diff options
Diffstat (limited to 'drivers/scsi/aic7xxx/aic79xx_core.c')
| -rw-r--r-- | drivers/scsi/aic7xxx/aic79xx_core.c | 24 |
1 files changed, 12 insertions, 12 deletions
diff --git a/drivers/scsi/aic7xxx/aic79xx_core.c b/drivers/scsi/aic7xxx/aic79xx_core.c index 3233bf564435..5f8617dd43bb 100644 --- a/drivers/scsi/aic7xxx/aic79xx_core.c +++ b/drivers/scsi/aic7xxx/aic79xx_core.c @@ -562,7 +562,7 @@ ahd_targetcmd_offset(struct ahd_softc *ahd, u_int index) } #endif -/*********************** Miscelaneous Support Functions ***********************/ +/*********************** Miscellaneous Support Functions ***********************/ /* * Return pointers to the transfer negotiation information * for the specified our_id/remote_id pair. @@ -599,7 +599,7 @@ void ahd_outw(struct ahd_softc *ahd, u_int port, u_int value) { /* - * Write low byte first to accomodate registers + * Write low byte first to accommodate registers * such as PRGMCNT where the order maters. */ ahd_outb(ahd, port, value & 0xFF); @@ -2067,7 +2067,7 @@ ahd_handle_seqint(struct ahd_softc *ahd, u_int intstat) * that requires host assistance for completion. * While handling the message phase(s), we will be * notified by the sequencer after each byte is - * transfered so we can track bus phase changes. + * transferred so we can track bus phase changes. * * If this is the first time we've seen a HOST_MSG_LOOP * interrupt, initialize the state of the host message @@ -2487,7 +2487,7 @@ ahd_handle_scsiint(struct ahd_softc *ahd, u_int intstat) /* * Although the driver does not care about the * 'Selection in Progress' status bit, the busy - * LED does. SELINGO is only cleared by a successfull + * LED does. SELINGO is only cleared by a successful * selection, so we must manually clear it to insure * the LED turns off just incase no future successful * selections occur (e.g. no devices on the bus). @@ -3548,7 +3548,7 @@ ahd_clear_critical_section(struct ahd_softc *ahd) ahd_outb(ahd, SEQCTL0, ahd_inb(ahd, SEQCTL0) & ~STEP); ahd_outb(ahd, SIMODE1, simode1); /* - * SCSIINT seems to glitch occassionally when + * SCSIINT seems to glitch occasionally when * the interrupt masks are restored. Clear SCSIINT * one more time so that only persistent errors * are seen as a real interrupt. @@ -3838,7 +3838,7 @@ ahd_validate_width(struct ahd_softc *ahd, struct ahd_initiator_tinfo *tinfo, /* * Update the bitmask of targets for which the controller should - * negotiate with at the next convenient oportunity. This currently + * negotiate with at the next convenient opportunity. This currently * means the next time we send the initial identify messages for * a new transaction. */ @@ -4200,7 +4200,7 @@ ahd_update_neg_table(struct ahd_softc *ahd, struct ahd_devinfo *devinfo, /* * During packetized transfers, the target will - * give us the oportunity to send command packets + * give us the opportunity to send command packets * without us asserting attention. */ if ((tinfo->ppr_options & MSG_EXT_PPR_IU_REQ) == 0) @@ -5651,7 +5651,7 @@ ahd_handle_msg_reject(struct ahd_softc *ahd, struct ahd_devinfo *devinfo) /* * Requeue all tagged commands for this target - * currently in our posession so they can be + * currently in our possession so they can be * converted to untagged commands. */ ahd_search_qinfifo(ahd, SCB_GET_TARGET(ahd, scb), @@ -6245,7 +6245,7 @@ ahd_shutdown(void *arg) /* * Reset the controller and record some information about it * that is only available just after a reset. If "reinit" is - * non-zero, this reset occured after initial configuration + * non-zero, this reset occurred after initial configuration * and the caller requests that the chip be fully reinitialized * to a runable state. Chip interrupts are *not* enabled after * a reinitialization. The caller must enable interrupts via @@ -6495,7 +6495,7 @@ ahd_init_scbdata(struct ahd_softc *ahd) } /* - * Note that we were successfull + * Note that we were successful */ return (0); @@ -7079,7 +7079,7 @@ ahd_init(struct ahd_softc *ahd) return (ENOMEM); /* - * Verify that the compiler hasn't over-agressively + * Verify that the compiler hasn't over-aggressively * padded important structures. */ if (sizeof(struct hardware_scb) != 64) @@ -10087,7 +10087,7 @@ ahd_write_seeprom(struct ahd_softc *ahd, uint16_t *buf, return (error); /* - * Write the data. If we don't get throught the loop at + * Write the data. If we don't get through the loop at * least once, the arguments were invalid. */ retval = EINVAL; |