spi: orion: Add direct access mode

This patch adds support for the direct access mode to the Orion SPI
driver which is used on the Marvell Armada based SoCs. In this direct
mode, all data written to (or read from) a specifically mapped MBus
window (linked to one SPI chip-select on one of the SPI controllers)
will be transferred directly to the SPI bus. Without the need to control
the SPI registers in between. This can improve the SPI transfer rate in
such cases.

Both, direct-read and -write mode are supported. But only the write
mode has been tested. This mode especially benefits from the SPI direct
mode, as the data bytes are written head-to-head to the SPI bus,
without any additional addresses.

One use-case for this direct write mode is, programming a FPGA bitstream
image into the FPGA connected to the SPI bus at maximum speed.

This mode is described in chapter "22.5.2 Direct Write to SPI" in the
Marvell Armada XP Functional Spec Datasheet.

Signed-off-by: Stefan Roese <sr@denx.de>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Mark Brown <broonie@kernel.org>

1 files changed, 88 insertions, 0 deletions

diff --git a/drivers/spi/spi-orion.c b/drivers/spi/spi-orion.c
index a87cfd4ba17b..d0d9c8682b32 100644
--- a/drivers/spi/spi-orion.c
+++ b/drivers/spi/spi-orion.c
@@ -18,6 +18,7 @@
 #include <linux/module.h>
 #include <linux/pm_runtime.h>
 #include <linux/of.h>
+#include <linux/of_address.h>
 #include <linux/of_device.h>
 #include <linux/clk.h>
 #include <linux/sizes.h>
@@ -43,6 +44,9 @@
 #define ORION_SPI_INT_CAUSE_REG		0x10
 #define ORION_SPI_TIMING_PARAMS_REG	0x18
 
+/* Register for the "Direct Mode" */
+#define SPI_DIRECT_WRITE_CONFIG_REG	0x20
+
 #define ORION_SPI_TMISO_SAMPLE_MASK	(0x3 << 6)
 #define ORION_SPI_TMISO_SAMPLE_1	(1 << 6)
 #define ORION_SPI_TMISO_SAMPLE_2	(2 << 6)
@@ -78,11 +82,18 @@ struct orion_spi_dev {
 	bool			is_errata_50mhz_ac;
 };
 
+struct orion_direct_acc {
+	void __iomem		*vaddr;
+	u32			size;
+};
+
 struct orion_spi {
 	struct spi_master	*master;
 	void __iomem		*base;
 	struct clk              *clk;
 	const struct orion_spi_dev *devdata;
+
+	struct orion_direct_acc	direct_access[ORION_NUM_CHIPSELECTS];
 };
 
 static inline void __iomem *spi_reg(struct orion_spi *orion_spi, u32 reg)
@@ -372,10 +383,39 @@ orion_spi_write_read(struct spi_device *spi, struct spi_transfer *xfer)
 {
 	unsigned int count;
 	int word_len;
+	struct orion_spi *orion_spi;
+	int cs = spi->chip_select;
 
 	word_len = spi->bits_per_word;
 	count = xfer->len;
 
+	orion_spi = spi_master_get_devdata(spi->master);
+
+	/*
+	 * Use SPI direct write mode if base address is available. Otherwise
+	 * fall back to PIO mode for this transfer.
+	 */
+	if ((orion_spi->direct_access[cs].vaddr) && (xfer->tx_buf) &&
+	    (word_len == 8)) {
+		unsigned int cnt = count / 4;
+		unsigned int rem = count % 4;
+
+		/*
+		 * Send the TX-data to the SPI device via the direct
+		 * mapped address window
+		 */
+		iowrite32_rep(orion_spi->direct_access[cs].vaddr,
+			      xfer->tx_buf, cnt);
+		if (rem) {
+			u32 *buf = (u32 *)xfer->tx_buf;
+
+			iowrite8_rep(orion_spi->direct_access[cs].vaddr,
+				     &buf[cnt], rem);
+		}
+
+		return count;
+	}
+
 	if (word_len == 8) {
 		const u8 *tx = xfer->tx_buf;
 		u8 *rx = xfer->rx_buf;
@@ -425,6 +465,10 @@ static int orion_spi_reset(struct orion_spi *orion_spi)
 {
 	/* Verify that the CS is deasserted */
 	orion_spi_clrbits(orion_spi, ORION_SPI_IF_CTRL_REG, 0x1);
+
+	/* Don't deassert CS between the direct mapped SPI transfers */
+	writel(0, spi_reg(orion_spi, SPI_DIRECT_WRITE_CONFIG_REG));
+
 	return 0;
 }
 
@@ -504,6 +548,7 @@ static int orion_spi_probe(struct platform_device *pdev)
 	struct resource *r;
 	unsigned long tclk_hz;
 	int status = 0;
+	struct device_node *np;
 
 	master = spi_alloc_master(&pdev->dev, sizeof(*spi));
 	if (master == NULL) {
@@ -576,6 +621,49 @@ static int orion_spi_probe(struct platform_device *pdev)
 		goto out_rel_clk;
 	}
 
+	/* Scan all SPI devices of this controller for direct mapped devices */
+	for_each_available_child_of_node(pdev->dev.of_node, np) {
+		u32 cs;
+
+		/* Get chip-select number from the "reg" property */
+		status = of_property_read_u32(np, "reg", &cs);
+		if (status) {
+			dev_err(&pdev->dev,
+				"%s has no valid 'reg' property (%d)\n",
+				np->full_name, status);
+			status = 0;
+			continue;
+		}
+
+		/*
+		 * Check if an address is configured for this SPI device. If
+		 * not, the MBus mapping via the 'ranges' property in the 'soc'
+		 * node is not configured and this device should not use the
+		 * direct mode. In this case, just continue with the next
+		 * device.
+		 */
+		status = of_address_to_resource(pdev->dev.of_node, cs + 1, r);
+		if (status)
+			continue;
+
+		/*
+		 * Only map one page for direct access. This is enough for the
+		 * simple TX transfer which only writes to the first word.
+		 * This needs to get extended for the direct SPI-NOR / SPI-NAND
+		 * support, once this gets implemented.
+		 */
+		spi->direct_access[cs].vaddr = devm_ioremap(&pdev->dev,
+							    r->start,
+							    PAGE_SIZE);
+		if (IS_ERR(spi->direct_access[cs].vaddr)) {
+			status = PTR_ERR(spi->direct_access[cs].vaddr);
+			goto out_rel_clk;
+		}
+		spi->direct_access[cs].size = PAGE_SIZE;
+
+		dev_info(&pdev->dev, "CS%d configured for direct access\n", cs);
+	}
+
 	pm_runtime_set_active(&pdev->dev);
 	pm_runtime_use_autosuspend(&pdev->dev);
 	pm_runtime_set_autosuspend_delay(&pdev->dev, SPI_AUTOSUSPEND_TIMEOUT);