1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
|
* Microchip ENC28J60
This is a standalone 10 MBit ethernet controller with SPI interface.
For each device connected to a SPI bus, define a child node within
the SPI master node.
Required properties:
- compatible: Should be "microchip,enc28j60"
- reg: Specify the SPI chip select the ENC28J60 is wired to
- interrupt-parent: Specify the phandle of the source interrupt, see interrupt
binding documentation for details. Usually this is the GPIO bank
the interrupt line is wired to.
- interrupts: Specify the interrupt index within the interrupt controller (referred
to above in interrupt-parent) and interrupt type. The ENC28J60 natively
generates falling edge interrupts, however, additional board logic
might invert the signal.
- pinctrl-names: List of assigned state names, see pinctrl binding documentation.
- pinctrl-0: List of phandles to configure the GPIO pin used as interrupt line,
see also generic and your platform specific pinctrl binding
documentation.
Optional properties:
- spi-max-frequency: Maximum frequency of the SPI bus when accessing the ENC28J60.
According to the ENC28J80 datasheet, the chip allows a maximum of 20 MHz, however,
board designs may need to limit this value.
- local-mac-address: See ethernet.txt in the same directory.
Example (for NXP i.MX28 with pin control stuff for GPIO irq):
ssp2: ssp@80014000 {
compatible = "fsl,imx28-spi";
pinctrl-names = "default";
pinctrl-0 = <&spi2_pins_b &spi2_sck_cfg>;
enc28j60: ethernet@0 {
compatible = "microchip,enc28j60";
pinctrl-names = "default";
pinctrl-0 = <&enc28j60_pins>;
reg = <0>;
interrupt-parent = <&gpio3>;
interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
spi-max-frequency = <12000000>;
};
};
pinctrl@80018000 {
enc28j60_pins: enc28j60_pins@0 {
reg = <0>;
fsl,pinmux-ids = <
MX28_PAD_AUART0_RTS__GPIO_3_3 /* Interrupt */
>;
fsl,drive-strength = <MXS_DRIVE_4mA>;
fsl,voltage = <MXS_VOLTAGE_HIGH>;
fsl,pull-up = <MXS_PULL_DISABLE>;
};
};
|
