diff options
Diffstat (limited to 'drivers/net/ethernet/cadence/macb.c')
| -rw-r--r-- | drivers/net/ethernet/cadence/macb.c | 18 |
1 files changed, 18 insertions, 0 deletions
diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c index 61aa570aad9a..fc646a41d548 100644 --- a/drivers/net/ethernet/cadence/macb.c +++ b/drivers/net/ethernet/cadence/macb.c @@ -350,6 +350,9 @@ static int macb_mii_probe(struct net_device *dev) else phydev->supported &= PHY_BASIC_FEATURES; + if (bp->caps & MACB_CAPS_NO_GIGABIT_HALF) + phydev->supported &= ~SUPPORTED_1000baseT_Half; + phydev->advertising = phydev->supported; bp->link = 0; @@ -1037,6 +1040,12 @@ static irqreturn_t macb_interrupt(int irq, void *dev_id) * add that if/when we get our hands on a full-blown MII PHY. */ + /* There is a hardware issue under heavy load where DMA can + * stop, this causes endless "used buffer descriptor read" + * interrupts but it can be cleared by re-enabling RX. See + * the at91 manual, section 41.3.1 or the Zynq manual + * section 16.7.4 for details. + */ if (status & MACB_BIT(RXUBR)) { ctrl = macb_readl(bp, NCR); macb_writel(bp, NCR, ctrl & ~MACB_BIT(RE)); @@ -2693,6 +2702,14 @@ static const struct macb_config emac_config = { .init = at91ether_init, }; +static const struct macb_config zynq_config = { + .caps = MACB_CAPS_SG_DISABLED | MACB_CAPS_GIGABIT_MODE_AVAILABLE | + MACB_CAPS_NO_GIGABIT_HALF, + .dma_burst_length = 16, + .clk_init = macb_clk_init, + .init = macb_init, +}; + static const struct of_device_id macb_dt_ids[] = { { .compatible = "cdns,at32ap7000-macb" }, { .compatible = "cdns,at91sam9260-macb", .data = &at91sam9260_config }, @@ -2703,6 +2720,7 @@ static const struct of_device_id macb_dt_ids[] = { { .compatible = "atmel,sama5d4-gem", .data = &sama5d4_config }, { .compatible = "cdns,at91rm9200-emac", .data = &emac_config }, { .compatible = "cdns,emac", .data = &emac_config }, + { .compatible = "cdns,zynq-gem", .data = &zynq_config }, { /* sentinel */ } }; MODULE_DEVICE_TABLE(of, macb_dt_ids); |