Merge branch 'sh-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-3.x

* 'sh-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-3.x:
  sh: fix the compile error in setup-sh7757.c
  serial: sh-sci: report CTS as active for get_mctrl
  sh: Add unaligned memory access for PC relative intructions
  sh: Fix unaligned memory access for branches without delay slots
  sh: Fix up fallout from cpuidle changes.
  serial: sh-sci: console Runtime PM support
  sh: Fix conflicting definitions of ptrace_triggered
  serial: sh-sci: fix DMA build by including dma-mapping.h
  serial: sh-sci: Fix up default regtype probing.
  sh: intc: enable both edges GPIO interrupts on sh7372
  shwdt: fix usage of mod_timer
  clocksource: sh_cmt: wait for CMCNT on init V2

3 files changed, 95 insertions, 13 deletions

diff --git a/drivers/clocksource/sh_cmt.c b/drivers/clocksource/sh_cmt.c
index dc7c033ef587..32a77becc098 100644
--- a/drivers/clocksource/sh_cmt.c
+++ b/drivers/clocksource/sh_cmt.c
@@ -26,6 +26,7 @@
 #include <linux/clk.h>
 #include <linux/irq.h>
 #include <linux/err.h>
+#include <linux/delay.h>
 #include <linux/clocksource.h>
 #include <linux/clockchips.h>
 #include <linux/sh_timer.h>
@@ -150,13 +151,13 @@ static void sh_cmt_start_stop_ch(struct sh_cmt_priv *p, int start)
 
 static int sh_cmt_enable(struct sh_cmt_priv *p, unsigned long *rate)
 {
-	int ret;
+	int k, ret;
 
 	/* enable clock */
 	ret = clk_enable(p->clk);
 	if (ret) {
 		dev_err(&p->pdev->dev, "cannot enable clock\n");
-		return ret;
+		goto err0;
 	}
 
 	/* make sure channel is disabled */
@@ -174,9 +175,38 @@ static int sh_cmt_enable(struct sh_cmt_priv *p, unsigned long *rate)
 	sh_cmt_write(p, CMCOR, 0xffffffff);
 	sh_cmt_write(p, CMCNT, 0);
 
+	/*
+	 * According to the sh73a0 user's manual, as CMCNT can be operated
+	 * only by the RCLK (Pseudo 32 KHz), there's one restriction on
+	 * modifying CMCNT register; two RCLK cycles are necessary before
+	 * this register is either read or any modification of the value
+	 * it holds is reflected in the LSI's actual operation.
+	 *
+	 * While at it, we're supposed to clear out the CMCNT as of this
+	 * moment, so make sure it's processed properly here.  This will
+	 * take RCLKx2 at maximum.
+	 */
+	for (k = 0; k < 100; k++) {
+		if (!sh_cmt_read(p, CMCNT))
+			break;
+		udelay(1);
+	}
+
+	if (sh_cmt_read(p, CMCNT)) {
+		dev_err(&p->pdev->dev, "cannot clear CMCNT\n");
+		ret = -ETIMEDOUT;
+		goto err1;
+	}
+
 	/* enable channel */
 	sh_cmt_start_stop_ch(p, 1);
 	return 0;
+ err1:
+	/* stop clock */
+	clk_disable(p->clk);
+
+ err0:
+	return ret;
 }
 
 static void sh_cmt_disable(struct sh_cmt_priv *p)
diff --git a/drivers/sh/intc/chip.c b/drivers/sh/intc/chip.c
index f33e2dd97934..33b2ed451e09 100644
--- a/drivers/sh/intc/chip.c
+++ b/drivers/sh/intc/chip.c
@@ -186,6 +186,9 @@ static unsigned char intc_irq_sense_table[IRQ_TYPE_SENSE_MASK + 1] = {
     !defined(CONFIG_CPU_SUBTYPE_SH7709)
 	[IRQ_TYPE_LEVEL_HIGH] = VALID(3),
 #endif
+#if defined(CONFIG_ARCH_SH7372)
+	[IRQ_TYPE_EDGE_BOTH] = VALID(4),
+#endif
 };
 
 static int intc_set_type(struct irq_data *data, unsigned int type)
diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c
index a9414facda47..5ea6ec3442e6 100644
--- a/drivers/tty/serial/sh-sci.c
+++ b/drivers/tty/serial/sh-sci.c
@@ -47,6 +47,7 @@
 #include <linux/ctype.h>
 #include <linux/err.h>
 #include <linux/dmaengine.h>
+#include <linux/dma-mapping.h>
 #include <linux/scatterlist.h>
 #include <linux/slab.h>
 
@@ -95,6 +96,12 @@ struct sci_port {
 #endif
 
 	struct notifier_block		freq_transition;
+
+#ifdef CONFIG_SERIAL_SH_SCI_CONSOLE
+	unsigned short saved_smr;
+	unsigned short saved_fcr;
+	unsigned char saved_brr;
+#endif
 };
 
