diff options
| -rw-r--r-- | drivers/usb/musb/tusb6010.c | 13 | ||||
| -rw-r--r-- | drivers/usb/musb/tusb6010_omap.c | 22 |
2 files changed, 27 insertions, 8 deletions
diff --git a/drivers/usb/musb/tusb6010.c b/drivers/usb/musb/tusb6010.c index ab776a8d98ca..60d3938cafcf 100644 --- a/drivers/usb/musb/tusb6010.c +++ b/drivers/usb/musb/tusb6010.c @@ -29,6 +29,19 @@ static void tusb_source_power(struct musb *musb, int is_on); #define TUSB_REV_MAJOR(reg_val) ((reg_val >> 4) & 0xf) #define TUSB_REV_MINOR(reg_val) (reg_val & 0xf) +#ifdef CONFIG_PM +/* REVISIT: These should be only needed if somebody implements off idle */ +void musb_platform_save_context(struct musb *musb, + struct musb_context_registers *musb_context) +{ +} + +void musb_platform_restore_context(struct musb *musb, + struct musb_context_registers *musb_context) +{ +} +#endif + /* * Checks the revision. We need to use the DMA register as 3.0 does not * have correct versions for TUSB_PRCM_REV or TUSB_INT_CTRL_REV. diff --git a/drivers/usb/musb/tusb6010_omap.c b/drivers/usb/musb/tusb6010_omap.c index 5afa070d7dc9..c061a88f2b0f 100644 --- a/drivers/usb/musb/tusb6010_omap.c +++ b/drivers/usb/musb/tusb6010_omap.c @@ -39,7 +39,7 @@ struct tusb_omap_dma_ch { struct tusb_omap_dma *tusb_dma; - void __iomem *dma_addr; + dma_addr_t dma_addr; u32 len; u16 packet_sz; @@ -126,6 +126,7 @@ static void tusb_omap_dma_cb(int lch, u16 ch_status, void *data) struct tusb_omap_dma_ch *chdat = to_chdat(channel); struct tusb_omap_dma *tusb_dma = chdat->tusb_dma; struct musb *musb = chdat->musb; + struct device *dev = musb->controller; struct musb_hw_ep *hw_ep = chdat->hw_ep; void __iomem *ep_conf = hw_ep->conf; void __iomem *mbase = musb->mregs; @@ -173,13 +174,15 @@ static void tusb_omap_dma_cb(int lch, u16 ch_status, void *data) DBG(3, "Using PIO for remaining %lu bytes\n", pio); buf = phys_to_virt((u32)chdat->dma_addr) + chdat->transfer_len; if (chdat->tx) { - dma_cache_maint(phys_to_virt((u32)chdat->dma_addr), - chdat->transfer_len, DMA_TO_DEVICE); + dma_unmap_single(dev, chdat->dma_addr, + chdat->transfer_len, + DMA_TO_DEVICE); musb_write_fifo(hw_ep, pio, buf); } else { + dma_unmap_single(dev, chdat->dma_addr, + chdat->transfer_len, + DMA_FROM_DEVICE); musb_read_fifo(hw_ep, pio, buf); - dma_cache_maint(phys_to_virt((u32)chdat->dma_addr), - chdat->transfer_len, DMA_FROM_DEVICE); } channel->actual_len += pio; } @@ -224,6 +227,7 @@ static int tusb_omap_dma_program(struct dma_channel *channel, u16 packet_sz, struct tusb_omap_dma_ch *chdat = to_chdat(channel); struct tusb_omap_dma *tusb_dma = chdat->tusb_dma; struct musb *musb = chdat->musb; + struct device *dev = musb->controller; struct musb_hw_ep *hw_ep = chdat->hw_ep; void __iomem *mbase = musb->mregs; void __iomem *ep_conf = hw_ep->conf; @@ -299,14 +303,16 @@ static int tusb_omap_dma_program(struct dma_channel *channel, u16 packet_sz, chdat->packet_sz = packet_sz; chdat->len = len; channel->actual_len = 0; - chdat->dma_addr = (void __iomem *)dma_addr; + chdat->dma_addr = dma_addr; channel->status = MUSB_DMA_STATUS_BUSY; /* Since we're recycling dma areas, we need to clean or invalidate */ if (chdat->tx) - dma_cache_maint(phys_to_virt(dma_addr), len, DMA_TO_DEVICE); + dma_map_single(dev, phys_to_virt(dma_addr), len, + DMA_TO_DEVICE); else - dma_cache_maint(phys_to_virt(dma_addr), len, DMA_FROM_DEVICE); + dma_map_single(dev, phys_to_virt(dma_addr), len, + DMA_FROM_DEVICE); /* Use 16-bit transfer if dma_addr is not 32-bit aligned */ if ((dma_addr & 0x3) == 0) { |