starfive-tech/u-boot.git/drivers/gpio/Kconfig, branch rtthread_AMP

GPIO:Starfive-jh7110: Add GPIO driver for JH7110

2022-10-18T08:24:33+00:00

Support for GPIO controller on starfive JH7110 SoCs. Signed-off-by: yanhong.wang

pci: Drop DM_PCI

2021-09-13T22:23:13+00:00

This option has not effect now. Drop it, using PCI instead where needed. Signed-off-by: Simon Glass

gpio: mcp230xx: Introduce new driver

2021-08-22T08:53:14+00:00

Introduce driver for I2C based MCP230xx GPIO chips, which are quite common and already well supported by the Linux kernel. Reviewed-by: Simon Glass Signed-off-by: Sebastian Reichel Reviewed-by: Simon Glass

Rename GPIO_SUPPORT to GPIO

2021-07-28T18:29:36+00:00

Rename these options so that CONFIG_IS_ENABLED can be used with them. Signed-off-by: Simon Glass

gpio: Add driver for Nomadik GPIO

2021-07-14T20:47:56+00:00

Nomadik GPIO is a fairly simple GPIO module used in the ST-Ericsson Ux500 SoCs (and some older Nomadik SoCs). It uses registers where each GPIO is represented as a single bit, plus "set" and "clear" registers that allow updating the state without having to read the existing state. The driver implements support for it for use together with DM_GPIO and the existing ste-dbx5x0.dtsi device tree. Cc: Linus Walleij Signed-off-by: Stephan Gerhold Reviewed-by: Linus Walleij

gpio: pca953x: Add missing i2c dependency

2021-06-23T07:48:35+00:00

pca953x also depends on i2c that's why add dependency to Kconfig. Where GPIO is enabled but I2C compilation error pops up. Signed-off-by: Michal Simek Reviewed-by: Heiko Schocher

gpio: Add support for DM GPIO for Kirkwood

2021-01-27T06:25:39+00:00

The Armada driver also works on Nedap's custom Kirkwood board with a Marvell 88F6180 CPU. The original commit of that driver, commit 704d9a645e17 ("gpio: Add DM GPIO driver for Marvell MVEBU"), also mentions that this driver would be suitable for Kirkwood. This does not completely replace the Kirkwood specific driver as there are still boards depending on that driver. Signed-off-by: Harm Berntsen CC: Stefan Roese , Reviewed-by: Stefan Roese

gpio: add GPIO controller driver for MediaTek MT7620 SoC

2021-01-24T20:39:26+00:00

This patch adds GPIO controller driver for MediaTek MT7620 SoC Reviewed-by: Stefan Roese Reviewed-by: Simon Glass Signed-off-by: Weijie Gao

xilinx: kconfig: Change Kconfig dependencies for Xilinx drivers

2020-08-20T07:46:55+00:00

Zynq/ZynqMP/Versal IPs should be possible to called also from Microblaze in PL and vice versa. That's why change dependencies and do not limit enabling just for some platforms. Signed-off-by: Michal Simek Reviewed-by: Heiko Schocher

gpio: octeon_gpio: Add GPIO controller driver for Octeon

2020-08-03T19:11:41+00:00

Add support for GPIO controllers found on Octeon II/III and Octeon TX TX2 SoC platforms. Signed-off-by: Aaron Williams Signed-off-by: Suneel Garapati Signed-off-by: Stefan Roese Reviewed-by: Simon Glass Reviewed-by: Daniel Schwierzeck