From 251eb40f5ccd07a905633a816fbf8f2b6b25cced Mon Sep 17 00:00:00 2001 From: Jonathan Cameron Date: Mon, 13 Apr 2009 14:39:45 -0700 Subject: hwmon: sht15 humidity sensor driver Data sheet at: http://www.sensirion.ch/en/pdf/product_information/Datasheet-humidity-sensor-SHT1x.pdf These sensors communicate over a 2 wire bus running a device specific protocol. The complexity of the driver is mainly due to handling the substantial delays between requesting a reading and the device pulling the data line low to indicate that the data is available. This is handled by an interrupt that is disabled under all other conditions. I wasn't terribly clear on the best way to handle this, so comments on that aspect would be particularly welcome! Interpretation of the temperature depends on knowing the supply voltage. If configured in a board config as a regulator consumer this is obtained from the regulator subsystem. If not it should be provided in the platform data. I've placed this driver in the hwmon subsystem as it is definitely a device that may be used for hardware monitoring and with it's relatively slow response times (up to 120 millisecs to get a reading) a caching strategy certainly seems to make sense! Signed-off-by: Jonathan Cameron Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- drivers/hwmon/Makefile | 1 + 1 file changed, 1 insertion(+) (limited to 'drivers/hwmon/Makefile') diff --git a/drivers/hwmon/Makefile b/drivers/hwmon/Makefile index 1d3757837b4f..0ae26984ba45 100644 --- a/drivers/hwmon/Makefile +++ b/drivers/hwmon/Makefile @@ -76,6 +76,7 @@ obj-$(CONFIG_SENSORS_MAX6650) += max6650.o obj-$(CONFIG_SENSORS_PC87360) += pc87360.o obj-$(CONFIG_SENSORS_PC87427) += pc87427.o obj-$(CONFIG_SENSORS_PCF8591) += pcf8591.o +obj-$(CONFIG_SENSORS_SHT15) += sht15.o obj-$(CONFIG_SENSORS_SIS5595) += sis5595.o obj-$(CONFIG_SENSORS_SMSC47B397)+= smsc47b397.o obj-$(CONFIG_SENSORS_SMSC47M1) += smsc47m1.o -- cgit v1.2.3