diff options
Diffstat (limited to 'drivers/phy/qualcomm/phy-qcom-m31.c')
| -rw-r--r-- | drivers/phy/qualcomm/phy-qcom-m31.c | 294 |
1 files changed, 294 insertions, 0 deletions
diff --git a/drivers/phy/qualcomm/phy-qcom-m31.c b/drivers/phy/qualcomm/phy-qcom-m31.c new file mode 100644 index 000000000000..ed08072ca032 --- /dev/null +++ b/drivers/phy/qualcomm/phy-qcom-m31.c @@ -0,0 +1,294 @@ +// SPDX-License-Identifier: GPL-2.0+ +/* + * Copyright (c) 2014-2023, The Linux Foundation. All rights reserved. + */ + +#include <linux/clk.h> +#include <linux/delay.h> +#include <linux/err.h> +#include <linux/io.h> +#include <linux/kernel.h> +#include <linux/module.h> +#include <linux/of.h> +#include <linux/phy/phy.h> +#include <linux/platform_device.h> +#include <linux/reset.h> +#include <linux/slab.h> + +#define USB2PHY_PORT_UTMI_CTRL1 0x40 + +#define USB2PHY_PORT_UTMI_CTRL2 0x44 + #define UTMI_ULPI_SEL BIT(7) + #define UTMI_TEST_MUX_SEL BIT(6) + +#define HS_PHY_CTRL_REG 0x10 + #define UTMI_OTG_VBUS_VALID BIT(20) + #define SW_SESSVLD_SEL BIT(28) + +#define USB_PHY_UTMI_CTRL0 0x3c + +#define USB_PHY_UTMI_CTRL5 0x50 + #define POR_EN BIT(1) + +#define USB_PHY_HS_PHY_CTRL_COMMON0 0x54 + #define COMMONONN BIT(7) + #define FSEL BIT(4) + #define RETENABLEN BIT(3) + #define FREQ_24MHZ (BIT(6) | BIT(4)) + +#define USB_PHY_HS_PHY_CTRL2 0x64 + #define USB2_SUSPEND_N_SEL BIT(3) + #define USB2_SUSPEND_N BIT(2) + #define USB2_UTMI_CLK_EN BIT(1) + +#define USB_PHY_CFG0 0x94 + #define UTMI_PHY_OVERRIDE_EN BIT(1) + +#define USB_PHY_REFCLK_CTRL 0xa0 + #define CLKCORE BIT(1) + +#define USB2PHY_PORT_POWERDOWN 0xa4 + #define POWER_UP BIT(0) + #define POWER_DOWN 0 + +#define USB_PHY_FSEL_SEL 0xb8 + #define FREQ_SEL BIT(0) + +#define USB2PHY_USB_PHY_M31_XCFGI_1 0xbc + #define USB2_0_TX_ENABLE BIT(2) + +#define USB2PHY_USB_PHY_M31_XCFGI_4 0xc8 + #define HSTX_SLEW_RATE_565PS GENMASK(1, 0) + #define PLL_CHARGING_PUMP_CURRENT_35UA GENMASK(4, 3) + #define ODT_VALUE_38_02_OHM GENMASK(7, 6) + +#define USB2PHY_USB_PHY_M31_XCFGI_5 0xcc + #define ODT_VALUE_45_02_OHM BIT(2) + #define HSTX_PRE_EMPHASIS_LEVEL_0_55MA BIT(0) + +#define USB2PHY_USB_PHY_M31_XCFGI_11 0xe4 + #define XCFG_COARSE_TUNE_NUM BIT(1) + #define XCFG_FINE_TUNE_NUM BIT(3) + +struct m31_phy_regs { + u32 off; + u32 val; + u32 delay; +}; + +struct m31_priv_data { + bool ulpi_mode; + const struct m31_phy_regs *regs; + unsigned int nregs; +}; + +struct m31_phy_regs m31_ipq5332_regs[] = { + { + USB_PHY_CFG0, + UTMI_PHY_OVERRIDE_EN, + 0 + }, + { + USB_PHY_UTMI_CTRL5, + POR_EN, + 15 + }, + { + USB_PHY_FSEL_SEL, + FREQ_SEL, + 0 + }, + { + USB_PHY_HS_PHY_CTRL_COMMON0, + COMMONONN | FREQ_24MHZ | RETENABLEN, + 0 + }, + { + USB_PHY_UTMI_CTRL5, + POR_EN, + 0 + }, + { + USB_PHY_HS_PHY_CTRL2, + USB2_SUSPEND_N_SEL | USB2_SUSPEND_N | USB2_UTMI_CLK_EN, + 0 + }, + { + USB2PHY_USB_PHY_M31_XCFGI_11, + XCFG_COARSE_TUNE_NUM | XCFG_FINE_TUNE_NUM, + 0 + }, + { + USB2PHY_USB_PHY_M31_XCFGI_4, + HSTX_SLEW_RATE_565PS | PLL_CHARGING_PUMP_CURRENT_35UA | ODT_VALUE_38_02_OHM, + 0 + }, + { + USB2PHY_USB_PHY_M31_XCFGI_1, + USB2_0_TX_ENABLE, + 0 + }, + { + USB2PHY_USB_PHY_M31_XCFGI_5, + ODT_VALUE_45_02_OHM | HSTX_PRE_EMPHASIS_LEVEL_0_55MA, + 4 + }, + { + USB_PHY_UTMI_CTRL5, + 0x0, + 0 + }, + { + USB_PHY_HS_PHY_CTRL2, + USB2_SUSPEND_N | USB2_UTMI_CLK_EN, + 0 + }, +}; + +struct m31usb_phy { + struct phy *phy; + void __iomem *base; + const struct m31_phy_regs *regs; + int nregs; + + struct regulator *vreg; + struct clk *clk; + struct