diff options
Diffstat (limited to 'Documentation/devicetree/bindings')
| -rw-r--r-- | Documentation/devicetree/bindings/net/dsa/marvell.txt | 4 | ||||
| -rw-r--r-- | Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt | 2 |
2 files changed, 4 insertions, 2 deletions
diff --git a/Documentation/devicetree/bindings/net/dsa/marvell.txt b/Documentation/devicetree/bindings/net/dsa/marvell.txt index 7ef9dbb08957..1d4d0f49c9d0 100644 --- a/Documentation/devicetree/bindings/net/dsa/marvell.txt +++ b/Documentation/devicetree/bindings/net/dsa/marvell.txt @@ -26,6 +26,10 @@ Optional properties: - interrupt-controller : Indicates the switch is itself an interrupt controller. This is used for the PHY interrupts. #interrupt-cells = <2> : Controller uses two cells, number and flag +- eeprom-length : Set to the length of an EEPROM connected to the + switch. Must be set if the switch can not detect + the presence and/or size of a connected EEPROM, + otherwise optional. - mdio : Container of PHY and devices on the switches MDIO bus. - mdio? : Container of PHYs and devices on the external MDIO diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt index 71a3c134af1b..f01d154090da 100644 --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt @@ -247,7 +247,6 @@ bias-bus-hold - latch weakly bias-pull-up - pull up the pin bias-pull-down - pull down the pin bias-pull-pin-default - use pin-default pull state -bi-directional - pin supports simultaneous input/output operations drive-push-pull - drive actively high and low drive-open-drain - drive with open drain drive-open-source - drive with open source @@ -260,7 +259,6 @@ input-debounce - debounce mode with debound time X power-source - select between different power supplies low-power-enable - enable low power mode low-power-disable - disable low power mode -output-enable - enable output on pin regardless of output value output-low - set the pin to output mode with low level output-high - set the pin to output mode with high level slew-rate - set the slew rate |