diff options
Diffstat (limited to 'Documentation/admin-guide/kernel-parameters.txt')
| -rw-r--r-- | Documentation/admin-guide/kernel-parameters.txt | 42 |
1 files changed, 35 insertions, 7 deletions
diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt index 566c4b9af3cd..2991f6e692bd 100644 --- a/Documentation/admin-guide/kernel-parameters.txt +++ b/Documentation/admin-guide/kernel-parameters.txt @@ -113,7 +113,7 @@ the GPE dispatcher. This facility can be used to prevent such uncontrolled GPE floodings. - Format: <byte> + Format: <byte> or <bitmap-list> acpi_no_auto_serialize [HW,ACPI] Disable auto-serialization of AML methods @@ -581,6 +581,28 @@ loops can be debugged more effectively on production systems. + clocksource.max_cswd_read_retries= [KNL] + Number of clocksource_watchdog() retries due to + external delays before the clock will be marked + unstable. Defaults to three retries, that is, + four attempts to read the clock under test. + + clocksource.verify_n_cpus= [KNL] + Limit the number of CPUs checked for clocksources + marked with CLOCK_SOURCE_VERIFY_PERCPU that + are marked unstable due to excessive skew. + A negative value says to check all CPUs, while + zero says not to check any. Values larger than + nr_cpu_ids are silently truncated to nr_cpu_ids. + The actual CPUs are chosen randomly, with + no replacement if the same CPU is chosen twice. + + clocksource-wdtest.holdoff= [KNL] + Set the time in seconds that the clocksource + watchdog test waits before commencing its tests. + Defaults to zero when built as a module and to + 10 seconds when built into the kernel. + clearcpuid=BITNUM[,BITNUM...] [X86] Disable CPUID feature X for the kernel. See arch/x86/include/asm/cpufeatures.h for the valid bit @@ -3244,7 +3266,7 @@ noclflush [BUGS=X86] Don't use the CLFLUSH instruction - nodelayacct [KNL] Disable per-task delay accounting + delayacct [KNL] Enable per-task delay accounting nodsp [SH] Disable hardware DSP at boot time. @@ -3513,6 +3535,9 @@ nr_uarts= [SERIAL] maximum number of UARTs to be registered. + numa=off [KNL, ARM64, PPC, RISCV, SPARC, X86] Disable NUMA, Only + set up a single NUMA node spanning all memory. + numa_balancing= [KNL,ARM64,PPC,RISCV,S390,X86] Enable or disable automatic NUMA balancing. Allowed values are enable and disable @@ -4781,11 +4806,6 @@ Reserves a hole at the top of the kernel virtual address space. - reservelow= [X86] - Format: nn[K] - Set the amount of memory to reserve for BIOS at - the bottom of the address space. - reset_devices [KNL] Force drivers to reset the underlying device during initialization. @@ -5289,6 +5309,14 @@ exception. Default behavior is by #AC if both features are enabled in hardware. + ratelimit:N - + Set system wide rate limit to N bus locks + per second for bus lock detection. + 0 < N <= 1000. + + N/A for split lock detection. + + If an #AC exception is hit in the kernel or in firmware (i.e. not while executing in user mode) the kernel will oops in either "warn" or "fatal" |