reset_control *reset; + + bool ulpi_mode; +}; + +static int m31usb_phy_init(struct phy *phy) +{ + struct m31usb_phy *qphy = phy_get_drvdata(phy); + const struct m31_phy_regs *regs = qphy->regs; + int i, ret; + + ret = regulator_enable(qphy->vreg); + if (ret) { + dev_err(&phy->dev, "failed to enable regulator, %d\n", ret); + return ret; + } + + ret = clk_prepare_enable(qphy->clk); + if (ret) { + if (qphy->vreg) + regulator_disable(qphy->vreg); + dev_err(&phy->dev, "failed to enable cfg ahb clock, %d\n", ret); + return ret; + } + + /* Perform phy reset */ + reset_control_assert(qphy->reset); + udelay(5); + reset_control_deassert(qphy->reset); + + /* configure for ULPI mode if requested */ + if (qphy->ulpi_mode) + writel(0x0, qphy->base + USB2PHY_PORT_UTMI_CTRL2); + + /* Enable the PHY */ + writel(POWER_UP, qphy->base + USB2PHY_PORT_POWERDOWN); + + /* Turn on phy ref clock */ + for (i = 0; i < qphy->nregs; i++) { + writel(regs[i].val, qphy->base + regs[i].off); + if (regs[i].delay) + udelay(regs[i].delay); + } + + return 0; +} + +static int m31usb_phy_shutdown(struct phy *phy) +{ + struct m31usb_phy *qphy = phy_get_drvdata(phy); + + /* Disable the PHY */ + writel_relaxed(POWER_DOWN, qphy->base + USB2PHY_PORT_POWERDOWN); + + clk_disable_unprepare(qphy->clk); + + regulator_disable(qphy->vreg); + + return 0; +} + +static const struct phy_ops m31usb_phy_gen_ops = { + .power_on = m31usb_phy_init, + .power_off = m31usb_phy_shutdown, + .owner = THIS_MODULE, +}; + +static int m31usb_phy_probe(struct platform_device *pdev) +{ + struct phy_provider *phy_provider; + const struct m31_priv_data *data; + struct device *dev = &pdev->dev; + struct m31usb_phy *qphy; + + qphy = devm_kzalloc(dev, sizeof(*qphy), GFP_KERNEL); + if (!qphy) + return -ENOMEM; + + qphy->base = devm_platform_ioremap_resource(pdev, 0); + if (IS_ERR(qphy->base)) + return PTR_ERR(qphy->base); + + qphy->reset = devm_reset_control_get_exclusive_by_index(dev, 0); + if (IS_ERR(qphy->reset)) + return PTR_ERR(qphy->reset); + + qphy->clk = devm_clk_get(dev, NULL); + if (IS_ERR(qphy->clk)) + return dev_err_probe(dev, PTR_ERR(qphy->clk), + "failed to get clk\n"); + + data = of_device_get_match_data(dev); + qphy->regs = data->regs; + qphy->nregs = data->nregs; + qphy->ulpi_mode = data->ulpi_mode; + + qphy->phy = devm_phy_create(dev, NULL, &m31usb_phy_gen_ops); + if (IS_ERR(qphy->phy)) + return dev_err_probe(dev, PTR_ERR(qphy->phy), + "failed to create phy\n"); + + qphy->vreg = devm_regulator_get(dev, "vdda-phy"); + if (IS_ERR(qphy->vreg)) + return dev_err_probe(dev, PTR_ERR(qphy->phy), + "failed to get vreg\n"); + + phy_set_drvdata(qphy->phy, qphy); + + phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate); + if (!IS_ERR(phy_provider)) + dev_info(dev, "Registered M31 USB phy\n"); + + return PTR_ERR_OR_ZERO(phy_provider); +} + +static const struct m31_priv_data m31_ipq5332_data = { + .ulpi_mode = false, + .regs = m31_ipq5332_regs, + .nregs = ARRAY_SIZE(m31_ipq5332_regs), +}; + +static const struct of_device_id m31usb_phy_id_table[] = { + { .compatible = "qcom,ipq5332-usb-hsphy", .data = &m31_ipq5332_data }, + { }, +}; +MODULE_DEVICE_TABLE(of, m31usb_phy_id_table); + +static struct platform_driver m31usb_phy_driver = { + .probe = m31usb_phy_probe, + .driver = { + .name = "qcom-m31usb-phy", + .of_match_table = m31usb_phy_id_table, + }, +}; + +module_platform_driver(m31usb_phy_driver); + +MODULE_DESCRIPTION("USB2 Qualcomm M31 HSPHY driver"); +MODULE_LICENSE("GPL"); |