diff options
Diffstat (limited to 'drivers/net/ethernet/qualcomm')
| -rw-r--r-- | drivers/net/ethernet/qualcomm/emac/emac-mac.c | 23 | ||||
| -rw-r--r-- | drivers/net/ethernet/qualcomm/emac/emac-sgmii.c | 2 | ||||
| -rw-r--r-- | drivers/net/ethernet/qualcomm/emac/emac.c | 1 |
3 files changed, 19 insertions, 7 deletions
diff --git a/drivers/net/ethernet/qualcomm/emac/emac-mac.c b/drivers/net/ethernet/qualcomm/emac/emac-mac.c index e97968ed4b8f..0b4deb31e742 100644 --- a/drivers/net/ethernet/qualcomm/emac/emac-mac.c +++ b/drivers/net/ethernet/qualcomm/emac/emac-mac.c @@ -575,10 +575,11 @@ void emac_mac_start(struct emac_adapter *adpt) mac |= TXEN | RXEN; /* enable RX/TX */ - /* We don't have ethtool support yet, so force flow-control mode - * to 'full' always. - */ - mac |= TXFC | RXFC; + /* Configure MAC flow control to match the PHY's settings. */ + if (phydev->pause) + mac |= RXFC; + if (phydev->pause != phydev->asym_pause) + mac |= TXFC; /* setup link speed */ mac &= ~SPEED_MASK; @@ -1003,6 +1004,12 @@ int emac_mac_up(struct emac_adapter *adpt) writel((u32)~DIS_INT, adpt->base + EMAC_INT_STATUS); writel(adpt->irq.mask, adpt->base + EMAC_INT_MASK); + /* Enable pause frames. Without this feature, the EMAC has been shown + * to receive (and drop) frames with FCS errors at gigabit connections. + */ + adpt->phydev->supported |= SUPPORTED_Pause | SUPPORTED_Asym_Pause; + adpt->phydev->advertising |= SUPPORTED_Pause | SUPPORTED_Asym_Pause; + adpt->phydev->irq = PHY_IGNORE_INTERRUPT; phy_start(adpt->phydev); @@ -1021,14 +1028,18 @@ void emac_mac_down(struct emac_adapter *adpt) napi_disable(&adpt->rx_q.napi); phy_stop(adpt->phydev); - phy_disconnect(adpt->phydev); - /* disable mac irq */ + /* Interrupts must be disabled before the PHY is disconnected, to + * avoid a race condition where adjust_link is null when we get + * an interrupt. + */ writel(DIS_INT, adpt->base + EMAC_INT_STATUS); writel(0, adpt->base + EMAC_INT_MASK); synchronize_irq(adpt->irq.irq); free_irq(adpt->irq.irq, &adpt->irq); + phy_disconnect(adpt->phydev); + emac_mac_reset(adpt); emac_tx_q_descs_free(adpt); diff --git a/drivers/net/ethernet/qualcomm/emac/emac-sgmii.c b/drivers/net/ethernet/qualcomm/emac/emac-sgmii.c index 75c1b530e39e..72fe343c7a36 100644 --- a/drivers/net/ethernet/qualcomm/emac/emac-sgmii.c +++ b/drivers/net/ethernet/qualcomm/emac/emac-sgmii.c @@ -421,7 +421,7 @@ static const struct emac_reg_write sgmii_v2_laned[] = { /* CDR Settings */ {EMAC_SGMII_LN_UCDR_FO_GAIN_MODE0, UCDR_STEP_BY_TWO_MODE0 | UCDR_xO_GAIN_MODE(10)}, - {EMAC_SGMII_LN_UCDR_SO_GAIN_MODE0, UCDR_xO_GAIN_MODE(6)}, + {EMAC_SGMII_LN_UCDR_SO_GAIN_MODE0, UCDR_xO_GAIN_MODE(0)}, {EMAC_SGMII_LN_UCDR_SO_CONFIG, UCDR_ENABLE | UCDR_SO_SATURATION(12)}, /* TX/RX Settings */ diff --git a/drivers/net/ethernet/qualcomm/emac/emac.c b/drivers/net/ethernet/qualcomm/emac/emac.c index 9bf3b2b82e95..4fede4b86538 100644 --- a/drivers/net/ethernet/qualcomm/emac/emac.c +++ b/drivers/net/ethernet/qualcomm/emac/emac.c @@ -575,6 +575,7 @@ static const struct of_device_id emac_dt_match[] = { }, {} }; +MODULE_DEVICE_TABLE(of, emac_dt_match); #if IS_ENABLED(CONFIG_ACPI) static const struct acpi_device_id emac_acpi_match[] = { |