 /* Function prototypes */
@@ -1076,7 +1083,7 @@ static unsigned int sci_get_mctrl(struct uart_port *port)
 	/* This routine is used for getting signals of: DTR, DCD, DSR, RI,
 	   and CTS/RTS */
 
-	return TIOCM_DTR | TIOCM_RTS | TIOCM_DSR;
+	return TIOCM_DTR | TIOCM_RTS | TIOCM_CTS | TIOCM_DSR;
 }
 
 #ifdef CONFIG_SERIAL_SH_SCI_DMA
@@ -1633,11 +1640,25 @@ static unsigned int sci_scbrr_calc(unsigned int algo_id, unsigned int bps,
 	return ((freq + 16 * bps) / (32 * bps) - 1);
 }
 
+static void sci_reset(struct uart_port *port)
+{
+	unsigned int status;
+
+	do {
+		status = sci_in(port, SCxSR);
+	} while (!(status & SCxSR_TEND(port)));
+
+	sci_out(port, SCSCR, 0x00);	/* TE=0, RE=0, CKE1=0 */
+
+	if (port->type != PORT_SCI)
+		sci_out(port, SCFCR, SCFCR_RFRST | SCFCR_TFRST);
+}
+
 static void sci_set_termios(struct uart_port *port, struct ktermios *termios,
 			    struct ktermios *old)
 {
 	struct sci_port *s = to_sci_port(port);
-	unsigned int status, baud, smr_val, max_baud;
+	unsigned int baud, smr_val, max_baud;
 	int t = -1;
 	u16 scfcr = 0;
 
@@ -1657,14 +1678,7 @@ static void sci_set_termios(struct uart_port *port, struct ktermios *termios,
 
 	sci_port_enable(s);
 
-	do {
-		status = sci_in(port, SCxSR);
-	} while (!(status & SCxSR_TEND(port)));
-
-	sci_out(port, SCSCR, 0x00);	/* TE=0, RE=0, CKE1=0 */
-
-	if (port->type != PORT_SCI)
-		sci_out(port, SCFCR, scfcr | SCFCR_RFRST | SCFCR_TFRST);
+	sci_reset(port);
 
 	smr_val = sci_in(port, SCSMR) & 3;
 
@@ -2037,7 +2051,8 @@ static int __devinit serial_console_setup(struct console *co, char *options)
 	if (options)
 		uart_parse_options(options, &baud, &parity, &bits, &flow);
 
-	/* TODO: disable clock */
+	sci_port_disable(sci_port);
+
 	return uart_set_options(port, co, baud, parity, bits, flow);
 }
 
@@ -2080,6 +2095,36 @@ static int __devinit sci_probe_earlyprintk(struct platform_device *pdev)
 	return 0;
 }
 
+#define uart_console(port)	((port)->cons->index == (port)->line)
+
+static int sci_runtime_suspend(struct device *dev)
+{
+	struct sci_port *sci_port = dev_get_drvdata(dev);
+	struct uart_port *port = &sci_port->port;
+
+	if (uart_console(port)) {
+		sci_port->saved_smr = sci_in(port, SCSMR);
+		sci_port->saved_brr = sci_in(port, SCBRR);
+		sci_port->saved_fcr = sci_in(port, SCFCR);
+	}
+	return 0;
+}
+
+static int sci_runtime_resume(struct device *dev)
+{
+	struct sci_port *sci_port = dev_get_drvdata(dev);
+	struct uart_port *port = &sci_port->port;
+
+	if (uart_console(port)) {
+		sci_reset(port);
+		sci_out(port, SCSMR, sci_port->saved_smr);
+		sci_out(port, SCBRR, sci_port->saved_brr);
+		sci_out(port, SCFCR, sci_port->saved_fcr);
+		sci_out(port, SCSCR, sci_port->cfg->scscr);
+	}
+	return 0;
+}
+
 #define SCI_CONSOLE	(&serial_console)
 
 #else
@@ -2089,6 +2134,8 @@ static inline int __devinit sci_probe_earlyprintk(struct platform_device *pdev)
 }
 
 #define SCI_CONSOLE	NULL
+#define sci_runtime_suspend	NULL
+#define sci_runtime_resume	NULL
 
 #endif /* CONFIG_SERIAL_SH_SCI_CONSOLE */
 
@@ -2204,6 +2251,8 @@ static int sci_resume(struct device *dev)
 }
 
 static const struct dev_pm_ops sci_dev_pm_ops = {
+	.runtime_suspend = sci_runtime_suspend,
+	.runtime_resume = sci_runtime_resume,
 	.suspend	= sci_suspend,
 	.resume		= sci_resume,
 };