diff options
| -rw-r--r-- | arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts | 38 |
1 files changed, 38 insertions, 0 deletions
diff --git a/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts b/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts index 461683c6d1fb..15c22b06fc4b 100644 --- a/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts +++ b/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts @@ -96,6 +96,8 @@ wifi_pwrseq: wifi_pwrseq { compatible = "mmc-pwrseq-simple"; reset-gpios = <&pio 6 10 GPIO_ACTIVE_LOW>; /* PG10 WIFI_EN */ + clocks = <&ccu CLK_OUTA>; + clock-names = "ext_clock"; }; }; @@ -172,6 +174,8 @@ }; &pio { + pinctrl-names = "default"; + pinctrl-0 = <&clk_out_a_pin>; vcc-pa-supply = <®_aldo2>; vcc-pc-supply = <®_dcdc1>; vcc-pd-supply = <®_dcdc1>; @@ -233,12 +237,27 @@ regulator-name = "vcc-wifi-io"; }; +/* + * Our WiFi chip needs both DLDO2 and DLDO3 to be powered at the same + * time, with the two being in sync, to be able to meet maximum power + * consumption during transmits. Since this is not really supported + * right now, just use the two as always on, and we will fix it later. + */ + ®_dldo2 { + regulator-always-on; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; regulator-name = "vcc-wifi"; }; +®_dldo3 { + regulator-always-on; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + regulator-name = "vcc-wifi-2"; +}; + ®_dldo4 { regulator-min-microvolt = <2500000>; regulator-max-microvolt = <2500000>; @@ -261,6 +280,25 @@ status = "okay"; }; +&uart3 { + pinctrl-names = "default"; + pinctrl-0 = <&uart3_pg_pins>, <&uart3_rts_cts_pg_pins>; + uart-has-rtscts; + status = "okay"; + + bluetooth { + compatible = "brcm,bcm43438-bt"; + clocks = <&ccu CLK_OUTA>; + clock-names = "lpo"; + vbat-supply = <®_dldo2>; + vddio-supply = <®_dldo1>; + device-wakeup-gpios = <&pio 6 11 GPIO_ACTIVE_HIGH>; /* PG11 */ + /* TODO host wake line connected to PMIC GPIO pins */ + shutdown-gpios = <&pio 7 12 GPIO_ACTIVE_HIGH>; /* PH12 */ + max-speed = <1500000>; + }; +}; + &usbphy { usb1_vbus-supply = <®_vcc5v0>; status = "okay"; |