diff options
Diffstat (limited to 'include/linux/spi')
| -rw-r--r-- | include/linux/spi/spi.h | 8 |
1 files changed, 4 insertions, 4 deletions
diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h index 36c86ef51ff3..e713543336f1 100644 --- a/include/linux/spi/spi.h +++ b/include/linux/spi/spi.h @@ -237,7 +237,7 @@ static inline void spi_unregister_driver(struct spi_driver *sdrv) * @mode_bits: flags understood by this controller driver * @bits_per_word_mask: A mask indicating which values of bits_per_word are * supported by the driver. Bit n indicates that a bits_per_word n+1 is - * suported. If set, the SPI core will reject any transfer with an + * supported. If set, the SPI core will reject any transfer with an * unsupported bits_per_word. If not set, this value is simply ignored, * and it's up to the individual driver to perform any validation. * @min_speed_hz: Lowest supported transfer speed @@ -262,7 +262,7 @@ static inline void spi_unregister_driver(struct spi_driver *sdrv) * @cur_msg: the currently in-flight message * @cur_msg_prepared: spi_prepare_message was called for the currently * in-flight message - * @xfer_completion: used by core tranfer_one_message() + * @xfer_completion: used by core transfer_one_message() * @busy: message pump is busy * @running: message pump is running * @rt: whether this queue is set to run as a realtime task @@ -525,7 +525,7 @@ extern struct spi_master *spi_busnum_to_master(u16 busnum); * @rx_buf: data to be read (dma-safe memory), or NULL * @tx_dma: DMA address of tx_buf, if @spi_message.is_dma_mapped * @rx_dma: DMA address of rx_buf, if @spi_message.is_dma_mapped - * @tx_nbits: number of bits used for writting. If 0 the default + * @tx_nbits: number of bits used for writing. If 0 the default * (SPI_NBITS_SINGLE) is used. * @rx_nbits: number of bits used for reading. If 0 the default * (SPI_NBITS_SINGLE) is used. @@ -585,7 +585,7 @@ extern struct spi_master *spi_busnum_to_master(u16 busnum); * by the results of previous messages and where the whole transaction * ends when the chipselect goes intactive. * - * When SPI can transfer in 1x,2x or 4x. It can get this tranfer information + * When SPI can transfer in 1x,2x or 4x. It can get this transfer information * from device through @tx_nbits and @rx_nbits. In Bi-direction, these * two should both be set. User can set transfer mode with SPI_NBITS_SINGLE(1x) * SPI_NBITS_DUAL(2x) and SPI_NBITS_QUAD(4x) to support these three transfer. |