diff options
Diffstat (limited to 'drivers/net/wireless/rt2x00/rt2x00queue.h')
-rw-r--r-- | drivers/net/wireless/rt2x00/rt2x00queue.h | 136 |
1 files changed, 87 insertions, 49 deletions
diff --git a/drivers/net/wireless/rt2x00/rt2x00queue.h b/drivers/net/wireless/rt2x00/rt2x00queue.h index 7027c9f47d3f..8945945c892e 100644 --- a/drivers/net/wireless/rt2x00/rt2x00queue.h +++ b/drivers/net/wireless/rt2x00/rt2x00queue.h @@ -42,18 +42,32 @@ /** * DOC: Number of entries per queue * - * After research it was concluded that 12 entries in a RX and TX - * queue would be sufficient. Although this is almost one third of - * the amount the legacy driver allocated, the queues aren't getting - * filled to the maximum even when working with the maximum rate. + * Under normal load without fragmentation 12 entries are sufficient + * without the queue being filled up to the maximum. When using fragmentation + * and the queue threshold code we need to add some additional margins to + * make sure the queue will never (or only under extreme load) fill up + * completely. + * Since we don't use preallocated DMA having a large number of queue entries + * will have only minimal impact on the memory requirements for the queue. */ -#define RX_ENTRIES 12 -#define TX_ENTRIES 12 +#define RX_ENTRIES 24 +#define TX_ENTRIES 24 #define BEACON_ENTRIES 1 -#define ATIM_ENTRIES 1 +#define ATIM_ENTRIES 8 /** * enum data_queue_qid: Queue identification + * + * @QID_AC_BE: AC BE queue + * @QID_AC_BK: AC BK queue + * @QID_AC_VI: AC VI queue + * @QID_AC_VO: AC VO queue + * @QID_HCCA: HCCA queue + * @QID_MGMT: MGMT queue (prio queue) + * @QID_RX: RX queue + * @QID_OTHER: None of the above (don't use, only present for completeness) + * @QID_BEACON: Beacon queue (value unspecified, don't send it to device) + * @QID_ATIM: Atim queue (value unspeficied, don't send it to device) */ enum data_queue_qid { QID_AC_BE = 0, @@ -64,68 +78,55 @@ enum data_queue_qid { QID_MGMT = 13, QID_RX = 14, QID_OTHER = 15, -}; - -/** - * enum rt2x00_bcn_queue: Beacon queue index - * - * Start counting with a high offset, this because this enumeration - * supplements &enum ieee80211_tx_queue and we should prevent value - * conflicts. - * - * @RT2X00_BCN_QUEUE_BEACON: Beacon queue - * @RT2X00_BCN_QUEUE_ATIM: Atim queue (sends frame after beacon) - */ -enum rt2x00_bcn_queue { - RT2X00_BCN_QUEUE_BEACON = 100, - RT2X00_BCN_QUEUE_ATIM = 101, + QID_BEACON, + QID_ATIM, }; /** * enum skb_frame_desc_flags: Flags for &struct skb_frame_desc * - * @FRAME_DESC_DRIVER_GENERATED: Frame was generated inside driver - * and should not be reported back to mac80211 during txdone. + * @SKBDESC_DMA_MAPPED_RX: &skb_dma field has been mapped for RX + * @SKBDESC_DMA_MAPPED_TX: &skb_dma field has been mapped for TX */ enum skb_frame_desc_flags { - FRAME_DESC_DRIVER_GENERATED = 1 << 0, + SKBDESC_DMA_MAPPED_RX = (1 << 0), + SKBDESC_DMA_MAPPED_TX = (1 << 1), }; /** * struct skb_frame_desc: Descriptor information for the skb buffer * - * This structure is placed over the skb->cb array, this means that - * this structure should not exceed the size of that array (48 bytes). + * This structure is placed over the driver_data array, this means that + * this structure should not exceed the size of that array (40 bytes). * * @flags: Frame flags, see &enum skb_frame_desc_flags. - * @frame_type: Frame type, see &enum rt2x00_dump_type. - * @data: Pointer to data part of frame (Start of ieee80211 header). + * @desc_len: Length of the frame descriptor. * @desc: Pointer to descriptor part of the frame. * Note that this pointer could point to something outside * of the scope of the skb->data pointer. - * @data_len: Length of the frame data. - * @desc_len: Length of the frame descriptor. - + * @skb_dma: (PCI-only) the DMA address associated with the sk buffer. * @entry: The entry to which this sk buffer belongs. */ struct skb_frame_desc { unsigned int flags; - unsigned int frame_type; - - void *data; + unsigned int desc_len; void *desc; - unsigned int data_len; - unsigned int desc_len; + dma_addr_t skb_dma; struct queue_entry *entry; }; +/** + * get_skb_frame_desc - Obtain the rt2x00 frame descriptor from a sk_buff. + * @skb: &struct sk_buff from where we obtain the &struct skb_frame_desc + */ static inline struct skb_frame_desc* get_skb_frame_desc(struct sk_buff *skb) { - BUILD_BUG_ON(sizeof(struct skb_frame_desc) > sizeof(skb->cb)); - return (struct skb_frame_desc *)&skb->cb[0]; + BUILD_BUG_ON(sizeof(struct skb_frame_desc) > + IEEE80211_TX_INFO_DRIVER_DATA_SIZE); + return (struct skb_frame_desc *)&IEEE80211_SKB_CB(skb)->driver_data; } /** @@ -145,6 +146,7 @@ enum