE_AUTHOR("Theodore Ts'o");
 MODULE_DESCRIPTION("Comtrol RocketPort driver");
-module_param(board1, ulong, 0);
+module_param_hw(board1, ulong, ioport, 0);
 MODULE_PARM_DESC(board1, "I/O port for (ISA) board #1");
-module_param(board2, ulong, 0);
+module_param_hw(board2, ulong, ioport, 0);
 MODULE_PARM_DESC(board2, "I/O port for (ISA) board #2");
-module_param(board3, ulong, 0);
+module_param_hw(board3, ulong, ioport, 0);
 MODULE_PARM_DESC(board3, "I/O port for (ISA) board #3");
-module_param(board4, ulong, 0);
+module_param_hw(board4, ulong, ioport, 0);
 MODULE_PARM_DESC(board4, "I/O port for (ISA) board #4");
-module_param(controller, ulong, 0);
+module_param_hw(controller, ulong, ioport, 0);
 MODULE_PARM_DESC(controller, "I/O port for (ISA) rocketport controller");
 module_param(support_low_speed, bool, 0);
 MODULE_PARM_DESC(support_low_speed, "1 means support 50 baud, 0 means support 460400 baud");
diff --git a/drivers/tty/serial/8250/8250_core.c b/drivers/tty/serial/8250/8250_core.c
index 48a07e2f617f..1aab3010fbfa 100644
--- a/drivers/tty/serial/8250/8250_core.c
+++ b/drivers/tty/serial/8250/8250_core.c
@@ -1191,7 +1191,7 @@ module_exit(serial8250_exit);
 MODULE_LICENSE("GPL");
 MODULE_DESCRIPTION("Generic 8250/16x50 serial driver");
 
-module_param(share_irqs, uint, 0644);
+module_param_hw(share_irqs, uint, other, 0644);
 MODULE_PARM_DESC(share_irqs, "Share IRQs with other non-8250/16x50 devices (unsafe)");
 
 module_param(nr_uarts, uint, 0644);
@@ -1201,7 +1201,7 @@ module_param(skip_txen_test, uint, 0644);
 MODULE_PARM_DESC(skip_txen_test, "Skip checking for the TXEN bug at init time");
 
 #ifdef CONFIG_SERIAL_8250_RSA
-module_param_array(probe_rsa, ulong, &probe_rsa_count, 0444);
+module_param_hw_array(probe_rsa, ulong, ioport, &probe_rsa_count, 0444);
 MODULE_PARM_DESC(probe_rsa, "Probe I/O ports for RSA");
 #endif
 MODULE_ALIAS_CHARDEV_MAJOR(TTY_MAJOR);
diff --git a/drivers/tty/synclink.c b/drivers/tty/synclink.c
index 657eed82eeb3..a2c308f7d637 100644
--- a/drivers/tty/synclink.c
+++ b/drivers/tty/synclink.c
@@ -869,9 +869,9 @@ static int txholdbufs[MAX_TOTAL_DEVICES];
 	
 module_param(break_on_load, bool, 0);
 module_param(ttymajor, int, 0);
-module_param_array(io, int, NULL, 0);
-module_param_array(irq, int, NULL, 0);
-module_param_array(dma, int, NULL, 0);
+module_param_hw_array(io, int, ioport, NULL, 0);
+module_param_hw_array(irq, int, irq, NULL, 0);
+module_param_hw_array(dma, int, dma, NULL, 0);
 module_param(debug_level, int, 0);
 module_param_array(maxframe, int, NULL, 0);
 module_param_array(txdmabufs, int, NULL, 0);