diff options
Diffstat (limited to 'drivers/net/phy/dp83867.c')
| -rw-r--r-- | drivers/net/phy/dp83867.c | 29 |
1 files changed, 29 insertions, 0 deletions
diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c index 8561f2d4443b..13dafe7a29bd 100644 --- a/drivers/net/phy/dp83867.c +++ b/drivers/net/phy/dp83867.c @@ -137,6 +137,7 @@ #define DP83867_DOWNSHIFT_2_COUNT 2 #define DP83867_DOWNSHIFT_4_COUNT 4 #define DP83867_DOWNSHIFT_8_COUNT 8 +#define DP83867_SGMII_AUTONEG_EN BIT(7) /* CFG3 bits */ #define DP83867_CFG3_INT_OE BIT(7) @@ -855,6 +856,32 @@ static int dp83867_phy_reset(struct phy_device *phydev) DP83867_PHYCR_FORCE_LINK_GOOD, 0); } +static void dp83867_link_change_notify(struct phy_device *phydev) +{ + /* There is a limitation in DP83867 PHY device where SGMII AN is + * only triggered once after the device is booted up. Even after the + * PHY TPI is down and up again, SGMII AN is not triggered and + * hence no new in-band message from PHY to MAC side SGMII. + * This could cause an issue during power up, when PHY is up prior + * to MAC. At this condition, once MAC side SGMII is up, MAC side + * SGMII wouldn`t receive new in-band message from TI PHY with + * correct link status, speed and duplex info. + * Thus, implemented a SW solution here to retrigger SGMII Auto-Neg + * whenever there is a link change. + */ + if (phydev->interface == PHY_INTERFACE_MODE_SGMII) { + int val = 0; + + val = phy_clear_bits(phydev, DP83867_CFG2, + DP83867_SGMII_AUTONEG_EN); + if (val < 0) + return; + + phy_set_bits(phydev, DP83867_CFG2, + DP83867_SGMII_AUTONEG_EN); + } +} + static struct phy_driver dp83867_driver[] = { { .phy_id = DP83867_PHY_ID, @@ -879,6 +906,8 @@ static struct phy_driver dp83867_driver[] = { .suspend = genphy_suspend, .resume = genphy_resume, + + .link_change_notify = dp83867_link_change_notify, }, }; module_phy_driver(dp83867_driver); |