summaryrefslogtreecommitdiff
path: root/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/devicetree/bindings/mtd/gpmc-nand.txt')
-rw-r--r--Documentation/devicetree/bindings/mtd/gpmc-nand.txt19
1 files changed, 15 insertions, 4 deletions
diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nand.txt b/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
index fb733c4e1c11..3ee7e202657c 100644
--- a/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
@@ -13,7 +13,11 @@ Documentation/devicetree/bindings/mtd/nand.txt
Required properties:
- - reg: The CS line the peripheral is connected to
+ - compatible: "ti,omap2-nand"
+ - reg: range id (CS number), base offset and length of the
+ NAND I/O space
+ - interrupt-parent: must point to gpmc node
+ - interrupts: Two interrupt specifiers, one for fifoevent, one for termcount.
Optional properties:
@@ -44,6 +48,7 @@ Optional properties:
locating ECC errors for BCHx algorithms. SoC devices which have
ELM hardware engines should specify this device node in .dtsi
Using ELM for ECC error correction frees some CPU cycles.
+ - rb-gpios: GPIO specifier for the ready/busy# pin.
For inline partition table parsing (optional):
@@ -55,20 +60,26 @@ Example for an AM33xx board:
gpmc: gpmc@50000000 {
compatible = "ti,am3352-gpmc";
ti,hwmods = "gpmc";
- reg = <0x50000000 0x1000000>;
+ reg = <0x50000000 0x36c>;
interrupts = <100>;
gpmc,num-cs = <8>;
gpmc,num-waitpins = <2>;
#address-cells = <2>;
#size-cells = <1>;
- ranges = <0 0 0x08000000 0x2000>; /* CS0: NAND */
+ ranges = <0 0 0x08000000 0x1000000>; /* CS0 space, 16MB */
elm_id = <&elm>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
nand@0,0 {
- reg = <0 0 0>; /* CS0, offset 0 */
+ compatible = "ti,omap2-nand";
+ reg = <0 0 4>; /* CS0, offset 0, NAND I/O window 4 */
+ interrupt-parent = <&gpmc>;
+ interrupts = <0 IRQ_TYPE_NONE>, <1 IRQ_TYPE NONE>;
nand-bus-width = <16>;
ti,nand-ecc-opt = "bch8";
ti,nand-xfer-type = "polled";
+ rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 */
gpmc,sync-clk-ps = <0>;
gpmc,cs-on-ns = <0>;