diff options
Diffstat (limited to 'include/linux/pinctrl')
| -rw-r--r-- | include/linux/pinctrl/pinconf-generic.h | 18 |
1 files changed, 11 insertions, 7 deletions
diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h index 279e3c5326e3..231d3075815a 100644 --- a/include/linux/pinctrl/pinconf-generic.h +++ b/include/linux/pinctrl/pinconf-generic.h @@ -42,8 +42,6 @@ * @PIN_CONFIG_BIAS_PULL_UP: the pin will be pulled up (usually with high * impedance to VDD). If the argument is != 0 pull-up is enabled, * if it is 0, pull-up is total, i.e. the pin is connected to VDD. - * @PIN_CONFIG_BIDIRECTIONAL: the pin will be configured to allow simultaneous - * input and output operations. * @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open * collector) which means it is usually wired with other output ports * which are then pulled up with an external resistor. Setting this @@ -75,10 +73,16 @@ * operation, if several modes of operation are supported these can be * passed in the argument on a custom form, else just use argument 1 * to indicate low power mode, argument 0 turns low power mode off. - * @PIN_CONFIG_OUTPUT: this will configure the pin as an output. Use argument - * 1 to indicate high level, argument 0 to indicate low level. (Please - * see Documentation/pinctrl.txt, section "GPIO mode pitfalls" for a - * discussion around this parameter.) + * @PIN_CONFIG_OUTPUT_ENABLE: this will enable the pin's output mode + * without driving a value there. For most platforms this reduces to + * enable the output buffers and then let the pin controller current + * configuration (eg. the currently selected mux function) drive values on + * the line. Use argument 1 to enable output mode, argument 0 to disable + * it. + * @PIN_CONFIG_OUTPUT: this will configure the pin as an output and drive a + * value on the line. Use argument 1 to indicate high level, argument 0 to + * indicate low level. (Please see Documentation/pinctrl.txt, section + * "GPIO mode pitfalls" for a discussion around this parameter.) * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power * supplies, the argument to this parameter (on a custom format) tells * the driver which alternative power source to use. @@ -98,7 +102,6 @@ enum pin_config_param { PIN_CONFIG_BIAS_PULL_DOWN, PIN_CONFIG_BIAS_PULL_PIN_DEFAULT, PIN_CONFIG_BIAS_PULL_UP, - PIN_CONFIG_BIDIRECTIONAL, PIN_CONFIG_DRIVE_OPEN_DRAIN, PIN_CONFIG_DRIVE_OPEN_SOURCE, PIN_CONFIG_DRIVE_PUSH_PULL, @@ -108,6 +111,7 @@ enum pin_config_param { PIN_CONFIG_INPUT_SCHMITT, PIN_CONFIG_INPUT_SCHMITT_ENABLE, PIN_CONFIG_LOW_POWER_MODE, + PIN_CONFIG_OUTPUT_ENABLE, PIN_CONFIG_OUTPUT, PIN_CONFIG_POWER_SOURCE, PIN_CONFIG_SLEW_RATE, |