starfive-tech/u-boot.git/drivers/pinctrl, branch rtthread_AMP

pinctrl: starfive: Set up usb overcurrent signal

2023-11-29T02:54:31+00:00

For devkit HW design, there is not GPIO specific for the usb controller overcurrent signal. Config the sys iomux register to hardwire this signal, so that the usb controller can work normally. Signed-off-by: Mason Huo

pinctrl: starfive: jh7110: Added suppport for pinctrl in SPL

2023-11-29T02:54:26+00:00

Added support for pinctrl driver in SPL. Signed-off-by: Yanhong Wang

board: starfive: copyright: Standardize the copyright format

2023-04-23T03:19:47+00:00

Unify the content format of the copyright section Signed-off-by: Yanhong Wang

pinctrl: starfive: Add .get_function ops for the gpio driver

2023-03-28T09:44:50+00:00

Support getting direction of gpio. Signed-off-by: Hal Feng

pinctrl: starfive: Fix the crash problem when using gpio cmd

2023-03-28T09:44:17+00:00

starfive_pinctrl_priv struct is a priv of the parent device (pinctrl device), not the gpio device. Signed-off-by: Hal Feng

pinctrl: starfive: Add StarFive JH7110 driver

2022-11-21T03:44:55+00:00

Add pinctrl driver for StarFive JH7110 SoC. Signed-off-by: Kuan Lim Lee Signed-off-by: Emil Renner Berthing Signed-off-by: Jianlong Huang

pinctrl: fix typo

2021-09-14T13:07:18+00:00

fix typo in pinctrl Kconfig file to avoid git commit failure on some commit hooks check. Signed-off-by: Yuan Fang

pinctrl: Add pinctrl driver for imx8ulp

2021-08-09T12:46:51+00:00

Add pinctrl driver for i.MX8ULP Signed-off-by: Ye Li Signed-off-by: Peng Fan

global: Convert simple_strtoul() with decimal to dectoul()

2021-08-02T17:32:14+00:00

It is a pain to have to specify the value 10 in each call. Add a new dectoul() function and update the code to use it. Signed-off-by: Simon Glass

arm64: a37xx: pinctrl: Correct PWM pins definitions

2021-07-31T07:59:58+00:00

The PWM pins on North Bridge on Armada 37xx can be configured into PWM or GPIO functions. When in PWM function, each pin can also be configured to drive low on 0 and tri-state on 1 (LED mode). The current definitions handle this by declaring two pin groups for each pin: - group "pwmN" with functions "pwm" and "gpio" - group "ledN_od" ("od" for open drain) with functions "led" and "gpio" This is semantically incorrect. The correct definition for each pin should be one group with three functions: "pwm", "led" and "gpio". Change the "pwmN" groups to support "led" function. Remove "ledN_od" groups. This cannot break backwards compatibility with older device trees: no device tree uses it since there is no PWM driver for this SOC yet. Also "ledN_od" groups are not even documented. Signed-off-by: Marek Behún Reviewed-by: Stefan Roese