diff options
| -rw-r--r-- | drivers/regulator/fixed.c | 23 | ||||
| -rw-r--r-- | include/linux/regulator/fixed.h | 7 |
2 files changed, 18 insertions, 12 deletions
diff --git a/drivers/regulator/fixed.c b/drivers/regulator/fixed.c index 8a1e22acc202..9a7d70a9c8d7 100644 --- a/drivers/regulator/fixed.c +++ b/drivers/regulator/fixed.c @@ -202,6 +202,7 @@ static int __devinit reg_fixed_voltage_probe(struct platform_device *pdev) drvdata->startup_delay = config->startup_delay; if (gpio_is_valid(config->gpio)) { + int gpio_flag; drvdata->enable_high = config->enable_high; /* FIXME: Remove below print warning @@ -219,27 +220,25 @@ static int __devinit reg_fixed_voltage_probe(struct platform_device *pdev) dev_warn(&pdev->dev, "using GPIO 0 for regulator enable control\n"); - ret = gpio_request(config->gpio, config->supply_name); - if (ret) { - dev_err(&pdev->dev, - "Could not obtain regulator enable GPIO %d: %d\n", - config->gpio, ret); - goto err_name; - } - - /* set output direction without changing state + /* + * set output direction without changing state * to prevent glitch */ drvdata->is_enabled = config->enabled_at_boot; ret = drvdata->is_enabled ? config->enable_high : !config->enable_high; + gpio_flag = ret ? GPIOF_OUT_INIT_HIGH : GPIOF_OUT_INIT_LOW; + + if (config->gpio_is_open_drain) + gpio_flag |= GPIOF_OPEN_DRAIN; - ret = gpio_direction_output(config->gpio, ret); + ret = gpio_request_one(config->gpio, gpio_flag, + config->supply_name); if (ret) { dev_err(&pdev->dev, - "Could not configure regulator enable GPIO %d direction: %d\n", + "Could not obtain regulator enable GPIO %d: %d\n", config->gpio, ret); - goto err_gpio; + goto err_name; } drvdata->desc.ops = &fixed_voltage_gpio_ops; diff --git a/include/linux/regulator/fixed.h b/include/linux/regulator/fixed.h index 936a7d8c11a9..f83f7440b488 100644 --- a/include/linux/regulator/fixed.h +++ b/include/linux/regulator/fixed.h @@ -26,6 +26,12 @@ struct regulator_init_data; * @gpio: GPIO to use for enable control * set to -EINVAL if not used * @startup_delay: Start-up time in microseconds + * @gpio_is_open_drain: Gpio pin is open drain or normal type. + * If it is open drain type then HIGH will be set + * through PULL-UP with setting gpio as input + * and low will be set as gpio-output with driven + * to low. For non-open-drain case, the gpio will + * will be in output and drive to low/high accordingly. * @enable_high: Polarity of enable GPIO * 1 = Active high, 0 = Active low * @enabled_at_boot: Whether regulator has been enabled at @@ -43,6 +49,7 @@ struct fixed_voltage_config { int microvolts; int gpio; unsigned startup_delay; + unsigned gpio_is_open_drain:1; unsigned enable_high:1; unsigned enabled_at_boot:1; struct regulator_init_data *init_data; |