diff options
Diffstat (limited to 'Documentation/power/pci.rst')
| -rw-r--r-- | Documentation/power/pci.rst | 24 |
1 files changed, 12 insertions, 12 deletions
diff --git a/Documentation/power/pci.rst b/Documentation/power/pci.rst index 51e0a493d284..0924d29636ad 100644 --- a/Documentation/power/pci.rst +++ b/Documentation/power/pci.rst @@ -130,8 +130,8 @@ a full power-on reset sequence and the power-on defaults are restored to the device by hardware just as at initial power up. PCI devices supporting the PCI PM Spec can be programmed to generate PMEs -while in a low-power state (D1-D3), but they are not required to be capable -of generating PMEs from all supported low-power states. In particular, the +while in any power state (D0-D3), but they are not required to be capable +of generating PMEs from all supported power states. In particular, the capability of generating PMEs from D3cold is optional and depends on the presence of additional voltage (3.3Vaux) allowing the device to remain sufficiently active to generate a wakeup signal. @@ -600,17 +600,17 @@ using the following PCI bus type's callbacks:: respectively. -The first of them, pci_pm_thaw_noirq(), is analogous to pci_pm_resume_noirq(), -but it doesn't put the device into the full power state and doesn't attempt to -restore its standard configuration registers. It also executes the device -driver's pm->thaw_noirq() callback, if defined, instead of pm->resume_noirq(). +The first of them, pci_pm_thaw_noirq(), is analogous to pci_pm_resume_noirq(). +It puts the device into the full power state and restores its standard +configuration registers. It also executes the device driver's pm->thaw_noirq() +callback, if defined, instead of pm->resume_noirq(). The pci_pm_thaw() routine is similar to pci_pm_resume(), but it runs the device driver's pm->thaw() callback instead of pm->resume(). It is executed asynchronously for different PCI devices that don't depend on each other in a known way. -The complete phase it the same as for system resume. +The complete phase is the same as for system resume. After saving the image, devices need to be powered down before the system can enter the target sleep state (ACPI S4 for ACPI-based systems). This is done in @@ -692,11 +692,11 @@ controlling the runtime power management of their devices. At the time of this writing there are two ways to define power management callbacks for a PCI device driver, the recommended one, based on using a dev_pm_ops structure described in Documentation/driver-api/pm/devices.rst, and -the "legacy" one, in which the .suspend(), .suspend_late(), .resume_early(), and -.resume() callbacks from struct pci_driver are used. The legacy approach, -however, doesn't allow one to define runtime power management callbacks and is -not really suitable for any new drivers. Therefore it is not covered by this -document (refer to the source code to learn more about it). +the "legacy" one, in which the .suspend() and .resume() callbacks from struct +pci_driver are used. The legacy approach, however, doesn't allow one to define +runtime power management callbacks and is not really suitable for any new +drivers. Therefore it is not covered by this document (refer to the source code +to learn more about it). It is recommended that all PCI device drivers define a struct dev_pm_ops object containing pointers to power management (PM) callbacks that will be executed by |