rxdone_entry_desc_flags { * * Summary of information that has been read from the RX frame descriptor. * + * @timestamp: RX Timestamp * @signal: Signal of the received frame. * @rssi: RSSI of the received frame. * @size: Data size of the received frame. @@ -153,6 +155,7 @@ enum rxdone_entry_desc_flags { */ struct rxdone_entry_desc { + u64 timestamp; int signal; int rssi; int size; @@ -161,18 +164,32 @@ struct rxdone_entry_desc { }; /** + * enum txdone_entry_desc_flags: Flags for &struct txdone_entry_desc + * + * @TXDONE_UNKNOWN: Hardware could not determine success of transmission. + * @TXDONE_SUCCESS: Frame was successfully send + * @TXDONE_FAILURE: Frame was not successfully send + * @TXDONE_EXCESSIVE_RETRY: In addition to &TXDONE_FAILURE, the + * frame transmission failed due to excessive retries. + */ +enum txdone_entry_desc_flags { + TXDONE_UNKNOWN = 1 << 0, + TXDONE_SUCCESS = 1 << 1, + TXDONE_FAILURE = 1 << 2, + TXDONE_EXCESSIVE_RETRY = 1 << 3, +}; + +/** * struct txdone_entry_desc: TX done entry descriptor * * Summary of information that has been read from the TX frame descriptor * after the device is done with transmission. * - * @control: Control structure which was used to transmit the frame. - * @status: TX status (See &enum tx_status). + * @flags: TX done flags (See &enum txdone_entry_desc_flags). * @retry: Retry count. */ struct txdone_entry_desc { - struct ieee80211_tx_control *control; - int status; + unsigned long flags; int retry; }; @@ -180,19 +197,25 @@ struct txdone_entry_desc { * enum txentry_desc_flags: Status flags for TX entry descriptor * * @ENTRY_TXD_RTS_FRAME: This frame is a RTS frame. + * @ENTRY_TXD_CTS_FRAME: This frame is a CTS-to-self frame. * @ENTRY_TXD_OFDM_RATE: This frame is send out with an OFDM rate. + * @ENTRY_TXD_FIRST_FRAGMENT: This is the first frame. * @ENTRY_TXD_MORE_FRAG: This frame is followed by another fragment. * @ENTRY_TXD_REQ_TIMESTAMP: Require timestamp to be inserted. * @ENTRY_TXD_BURST: This frame belongs to the same burst event. * @ENTRY_TXD_ACK: An ACK is required for this frame. + * @ENTRY_TXD_RETRY_MODE: When set, the long retry count is used. */ enum txentry_desc_flags { ENTRY_TXD_RTS_FRAME, + ENTRY_TXD_CTS_FRAME, ENTRY_TXD_OFDM_RATE, + ENTRY_TXD_FIRST_FRAGMENT, ENTRY_TXD_MORE_FRAG, ENTRY_TXD_REQ_TIMESTAMP, ENTRY_TXD_BURST, ENTRY_TXD_ACK, + ENTRY_TXD_RETRY_MODE, }; /** @@ -206,6 +229,7 @@ enum txentry_desc_flags { * @length_low: PLCP length low word. * @signal: PLCP signal. * @service: PLCP service. + * @retry_limit: Max number of retries. * @aifs: AIFS value. * @ifs: IFS value. * @cw_min: cwmin value. @@ -221,10 +245,11 @@ struct txentry_desc { u16 signal; u16 service; - int aifs; - int ifs; - int cw_min; - int cw_max; + short retry_limit; + short aifs; + short ifs; + short cw_min; + short cw_max; }; /** @@ -239,12 +264,14 @@ struct txentry_desc { * @ENTRY_OWNER_DEVICE_CRYPTO: This entry is owned by the device for data * encryption or decryption. The entry should only be touched after * the device has signaled it is done with it. + * @ENTRY_DATA_PENDING: This entry contains a valid frame and is waiting + * for the signal to start sending. */ - enum queue_entry_flags { ENTRY_BCN_ASSIGNED, ENTRY_OWNER_DEVICE_DATA, ENTRY_OWNER_DEVICE_CRYPTO, + ENTRY_DATA_PENDING, }; /** @@ -302,6 +329,7 @@ enum queue_index { * index corruption due to concurrency. * @count: Number of frames handled in the queue. * @limit: Maximum number of entries in the queue. + * @threshold: Minimum number of free entries before queue is kicked by force. * @length: Number of frames in queue. * @index: Index pointers to entry positions in the queue, * use &enum queue_index to get a specific index field. @@ -320,6 +348,7 @@ struct data_queue { spinlock_t lock; unsigned int count; unsigned short limit; + unsigned short threshold; unsigned short length; unsigned short index[Q_INDEX_MAX]; @@ -369,7 +398,7 @@ struct data_queue_desc { * the end of the TX queue array. */ #define tx_queue_end(__dev) \ - &(__dev)->tx[(__dev)->hw->queues] + &(__dev)->tx[(__dev)->ops->tx_queues] /** * queue_loop - Loop through the queues within a specific range (HELPER MACRO). @@ -444,6 +473,15 @@ static inline int rt2x00queue_available(struct data_queue *queue) } /** + * rt2x00queue_threshold - Check if the queue is below threshold + * @queue: Queue to check. + */ +static inline int rt2x00queue_threshold(struct data_queue *queue) +{ + return rt2x00queue_available(queue) < queue->threshold; +} + +/** * rt2x00_desc_read - Read a word from the hardware descriptor. * @desc: Base descriptor address * @word: Word index from where the descriptor should be read. |