diff options
Diffstat (limited to 'drivers/mmc/host/tmio_mmc_pio.c')
-rw-r--r-- | drivers/mmc/host/tmio_mmc_pio.c | 132 |
1 files changed, 96 insertions, 36 deletions
diff --git a/drivers/mmc/host/tmio_mmc_pio.c b/drivers/mmc/host/tmio_mmc_pio.c index 9a7996ade58e..0d8a9bbe30be 100644 --- a/drivers/mmc/host/tmio_mmc_pio.c +++ b/drivers/mmc/host/tmio_mmc_pio.c @@ -34,8 +34,9 @@ #include <linux/io.h> #include <linux/irq.h> #include <linux/mfd/tmio.h> -#include <linux/mmc/cd-gpio.h> #include <linux/mmc/host.h> +#include <linux/mmc/mmc.h> +#include <linux/mmc/slot-gpio.h> #include <linux/mmc/tmio.h> #include <linux/module.h> #include <linux/pagemap.h> @@ -305,8 +306,8 @@ static int tmio_mmc_start_command(struct tmio_mmc_host *host, struct mmc_command int c = cmd->opcode; u32 irq_mask = TMIO_MASK_CMD; - /* Command 12 is handled by hardware */ - if (cmd->opcode == 12 && !cmd->arg) { + /* CMD12 is handled by hardware */ + if (cmd->opcode == MMC_STOP_TRANSMISSION && !cmd->arg) { sd_ctrl_write16(host, CTL_STOP_INTERNAL_ACTION, 0x001); return 0; } @@ -449,7 +450,7 @@ void tmio_mmc_do_data_irq(struct tmio_mmc_host *host) } if (stop) { - if (stop->opcode == 12 && !stop->arg) + if (stop->opcode == MMC_STOP_TRANSMISSION && !stop->arg) sd_ctrl_write16(host, CTL_STOP_INTERNAL_ACTION, 0x000); else BUG(); @@ -751,6 +752,34 @@ fail: mmc_request_done(mmc, mrq); } +static int tmio_mmc_clk_update(struct mmc_host *mmc) +{ + struct tmio_mmc_host *host = mmc_priv(mmc); + struct tmio_mmc_data *pdata = host->pdata; + int ret; + + if (!pdata->clk_enable) + return -ENOTSUPP; + + ret = pdata->clk_enable(host->pdev, &mmc->f_max); + if (!ret) + mmc->f_min = mmc->f_max / 512; + + return ret; +} + +static void tmio_mmc_set_power(struct tmio_mmc_host *host, struct mmc_ios *ios) +{ + struct mmc_host *mmc = host->mmc; + + if (host->set_pwr) + host->set_pwr(host->pdev, ios->power_mode != MMC_POWER_OFF); + if (!IS_ERR(mmc->supply.vmmc)) + /* Errors ignored... */ + mmc_regulator_set_ocr(mmc, mmc->supply.vmmc, + ios->power_mode ? ios->vdd : 0); +} + /* Set MMC clock / power. * Note: This controller uses a simple divider scheme therefore it cannot * run a MMC card at full speed (20MHz). The max clock is 24MHz on SD, but as @@ -797,32 +826,37 @@ static void tmio_mmc_set_ios(struct mmc_host *mmc, struct mmc_ios *ios) */ if (ios->power_mode == MMC_POWER_ON && ios->clock) { if (!host->power) { + tmio_mmc_clk_update(mmc); pm_runtime_get_sync(dev); host->power = true; } tmio_mmc_set_clock(host, ios->clock); /* power up SD bus */ - if (host->set_pwr) - host->set_pwr(host->pdev, 1); + tmio_mmc_set_power(host, ios); /* start bus clock */ tmio_mmc_clk_start(host); } else if (ios->power_mode != MMC_POWER_UP) { - if (host->set_pwr && ios->power_mode == MMC_POWER_OFF) - host->set_pwr(host->pdev, 0); + if (ios->power_mode == MMC_POWER_OFF) + tmio_mmc_set_power(host, ios); if (host->power) { + struct tmio_mmc_data *pdata = host->pdata; + tmio_mmc_clk_stop(host); host->power = false; pm_runtime_put(dev); + if (pdata->clk_disable) + pdata->clk_disable(host->pdev); } - tmio_mmc_clk_stop(host); } - switch (ios->bus_width) { - case MMC_BUS_WIDTH_1: - sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, 0x80e0); - break; - case MMC_BUS_WIDTH_4: - sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, 0x00e0); - break; + if (host->power) { + switch (ios->bus_width) { + case MMC_BUS_WIDTH_1: + sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, 0x80e0); + break; + case MMC_BUS_WIDTH_4: + sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, 0x00e0); + break; + } } /* Let things settle. delay taken from winCE driver */ @@ -841,6 +875,9 @@ static int tmio_mmc_get_ro(struct mmc_host *mmc) { struct tmio_mmc_host *host = mmc_priv(mmc); struct tmio_mmc_data *pdata = host->pdata; + int ret = mmc_gpio_get_ro(mmc); + if (ret >= 0) + return ret; return !