Input: add I2C attached EETI EXC3000 multi touch driver

The 3000 series have a new protocol which allows to report up to 5 points
in a single 66 byte frame. One must always read in 66 byte frames.
To support up to 10 points, two consecutive frames need to be read:
The first frame says how many points until sync.
The second frame must say zero points or both frames must be discarded.

To be able to work with the higher 400KHz I2C bus rate, one must
successfully send a special package prior _each_ read or the controller
will refuse to cooperate.

This is a minimal implementation based on egalax_i2c.c (which can be found
on the internet) and egalax_ts.c but without the vendor interface and no
power management support.

Signed-off-by: Ahmet Inan <inan@distec.de>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

1 files changed, 27 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/input/touchscreen/exc3000.txt b/Documentation/devicetree/bindings/input/touchscreen/exc3000.txt
new file mode 100644
index 000000000000..1dcff4a43eaa
--- /dev/null
+++ b/Documentation/devicetree/bindings/input/touchscreen/exc3000.txt
@@ -0,0 +1,27 @@
+* EETI EXC3000 Multiple Touch Controller
+
+Required properties:
+- compatible: must be "eeti,exc3000"
+- reg: i2c slave address
+- interrupt-parent: the phandle for the interrupt controller
+- interrupts: touch controller interrupt
+- touchscreen-size-x: See touchscreen.txt
+- touchscreen-size-y: See touchscreen.txt
+
+Optional properties:
+- touchscreen-inverted-x: See touchscreen.txt
+- touchscreen-inverted-y: See touchscreen.txt
+- touchscreen-swapped-x-y: See touchscreen.txt
+
+Example:
+
+	touchscreen@2a {
+		compatible = "eeti,exc3000";
+		reg = <0x2a>;
+		interrupt-parent = <&gpio1>;
+		interrupts = <9 IRQ_TYPE_LEVEL_LOW>;
+		touchscreen-size-x = <4096>;
+		touchscreen-size-y = <4096>;
+		touchscreen-inverted-x;
+		touchscreen-swapped-x-y;
+	};