diff options
Diffstat (limited to 'Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt')
-rw-r--r-- | Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt | 27 |
1 files changed, 26 insertions, 1 deletions
diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt index 3e23fece99da..eb39f5051159 100644 --- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt +++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt @@ -19,7 +19,7 @@ such as pull-up, multi drive, etc. Required properties for iomux controller: - compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl" - or "atmel,sama5d3-pinctrl" + or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pinctrl" - atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be configured in this periph mode. All the periph and bank need to be describe. @@ -100,6 +100,7 @@ DRIVE_STRENGTH (3 << 5): indicate the drive strength of the pin using the 11 - High OUTPUT (1 << 7): indicate this pin need to be configured as an output. OUTPUT_VAL (1 << 8): output val (1 = high, 0 = low) +SLEWRATE (1 << 9): slew rate of the pin: 0 = disable, 1 = enable DEBOUNCE (1 << 16): indicate this pin needs debounce. DEBOUNCE_VAL (0x3fff << 17): debounce value. @@ -116,6 +117,19 @@ Some requirements for using atmel,at91rm9200-pinctrl binding: configurations by referring to the phandle of that pin configuration node. 4. The gpio controller must be describe in the pinctrl simple-bus. +For each bank the required properties are: +- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or + "microchip,sam9x60-gpio" +- reg: physical base address and length of the controller's registers +- interrupts: interrupt outputs from the controller +- interrupt-controller: marks the device node as an interrupt controller +- #interrupt-cells: should be 2; refer to ../interrupt-controller/interrupts.txt + for more details. +- gpio-controller +- #gpio-cells: should be 2; the first cell is the GPIO number and the second + cell specifies GPIO flags as defined in <dt-bindings/gpio/gpio.h>. +- clocks: bank clock + Examples: pinctrl@fffff400 { @@ -125,6 +139,17 @@ pinctrl@fffff400 { compatible = "atmel,at91rm9200-pinctrl", "simple-bus"; reg = <0xfffff400 0x600>; + pioA: gpio@fffff400 { + compatible = "atmel,at91sam9x5-gpio"; + reg = <0xfffff400 0x200>; + interrupts = <2 IRQ_TYPE_LEVEL_HIGH 1>; + #gpio-cells = <2>; + gpio-controller; + interrupt-controller; + #interrupt-cells = <2>; + clocks = <&pmc PMC_TYPE_PERIPHERAL 2>; + }; + atmel,mux-mask = < /* A B */ 0xffffffff 0xffc00c3b /* pioA */ |