diff options
Diffstat (limited to 'drivers/spi/spi-dw.h')
| -rw-r--r-- | drivers/spi/spi-dw.h | 233 |
1 files changed, 233 insertions, 0 deletions
diff --git a/drivers/spi/spi-dw.h b/drivers/spi/spi-dw.h new file mode 100644 index 000000000000..8b7b07bf6c3f --- /dev/null +++ b/drivers/spi/spi-dw.h @@ -0,0 +1,233 @@ +#ifndef DW_SPI_HEADER_H +#define DW_SPI_HEADER_H + +#include <linux/io.h> +#include <linux/scatterlist.h> + +/* Bit fields in CTRLR0 */ +#define SPI_DFS_OFFSET 0 + +#define SPI_FRF_OFFSET 4 +#define SPI_FRF_SPI 0x0 +#define SPI_FRF_SSP 0x1 +#define SPI_FRF_MICROWIRE 0x2 +#define SPI_FRF_RESV 0x3 + +#define SPI_MODE_OFFSET 6 +#define SPI_SCPH_OFFSET 6 +#define SPI_SCOL_OFFSET 7 + +#define SPI_TMOD_OFFSET 8 +#define SPI_TMOD_MASK (0x3 << SPI_TMOD_OFFSET) +#define SPI_TMOD_TR 0x0 /* xmit & recv */ +#define SPI_TMOD_TO 0x1 /* xmit only */ +#define SPI_TMOD_RO 0x2 /* recv only */ +#define SPI_TMOD_EPROMREAD 0x3 /* eeprom read mode */ + +#define SPI_SLVOE_OFFSET 10 +#define SPI_SRL_OFFSET 11 +#define SPI_CFS_OFFSET 12 + +/* Bit fields in SR, 7 bits */ +#define SR_MASK 0x7f /* cover 7 bits */ +#define SR_BUSY (1 << 0) +#define SR_TF_NOT_FULL (1 << 1) +#define SR_TF_EMPT (1 << 2) +#define SR_RF_NOT_EMPT (1 << 3) +#define SR_RF_FULL (1 << 4) +#define SR_TX_ERR (1 << 5) +#define SR_DCOL (1 << 6) + +/* Bit fields in ISR, IMR, RISR, 7 bits */ +#define SPI_INT_TXEI (1 << 0) +#define SPI_INT_TXOI (1 << 1) +#define SPI_INT_RXUI (1 << 2) +#define SPI_INT_RXOI (1 << 3) +#define SPI_INT_RXFI (1 << 4) +#define SPI_INT_MSTI (1 << 5) + +/* TX RX interrupt level threshold, max can be 256 */ +#define SPI_INT_THRESHOLD 32 + +enum dw_ssi_type { + SSI_MOTO_SPI = 0, + SSI_TI_SSP, + SSI_NS_MICROWIRE, +}; + +struct dw_spi_reg { + u32 ctrl0; + u32 ctrl1; + u32 ssienr; + u32 mwcr; + u32 ser; + u32 baudr; + u32 txfltr; + u32 rxfltr; + u32 txflr; + u32 rxflr; + u32 sr; + u32 imr; + u32 isr; + u32 risr; + u32 txoicr; + u32 rxoicr; + u32 rxuicr; + u32 msticr; + u32 icr; + u32 dmacr; + u32 dmatdlr; + u32 dmardlr; + u32 idr; + u32 version; + u32 dr; /* Currently oper as 32 bits, + though only low 16 bits matters */ +} __packed; + +struct dw_spi; +struct dw_spi_dma_ops { + int (*dma_init)(struct dw_spi *dws); + void (*dma_exit)(struct dw_spi *dws); + int (*dma_transfer)(struct dw_spi *dws, int cs_change); +}; + +struct dw_spi { + struct spi_master *master; + struct spi_device *cur_dev; + struct device *parent_dev; + enum dw_ssi_type type; + char name[16]; + + void __iomem *regs; + unsigned long paddr; + u32 iolen; + int irq; + u32 fifo_len; /* depth of the FIFO buffer */ + u32 max_freq; /* max bus freq supported */ + + u16 bus_num; + u16 num_cs; /* supported slave numbers */ + + /* Driver message queue */ + struct workqueue_struct *workqueue; + struct work_struct pump_messages; + spinlock_t lock; + struct list_head queue; + int busy; + int run; + + /* Message Transfer pump */ + struct tasklet_struct pump_transfers; + + /* Current