diff options
Diffstat (limited to 'Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt | 32 |
1 files changed, 31 insertions, 1 deletions
diff --git a/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt b/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt index 68ac65f82a1c..02c27004d4a8 100644 --- a/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt +++ b/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt @@ -6,7 +6,11 @@ modes. It provides power-gating controllers for SoC and CPU power-islands. Required properties: - name : Should be pmc -- compatible : Should contain "nvidia,tegra<chip>-pmc". +- compatible : For Tegra20, must contain "nvidia,tegra20-pmc". For Tegra30, + must contain "nvidia,tegra30-pmc". For Tegra114, must contain + "nvidia,tegra114-pmc". For Tegra124, must contain "nvidia,tegra124-pmc". + Otherwise, must contain "nvidia,<chip>-pmc", plus at least one of the + above, where <chip> is tegra132. - reg : Offset and length of the register set for the device - clocks : Must contain an entry for each entry in clock-names. See ../clocks/clock-bindings.txt for details. @@ -47,6 +51,23 @@ Required properties when nvidia,suspend-mode=<0>: sleep mode, the warm boot code will restore some PLLs, clocks and then bring up CPU0 for resuming the system. +Hardware-triggered thermal reset: +On Tegra30, Tegra114 and Tegra124, if the 'i2c-thermtrip' subnode exists, +hardware-triggered thermal reset will be enabled. + +Required properties for hardware-triggered thermal reset (inside 'i2c-thermtrip'): +- nvidia,i2c-controller-id : ID of I2C controller to send poweroff command to. Valid values are + described in section 9.2.148 "APBDEV_PMC_SCRATCH53_0" of the + Tegra K1 Technical Reference Manual. +- nvidia,bus-addr : Bus address of the PMU on the I2C bus +- nvidia,reg-addr : I2C register address to write poweroff command to +- nvidia,reg-data : Poweroff command to write to PMU + +Optional properties for hardware-triggered thermal reset (inside 'i2c-thermtrip'): +- nvidia,pinmux-id : Pinmux used by the hardware when issuing poweroff command. + Defaults to 0. Valid values are described in section 12.5.2 + "Pinmux Support" of the Tegra4 Technical Reference Manual. + Example: / SoC dts including file @@ -69,6 +90,15 @@ pmc@7000f400 { / Tegra board dts file { ... + pmc@7000f400 { + i2c-thermtrip { + nvidia,i2c-controller-id = <4>; + nvidia,bus-addr = <0x40>; + nvidia,reg-addr = <0x36>; + nvidia,reg-data = <0x2>; + }; + }; + ... clocks { compatible = "simple-bus"; #address-cells = <1>; |