diff options
Diffstat (limited to 'Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt | 41 |
1 files changed, 38 insertions, 3 deletions
diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt index 5187f0dd8b28..2c81e45f1374 100644 --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-single.txt @@ -14,10 +14,12 @@ Optional properties: - pinctrl-single,function-off : function off mode for disabled state if available and same for all registers; if not specified, disabling of pin functions is ignored +- pinctrl-single,bit-per-mux : boolean to indicate that one register controls + more than one pin -This driver assumes that there is only one register for each pin, -and uses the common pinctrl bindings as specified in the pinctrl-bindings.txt -document in this directory. +This driver assumes that there is only one register for each pin (unless the +pinctrl-single,bit-per-mux is set), and uses the common pinctrl bindings as +specified in the pinctrl-bindings.txt document in this directory. The pin configuration nodes for pinctrl-single are specified as pinctrl register offset and value pairs using pinctrl-single,pins. Only the bits @@ -31,6 +33,15 @@ device pinctrl register, and 0x118 contains the desired value of the pinctrl register. See the device example and static board pins example below for more information. +In case when one register changes more than one pin's mux the +pinctrl-single,bits need to be used which takes three parameters: + + pinctrl-single,bits = <0xdc 0x18, 0xff>; + +Where 0xdc is the offset from the pinctrl register base address for the +device pinctrl register, 0x18 is the desired value, and 0xff is the sub mask to +be used when applying this change to the register. + Example: /* SoC common file */ @@ -55,6 +66,15 @@ pmx_wkup: pinmux@4a31e040 { pinctrl-single,function-mask = <0xffff>; }; +control_devconf0: pinmux@48002274 { + compatible = "pinctrl-single"; + reg = <0x48002274 4>; /* Single register */ + #address-cells = <1>; + #size-cells = <0>; + pinctrl-single,bit-per-mux; + pinctrl-single,register-width = <32>; + pinctrl-single,function-mask = <0x5F>; +}; /* board specific .dts file */ @@ -87,6 +107,21 @@ pmx_wkup: pinmux@4a31e040 { }; }; +&control_devconf0 { + mcbsp1_pins: pinmux_mcbsp1_pins { + pinctrl-single,bits = < + 0x00 0x18 0x18 /* FSR/CLKR signal from FSX/CLKX pin */ + >; + }; + + mcbsp2_clks_pins: pinmux_mcbsp2_clks_pins { + pinctrl-single,bits = < + 0x00 0x40 0x40 /* McBSP2 CLKS from McBSP_CLKS pin */ + >; + }; + +}; + &uart2 { pinctrl-names = "default"; pinctrl-0 = <&uart2_pins>; |