diff options
Diffstat (limited to 'Documentation/devicetree/bindings/serial/fsl-imx-uart.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/serial/fsl-imx-uart.txt | 4 |
1 files changed, 4 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt index 35957cbf1571..c8d677f9491f 100644 --- a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt +++ b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt @@ -8,6 +8,10 @@ Required properties: Optional properties: - fsl,dte-mode : Indicate the uart works in DTE mode. The uart works in DCE mode by default. +- fsl,inverted-tx , fsl,inverted-rx : Indicate that the hardware attached + to the peripheral inverts the signal transmitted or received, + respectively, and that the peripheral should invert its output/input + using the INVT/INVR registers. - rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx, linux,rs485-enabled-at-boot-time: see rs485.txt. Note that for RS485 you must enable either the "uart-has-rtscts" or the "rts-gpios" |