blob: 2117d4ac1ae5cbe0a2005c72513c2ec7f80cc305 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
|
Broadcom BCM7038-style Level 1 interrupt controller
This block is a first level interrupt controller that is typically connected
directly to one of the HW INT lines on each CPU. Every BCM7xxx set-top chip
since BCM7038 has contained this hardware.
Key elements of the hardware design include:
- 64, 96, 128, or 160 incoming level IRQ lines
- Most onchip peripherals are wired directly to an L1 input
- A separate instance of the register set for each CPU, allowing individual
peripheral IRQs to be routed to any CPU
- Atomic mask/unmask operations
- No polarity/level/edge settings
- No FIFO or priority encoder logic; software is expected to read all
2-5 status words to determine which IRQs are pending
Required properties:
- compatible: should be "brcm,bcm7038-l1-intc"
- reg: specifies the base physical address and size of the registers;
the number of supported IRQs is inferred from the size argument
- interrupt-controller: identifies the node as an interrupt controller
- #interrupt-cells: specifies the number of cells needed to encode an interrupt
source, should be 1.
- interrupts: specifies the interrupt line(s) in the interrupt-parent controller
node; valid values depend on the type of parent interrupt controller
If multiple reg ranges and interrupt-parent entries are present on an SMP
system, the driver will allow IRQ SMP affinity to be set up through the
/proc/irq/ interface. In the simplest possible configuration, only one
reg range and one interrupt-parent is needed.
Example:
periph_intc: periph_intc@1041a400 {
compatible = "brcm,bcm7038-l1-intc";
reg = <0x1041a400 0x30 0x1041a600 0x30>;
interrupt-controller;
#interrupt-cells = <1>;
interrupt-parent = <&cpu_intc>;
interrupts = <2>, <3>;
};
|
