diff options
Diffstat (limited to 'drivers/net/wireless/rt2x00/rt61pci.c')
| -rw-r--r-- | drivers/net/wireless/rt2x00/rt61pci.c | 130 |
1 files changed, 94 insertions, 36 deletions
diff --git a/drivers/net/wireless/rt2x00/rt61pci.c b/drivers/net/wireless/rt2x00/rt61pci.c index 6a74baf4e934..e539c6cb636f 100644 --- a/drivers/net/wireless/rt2x00/rt61pci.c +++ b/drivers/net/wireless/rt2x00/rt61pci.c @@ -931,6 +931,9 @@ static void rt61pci_config_retry_limit(struct rt2x00_dev *rt2x00dev, u32 reg; rt2x00pci_register_read(rt2x00dev, TXRX_CSR4, ®); + rt2x00_set_field32(®, TXRX_CSR4_OFDM_TX_RATE_DOWN, 1); + rt2x00_set_field32(®, TXRX_CSR4_OFDM_TX_RATE_STEP, 0); + rt2x00_set_field32(®, TXRX_CSR4_OFDM_TX_FALLBACK_CCK, 0); rt2x00_set_field32(®, TXRX_CSR4_LONG_RETRY_LIMIT, libconf->conf->long_frame_max_tx_count); rt2x00_set_field32(®, TXRX_CSR4_SHORT_RETRY_LIMIT, @@ -1619,7 +1622,8 @@ static void rt61pci_toggle_rx(struct rt2x00_dev *rt2x00dev, static void rt61pci_toggle_irq(struct rt2x00_dev *rt2x00dev, enum dev_state state) { - int mask = (state == STATE_RADIO_IRQ_OFF); + int mask = (state == STATE_RADIO_IRQ_OFF) || + (state == STATE_RADIO_IRQ_OFF_ISR); u32 reg; /* @@ -1736,7 +1740,9 @@ static int rt61pci_set_device_state(struct rt2x00_dev *rt2x00dev, rt61pci_toggle_rx(rt2x00dev, state); break; case STATE_RADIO_IRQ_ON: + case STATE_RADIO_IRQ_ON_ISR: case STATE_RADIO_IRQ_OFF: + case STATE_RADIO_IRQ_OFF_ISR: rt61pci_toggle_irq(rt2x00dev, state); break; case STATE_DEEP_SLEEP: @@ -1874,6 +1880,16 @@ static void rt61pci_write_beacon(struct queue_entry *entry, rt2x00pci_register_write(rt2x00dev, TXRX_CSR9, reg); /* + * Write the TX descriptor for the beacon. + */ + rt61pci_write_tx_desc(rt2x00dev, entry->skb, txdesc); + + /* + * Dump beacon to userspace through debugfs. + */ + rt2x00debug_dump_frame(rt2x00dev, DUMP_FRAME_BEACON, entry->skb); + + /* * Write entire beacon with descriptor to register. */ beacon_base = HW_BEACON_OFFSET(entry->entry_idx); @@ -2039,29 +2055,24 @@ static void rt61pci_txdone(struct rt2x00_dev *rt2x00dev) struct txdone_entry_desc txdesc; u32 word; u32 reg; - u32 old_reg; int type; int index; + int i; /* - * During each loop we will compare the freshly read - * STA_CSR4 register value with the value read from - * the previous loop. If the 2 values are equal then - * we should stop processing because the chance is - * quite big that the device has been unplugged and - * we risk going into an endless loop. + * TX_STA_FIFO is a stack of X entries, hence read TX_STA_FIFO + * at most X times and also stop processing once the TX_STA_FIFO_VALID + * flag is not set anymore. + * + * The legacy drivers use X=TX_RING_SIZE but state in a comment + * that the TX_STA_FIFO stack has a size of 16. We stick to our + * tx ring size for now. */ - old_reg = 0; - - while (1) { + for (i = 0; i < TX_ENTRIES; i++) { rt2x00pci_register_read(rt2x00dev, STA_CSR4, ®); if (!rt2x00_get_field32(reg, STA_CSR4_VALID)) break; - if (old_reg == reg) - break; - old_reg = reg; - /* * Skip this entry when it contains an invalid * queue identication number. @@ -2120,6 +2131,13 @@ static void rt61pci_txdone(struct rt2x00_dev *rt2x00dev) } txdesc.retry = rt2x00_get_field32(reg, STA_CSR4_RETRY_COUNT); + /* + * the frame was retried at least once + * -> hw used fallback rates + */ + if (txdesc.retry) + __set_bit(TXDONE_FALLBACK, &txdesc.flags); + rt2x00lib_txdone(entry, &txdesc); } } @@ -2132,27 +2150,11 @@ static void rt61pci_wakeup(struct rt2x00_dev *rt2x00dev) rt61pci_config(rt2x00dev, &libconf, IEEE80211_CONF_CHANGE_PS); } -static irqreturn_t rt61pci_interrupt(int irq, void *dev_instance) +static irqreturn_t rt61pci_interrupt_thread(int irq, void *dev_instance) { struct rt2x00_dev *rt2x00dev = dev_instance; - u32 reg_mcu; - u32 reg; - - /* - * Get the interrupt sources & saved to local variable. - * Write register value back to clear pending interrupts. - */ - rt2x00pci_register_read(rt2x00dev, MCU_INT_SOURCE_CSR, ®_mcu); - rt2x00pci_register_write(rt2x00dev, MCU_INT_SOURCE_CSR, reg_mcu); - - rt2x00pci_register_read(rt2x00dev, INT_SOURCE_CSR, ®); - rt2x00pci_register_write(rt2x00dev, INT_SOURCE_CSR, reg); - - if (!reg && !reg_mcu) - return IRQ_NONE; - - if (!test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags)) - return IRQ_HANDLED; + u32 reg = rt2x00dev->irqvalue[0]; + u32 reg_mcu = rt2x00dev->irqvalue[1]; /* * Handle interrupts, walk through all bits @@ -2185,9 +2187,51 @@ static irqreturn_t rt61pci_interrupt(int irq, void *dev_instance) if (rt2x00_get_field32(reg_mcu, MCU_INT_SOURCE_CSR_TWAKEUP)) rt61pci_wakeup(rt2x00dev); + /* + * 5 - Beacon done interrupt. + */ + if (rt2x00_get_field32(reg, INT_SOURCE_CSR_BEACON_DONE)) + rt2x00lib_beacondone(rt2x00dev); + + /* Enable interrupts again. */ + rt2x00dev->ops->lib->set_device_state(rt2x00dev, + STATE_RADIO_IRQ_ON_ISR); return IRQ_HANDLED; } + +static irqreturn_t rt61pci_interrupt(int irq, void *dev_instance) +{ + struct rt2x00_dev *rt2x00dev = dev_instance; + u32 reg_mcu; + u32 reg; + + /* + * Get the interrupt sources & saved to local variable. + * Write register value back to clear pending interrupts. + */ + rt2x00pci_register_read(rt2x00dev, MCU_INT_SOURCE_CSR, ®_mcu); + rt2x00pci_register_write(rt2x00dev, MCU_INT_SOURCE_CSR, reg_mcu); + + rt2x00pci_register_read(rt2x00dev, INT_SOURCE_CSR, ®); + rt2x00pci_register_write(rt2x00dev, INT_SOURCE_CSR, reg); + + if (!reg && !reg_mcu) + return IRQ_NONE; + + if (!test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags)) + return IRQ_HANDLED; + + /* Store irqvalues for use in the interrupt thread. */ + rt2x00dev->irqvalue[0] = reg; + rt2x00dev->irqvalue[1] = reg_mcu; + + /* Disable interrupts, will be enabled again in the interrupt thread. */ + rt2x00dev->ops->lib->set_device_state(rt2x00dev, + STATE_RADIO_IRQ_OFF_ISR); + return IRQ_WAKE_THREAD; +} + /* * Device probe functions. */ @@ -2577,6 +2621,18 @@ static int rt61pci_probe_hw_mode(struct rt2x00_dev *rt2x00dev) EEPROM_MAC_ADDR_0)); /* + * As rt61 has a global fallback table we cannot specify + * more then one tx rate per frame but since the hw will + * try several rates (based on the fallback table) we should + * still initialize max_rates to the maximum number of rates + * we are going to try. Otherwise mac80211 will truncate our + * reported tx rates and the rc algortihm will end up with + * incorrect data. + */ + rt2x00dev->hw->max_rates = 7; + rt2x00dev->hw->max_rate_tries = 1; + + /* * Initialize hw_mode information. */ spec->supported_bands = SUPPORT_BAND_2GHZ; @@ -2657,6 +2713,7 @@ static int rt61pci_probe_hw(struct rt2x00_dev *rt2x00dev) __set_bit(DRIVER_REQUIRE_DMA, &rt2x00dev->flags); if (!modparam_nohwcrypt) __set_bit(CONFIG_SUPPORT_HW_CRYPTO, &rt2x00dev->flags); + __set_bit(DRIVER_SUPPORT_LINK_TUNING, &rt2x00dev->flags); /* * Set the rssi offset. @@ -2748,8 +2805,9 @@ static const struct ieee80211_ops rt61pci_mac80211_ops = { .remove_interface = rt2x00mac_remove_interface, .config = rt2x00mac_config, .configure_filter = rt2x00mac_configure_filter, - .set_tim = rt2x00mac_set_tim, .set_key = rt2x00mac_set_key, + .sw_scan_start = rt2x00mac_sw_scan_start, + .sw_scan_complete = rt2x00mac_sw_scan_complete, .get_stats = rt2x00mac_get_stats, .bss_info_changed = rt2x00mac_bss_info_changed, .conf_tx = rt61pci_conf_tx, @@ -2759,6 +2817,7 @@ static const struct ieee80211_ops rt61pci_mac80211_ops = { static const struct rt2x00lib_ops rt61pci_rt2x00_ops = { .irq_handler = rt61pci_interrupt, + .irq_handler_thread = rt61pci_interrupt_thread, .probe_hw = rt61pci_probe_hw, .get_firmware_name = rt61pci_get_firmware_name, .check_firmware = rt61pci_check_firmware, @@ -2773,7 +2832,6 @@ static const struct rt2x00lib_ops rt61pci_rt2x00_ops = { .reset_tuner = rt61pci_reset_tuner, .link_tuner = rt61pci_link_tuner, .write_tx_desc = rt61pci_write_tx_desc, - .write_tx_data = rt2x00pci_write_tx_data, .write_beacon = rt61pci_write_beacon, .kick_tx_queue = rt61pci_kick_tx_queue, .kill_tx_queue = rt61pci_kill_tx_queue, |