message transfer state info */ + struct spi_message *cur_msg; + struct spi_transfer *cur_transfer; + struct chip_data *cur_chip; + struct chip_data *prev_chip; + size_t len; + void *tx; + void *tx_end; + void *rx; + void *rx_end; + int dma_mapped; + dma_addr_t rx_dma; + dma_addr_t tx_dma; + size_t rx_map_len; + size_t tx_map_len; + u8 n_bytes; /* current is a 1/2 bytes op */ + u8 max_bits_per_word; /* maxim is 16b */ + u32 dma_width; + int cs_change; + irqreturn_t (*transfer_handler)(struct dw_spi *dws); + void (*cs_control)(u32 command); + + /* Dma info */ + int dma_inited; + struct dma_chan *txchan; + struct scatterlist tx_sgl; + struct dma_chan *rxchan; + struct scatterlist rx_sgl; + int dma_chan_done; + struct device *dma_dev; + dma_addr_t dma_addr; /* phy address of the Data register */ + struct dw_spi_dma_ops *dma_ops; + void *dma_priv; /* platform relate info */ + struct pci_dev *dmac; + + /* Bus interface info */ + void *priv; +#ifdef CONFIG_DEBUG_FS + struct dentry *debugfs; +#endif +}; + +#define dw_readl(dw, name) \ + __raw_readl(&(((struct dw_spi_reg *)dw->regs)->name)) +#define dw_writel(dw, name, val) \ + __raw_writel((val), &(((struct dw_spi_reg *)dw->regs)->name)) +#define dw_readw(dw, name) \ + __raw_readw(&(((struct dw_spi_reg *)dw->regs)->name)) +#define dw_writew(dw, name, val) \ + __raw_writew((val), &(((struct dw_spi_reg *)dw->regs)->name)) + +static inline void spi_enable_chip(struct dw_spi *dws, int enable) +{ + dw_writel(dws, ssienr, (enable ? 1 : 0)); +} + +static inline void spi_set_clk(struct dw_spi *dws, u16 div) +{ + dw_writel(dws, baudr, div); +} + +static inline void spi_chip_sel(struct dw_spi *dws, u16 cs) +{ + if (cs > dws->num_cs) + return; + + if (dws->cs_control) + dws->cs_control(1); + + dw_writel(dws, ser, 1 << cs); +} + +/* Disable IRQ bits */ +static inline void spi_mask_intr(struct dw_spi *dws, u32 mask) +{ + u32 new_mask; + + new_mask = dw_readl(dws, imr) & ~mask; + dw_writel(dws, imr, new_mask); +} + +/* Enable IRQ bits */ +static inline void spi_umask_intr(struct dw_spi *dws, u32 mask) +{ + u32 new_mask; + + new_mask = dw_readl(dws, imr) | mask; + dw_writel(dws, imr, new_mask); +} + +/* + * Each SPI slave device to work with dw_api controller should + * has such a structure claiming its working mode (PIO/DMA etc), + * which can be save in the "controller_data" member of the + * struct spi_device + */ +struct dw_spi_chip { + u8 poll_mode; /* 0 for contoller polling mode */ + u8 type; /* SPI/SSP/Micrwire */ + u8 enable_dma; + void (*cs_control)(u32 command); +}; + +extern int dw_spi_add_host(struct dw_spi *dws); +extern void dw_spi_remove_host(struct dw_spi *dws); +extern int dw_spi_suspend_host(struct dw_spi *dws); +extern int dw_spi_resume_host(struct dw_spi *dws); +extern void dw_spi_xfer_done(struct dw_spi *dws); + +/* platform related setup */ +extern int dw_spi_mid_init(struct dw_spi *dws); /* Intel MID platforms */ +#endif /* DW_SPI_HEADER_H */ |