((pdata->flags & TMIO_MMC_WRPROTECT_DISABLE) || (sd_ctrl_read32(host, CTL_STATUS) & TMIO_STAT_WRPROTECT)); @@ -850,6 +887,9 @@ static int tmio_mmc_get_cd(struct mmc_host *mmc) { struct tmio_mmc_host *host = mmc_priv(mmc); struct tmio_mmc_data *pdata = host->pdata; + int ret = mmc_gpio_get_cd(mmc); + if (ret >= 0) + return ret; if (!pdata->get_cd) return -ENOSYS; @@ -865,6 +905,19 @@ static const struct mmc_host_ops tmio_mmc_ops = { .enable_sdio_irq = tmio_mmc_enable_sdio_irq, }; +static void tmio_mmc_init_ocr(struct tmio_mmc_host *host) +{ + struct tmio_mmc_data *pdata = host->pdata; + struct mmc_host *mmc = host->mmc; + + mmc_regulator_get_supply(mmc); + + if (!mmc->ocr_avail) + mmc->ocr_avail = pdata->ocr_mask ? : MMC_VDD_32_33 | MMC_VDD_33_34; + else if (pdata->ocr_mask) + dev_warn(mmc_dev(mmc), "Platform OCR mask is ignored\n"); +} + int __devinit tmio_mmc_host_probe(struct tmio_mmc_host **host, struct platform_device *pdev, struct tmio_mmc_data *pdata) @@ -904,18 +957,14 @@ int __devinit tmio_mmc_host_probe(struct tmio_mmc_host **host, mmc->ops = &tmio_mmc_ops; mmc->caps = MMC_CAP_4_BIT_DATA | pdata->capabilities; - mmc->f_max = pdata->hclk; - mmc->f_min = mmc->f_max / 512; + mmc->caps2 = pdata->capabilities2; mmc->max_segs = 32; mmc->max_blk_size = 512; mmc->max_blk_count = (PAGE_CACHE_SIZE / mmc->max_blk_size) * mmc->max_segs; mmc->max_req_size = mmc->max_blk_size * mmc->max_blk_count; mmc->max_seg_size = mmc->max_req_size; - if (pdata->ocr_mask) - mmc->ocr_avail = pdata->ocr_mask; - else - mmc->ocr_avail = MMC_VDD_32_33 | MMC_VDD_33_34; + tmio_mmc_init_ocr(_host); _host->native_hotplug = !(pdata->flags & TMIO_MMC_USE_GPIO_CD || mmc->caps & MMC_CAP_NEEDS_POLL || @@ -927,6 +976,11 @@ int __devinit tmio_mmc_host_probe(struct tmio_mmc_host **host, if (ret < 0) goto pm_disable; + if (tmio_mmc_clk_update(mmc) < 0) { + mmc->f_max = pdata->hclk; + mmc->f_min = mmc->f_max / 512; + } + /* * There are 4 different scenarios for the card detection: * 1) an external gpio irq handles the cd (best for power savings) @@ -937,7 +991,6 @@ int __devinit tmio_mmc_host_probe(struct tmio_mmc_host **host, * While we increment the runtime PM counter for all scenarios when * the mmc core activates us by calling an appropriate set_ios(), we * must additionally ensure that in case 2) the tmio mmc hardware stays - * additionally ensure that in case 2) the tmio mmc hardware stays * powered on during runtime for the card detection to work. */ if (_host->native_hotplug) @@ -948,6 +1001,17 @@ int __devinit tmio_mmc_host_probe(struct tmio_mmc_host **host, _host->sdcard_irq_mask = sd_ctrl_read32(_host, CTL_IRQ_MASK); tmio_mmc_disable_mmc_irqs(_host, TMIO_MASK_ALL); + + /* Unmask the IRQs we want to know about */ + if (!_host->chan_rx) + irq_mask |= TMIO_MASK_READOP; + if (!_host->chan_tx) + irq_mask |= TMIO_MASK_WRITEOP; + if (!_host->native_hotplug) + irq_mask &= ~(TMIO_STAT_CARD_REMOVE | TMIO_STAT_CARD_INSERT); + + _host->sdcard_irq_mask &= ~irq_mask; + if (pdata->flags & TMIO_MMC_SDIO_IRQ) tmio_mmc_enable_sdio_irq(mmc, 0); @@ -961,22 +1025,18 @@ int __devinit tmio_mmc_host_probe(struct tmio_mmc_host **host, /* See if we also get DMA */ tmio_mmc_request_dma(_host, pdata); - mmc_add_host(mmc); + ret = mmc_add_host(mmc); + if (pdata->clk_disable) + pdata->clk_disable(pdev); + if (ret < 0) { + tmio_mmc_host_remove(_host); + return ret; + } dev_pm_qos_expose_latency_limit(&pdev->dev, 100); - /* Unmask the IRQs we want to know about */ - if (!_host->chan_rx) - irq_mask |= TMIO_MASK_READOP; - if (!_host->chan_tx) - irq_mask |= TMIO_MASK_WRITEOP; - if (!_host->native_hotplug) - irq_mask &= ~(TMIO_STAT_CARD_REMOVE | TMIO_STAT_CARD_INSERT); - - tmio_mmc_enable_mmc_irqs(_host, irq_mask); - if (pdata->flags & TMIO_MMC_USE_GPIO_CD) { - ret = mmc_cd_gpio_request(mmc, pdata->cd_gpio); + ret = mmc_gpio_request_cd(mmc, pdata->cd_gpio); if (ret < 0) { tmio_mmc_host_remove(_host); return ret; @@ -1008,7 +1068,7 @@ void tmio_mmc_host_remove(struct tmio_mmc_host *host) * This means we can miss a card-eject, but this is anyway * possible, because of delayed processing of hotplug events. */ - mmc_cd_gpio_free(mmc); + mmc_gpio_free_cd(mmc); if (!host->native_hotplug) pm_runtime_get_sync(&pdev->dev); |