1 files changed, 11 insertions, 11 deletions
diff --git a/Documentation/devicetree/bindings/pci/samsung,exynos5440-pcie.txt b/Documentation/devicetree/bindings/pci/samsung,exynos5440-pcie.txt
index 7d3b09474657..34a11bfbfb60 100644
--- a/Documentation/devicetree/bindings/pci/samsung,exynos5440-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/samsung,exynos5440-pcie.txt
@@ -1,29 +1,29 @@
 * Samsung Exynos 5440 PCIe interface
 
-This PCIe host controller is based on the Synopsis Designware PCIe IP
+This PCIe host controller is based on the Synopsys DesignWare PCIe IP
 and thus inherits all the common properties defined in designware-pcie.txt.
 
 Required properties:
 - compatible: "samsung,exynos5440-pcie"
-- reg: base addresses and lengths of the pcie controller,
-	the phy controller, additional register for the phy controller.
-	(Registers for the phy controller are DEPRECATED.
+- reg: base addresses and lengths of the PCIe controller,
+	the PHY controller, additional register for the PHY controller.
+	(Registers for the PHY controller are DEPRECATED.
 	 Use the PHY framework.)
 - reg-names : First name should be set to "elbi".
-	And use the "config" instead of getting the confgiruation address space
+	And use the "config" instead of getting the configuration address space
 	from "ranges".
-	NOTE: When use the "config" property, reg-names must be set.
+	NOTE: When using the "config" property, reg-names must be set.
 - interrupts: A list of interrupt outputs for level interrupt,
 	pulse interrupt, special interrupt.
-- phys: From PHY binding. Phandle for the Generic PHY.
+- phys: From PHY binding. Phandle for the generic PHY.
 	Refer to Documentation/devicetree/bindings/phy/samsung-phy.txt
 
-Other common properties refer to
-	Documentation/devicetree/binding/pci/designware-pcie.txt
+For other common properties, refer to
+	Documentation/devicetree/bindings/pci/designware-pcie.txt
 
 Example:
 
-SoC specific DT Entry:
+SoC-specific DT Entry:
 
 	pcie@290000 {
 		compatible = "samsung,exynos5440-pcie", "snps,dw-pcie";
@@ -83,7 +83,7 @@ With using PHY framework:
 		...
 	};
 
-Board specific DT Entry:
+Board-specific DT Entry:
 
 	pcie@290000 {
 		reset-gpio = <&pin_ctrl 5 0>;