diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-shared.h')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-shared.h | 32 |
1 files changed, 3 insertions, 29 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-shared.h b/drivers/net/wireless/iwlwifi/iwl-shared.h index b515d657a0ad..983b41e43d4b 100644 --- a/drivers/net/wireless/iwlwifi/iwl-shared.h +++ b/drivers/net/wireless/iwlwifi/iwl-shared.h @@ -160,7 +160,6 @@ struct iwl_mod_params { * * Holds the module parameters * - * @num_ampdu_queues: num of ampdu queues * @tx_chains_num: Number of TX chains * @rx_chains_num: Number of RX chains * @valid_tx_ant: usable antennas for TX @@ -176,7 +175,6 @@ struct iwl_mod_params { * @use_rts_for_aggregation: use rts/cts protection for HT traffic */ struct iwl_hw_params { - u8 num_ampdu_queues; u8 tx_chains_num; u8 rx_chains_num; u8 valid_tx_ant; @@ -217,7 +215,6 @@ enum iwl_led_mode { * @chain_noise_num_beacons: number of beacons used to compute chain noise * @adv_thermal_throttle: support advance thermal throttle * @support_ct_kill_exit: support ct kill exit condition - * @support_wimax_coexist: support wimax/wifi co-exist * @plcp_delta_threshold: plcp error rate threshold used to trigger * radio tuning when there is a high receiving plcp error rate * @chain_noise_scale: default chain noise scale used for gain computation @@ -231,7 +228,6 @@ enum iwl_led_mode { struct iwl_base_params { int eeprom_size; int num_of_queues; /* def: HW dependent */ - int num_of_ampdu_queues;/* def: HW dependent */ /* for iwl_apm_init() */ u32 pll_cfg_val; @@ -240,7 +236,6 @@ struct iwl_base_params { u16 led_compensation; bool adv_thermal_throttle; bool support_ct_kill_exit; - const bool support_wimax_coexist; u8 plcp_delta_threshold; s32 chain_noise_scale; unsigned int wd_timeout; @@ -299,21 +294,15 @@ struct iwl_ht_params { * @need_temp_offset_calib: need to perform temperature offset calibration * @no_xtal_calib: some devices do not need crystal calibration data, * don't send it to those - * @scan_rx_antennas: available antenna for scan operation * @led_mode: 0=blinking, 1=On(RF On)/Off(RF Off) * @adv_pm: advance power management * @rx_with_siso_diversity: 1x1 device with rx antenna diversity * @internal_wimax_coex: internal wifi/wimax combo device - * @iq_invert: I/Q inversion * @temp_offset_v2: support v2 of temperature offset calibration * - * We enable the driver to be backward compatible wrt API version. The - * driver specifies which APIs it supports (with @ucode_api_max being the - * highest and @ucode_api_min the lowest). Firmware will only be loaded if - * it has a supported API version. - * - * The ideal usage of this infrastructure is to treat a new ucode API - * release as a new hardware revision. + * We enable the driver to be backward compatible wrt. hardware features. + * API differences in uCode shouldn't be handled here but through TLVs + * and/or the uCode API version instead. */ struct iwl_cfg { /* params specific to an individual device within a device family */ @@ -337,12 +326,10 @@ struct iwl_cfg { const struct iwl_bt_params *bt_params; const bool need_temp_offset_calib; /* if used set to true */ const bool no_xtal_calib; - u8 scan_rx_antennas[IEEE80211_NUM_BANDS]; enum iwl_led_mode led_mode; const bool adv_pm; const bool rx_with_siso_diversity; const bool internal_wimax_coex; - const bool iq_invert; const bool temp_offset_v2; }; @@ -351,7 +338,6 @@ struct iwl_cfg { * * @status: STATUS_* * @wowlan: are we running wowlan uCode - * @valid_contexts: microcode/device supports multiple contexts * @bus: pointer to the bus layer data * @cfg: see struct iwl_cfg * @priv: pointer to the upper layer data @@ -360,30 +346,18 @@ struct iwl_cfg { * @hw_params: see struct iwl_hw_params * @lock: protect general shared data * @eeprom: pointer to the eeprom/OTP image - * @ucode_type: indicator of loaded ucode image - * @device_pointers: pointers to ucode event tables */ struct iwl_shared { unsigned long status; - u8 valid_contexts; const struct iwl_cfg *cfg; struct iwl_trans *trans; void *drv; struct iwl_hw_params hw_params; - const struct iwl_fw *fw; /* eeprom -- this is in the card's little endian byte order */ u8 *eeprom; - /* ucode related variables */ - enum iwl_ucode_type ucode_type; - - struct { - u32 error_event_table; - u32 log_event_table; - } device_pointers; - }; /*Whatever _m is (iwl_trans, iwl_priv, these macros will work */ |