From bd529cfb40c427d5b5aae0d315afb9f0a1da5e76 Mon Sep 17 00:00:00 2001 From: Evgeniy Polyakov Date: Tue, 6 Dec 2005 13:38:28 +0300 Subject: [PATCH] W1: Move w1 bus master code into 'w1/masters' and move w1 slave code into 'w1/slaves' Signed-off-by: Ben Gardner Signed-off-by: Evgeniy Polyakov Signed-off-by: Greg Kroah-Hartman --- drivers/w1/Kconfig | 60 ++---------------------------------------------------- 1 file changed, 2 insertions(+), 58 deletions(-) (limited to 'drivers/w1/Kconfig') diff --git a/drivers/w1/Kconfig b/drivers/w1/Kconfig index 4baf61a22327..5e61ed59a41e 100644 --- a/drivers/w1/Kconfig +++ b/drivers/w1/Kconfig @@ -11,63 +11,7 @@ config W1 This W1 support can also be built as a module. If so, the module will be called wire.ko. -config W1_MATROX - tristate "Matrox G400 transport layer for 1-wire" - depends on W1 && PCI - help - Say Y here if you want to communicate with your 1-wire devices - using Matrox's G400 GPIO pins. - - This support is also available as a module. If so, the module - will be called matrox_w1.ko. - -config W1_DS9490 - tristate "DS9490R transport layer driver" - depends on W1 && USB - help - Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge. - - This support is also available as a module. If so, the module - will be called ds9490r.ko. - -config W1_DS9490_BRIDGE - tristate "DS9490R USB <-> W1 transport layer for 1-wire" - depends on W1_DS9490 - help - Say Y here if you want to communicate with your 1-wire devices - using DS9490R USB bridge. - - This support is also available as a module. If so, the module - will be called ds_w1_bridge.ko. - -config W1_THERM - tristate "Thermal family implementation" - depends on W1 - help - Say Y here if you want to connect 1-wire thermal sensors to you - wire. - -config W1_SMEM - tristate "Simple 64bit memory family implementation" - depends on W1 - help - Say Y here if you want to connect 1-wire - simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire. - -config W1_DS2433 - tristate "4kb EEPROM family support (DS2433)" - depends on W1 - help - Say Y here if you want to use a 1-wire - 4kb EEPROM family device (DS2433). - -config W1_DS2433_CRC - bool "Protect DS2433 data with a CRC16" - depends on W1_DS2433 - select CRC16 - help - Say Y here to protect DS2433 data with a CRC16. - Each block has 30 bytes of data and a two byte CRC16. - Full block writes are only allowed if the CRC is valid. +source drivers/w1/masters/Kconfig +source drivers/w1/slaves/Kconfig endmenu -- cgit v1.2.3