Merge tag 'pinctrl-v4.7-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

Pull pin control updates from Linus Walleij:
 "This kernel cycle was quite calm when it comes to pin control and
  there is really just one major change, and that is the introduction of
  devm_pinctrl_register() managed resources.

  Apart from that linear development, details below.

  Core changes:

   - Add the devm_pinctrl_register() API and switch all applicable
     drivers to use it, saving lots of lines of code all over the place.

  New drivers:

   - driver for the Broadcom NS2 SoC

   - subdriver for the PXA25x SoCs

   - subdriver for the AMLogic Meson GXBB SoC

  Driver improvements:

   - the Intel Baytrail driver now properly supports pin control

   - Nomadik, Rockchip, Broadcom BCM2835 support the .get_direction()
     callback in the GPIO portions

   - continued development and stabilization of several SH-PFC SoC
     subdrivers: r8a7795, r8a7790, r8a7794 etc"

* tag 'pinctrl-v4.7-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (85 commits)
  Revert "pinctrl: tegra: avoid parked_reg and parked_bank"
  pinctrl: meson: Fix eth_tx_en bit index
  pinctrl: tegra: avoid parked_reg and parked_bank
  pinctrl: tegra: Correctly check the supported configuration
  pinctrl: amlogic: Add support for Amlogic Meson GXBB SoC
  pinctrl: rockchip: fix pull setting error for rk3399
  pinctrl: stm32: Implement .pin_config_dbg_show()
  pinctrl: nomadik: hide nmk_gpio_get_mode when unused
  pinctrl: ns2: rename pinctrl_utils_dt_free_map
  pinctrl: at91: Merge clk_prepare and clk_enable into clk_prepare_enable
  pinctrl: at91: Make at91_gpio_template const
  pinctrl: baytrail: fix some error handling in debugfs
  pinctrl: ns2: add pinmux driver support for Broadcom NS2 SoC
  pinctrl: sirf/atlas7: trivial fix of spelling mistake on flagged
  pinctrl: sh-pfc: Kill unused variable in sh_pfc_remove()
  pinctrl: nomadik: implement .get_direction()
  pinctrl: nomadik: use BIT() with offsets consequently
  pinctrl: exynos5440: Use off-stack memory for pinctrl_gpio_range
  pinctrl: zynq: Use devm_pinctrl_register() for pinctrl registration
  pinctrl: u300: Use devm_pinctrl_register() for pinctrl registration
  ...

1 files changed, 14 insertions, 2 deletions

diff --git a/drivers/pinctrl/bcm/pinctrl-bcm2835.c b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
index 08b1d93da9fe..fa77165fab2c 100644
--- a/drivers/pinctrl/bcm/pinctrl-bcm2835.c
+++ b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
@@ -342,6 +342,18 @@ static int bcm2835_gpio_get(struct gpio_chip *chip, unsigned offset)
 	return bcm2835_gpio_get_bit(pc, GPLEV0, offset);
 }
 
+static int bcm2835_gpio_get_direction(struct gpio_chip *chip, unsigned int offset)
+{
+	struct bcm2835_pinctrl *pc = gpiochip_get_data(chip);
+	enum bcm2835_fsel fsel = bcm2835_pinctrl_fsel_get(pc, offset);
+
+	/* Alternative function doesn't clearly provide a direction */
+	if (fsel > BCM2835_FSEL_GPIO_OUT)
+		return -EINVAL;
+
+	return (fsel == BCM2835_FSEL_GPIO_IN);
+}
+
 static void bcm2835_gpio_set(struct gpio_chip *chip, unsigned offset, int value)
 {
 	struct bcm2835_pinctrl *pc = gpiochip_get_data(chip);
@@ -370,6 +382,7 @@ static struct gpio_chip bcm2835_gpio_chip = {
 	.free = gpiochip_generic_free,
 	.direction_input = bcm2835_gpio_direction_input,
 	.direction_output = bcm2835_gpio_direction_output,
+	.get_direction = bcm2835_gpio_get_direction,
 	.get = bcm2835_gpio_get,
 	.set = bcm2835_gpio_set,
 	.to_irq = bcm2835_gpio_to_irq,
@@ -1027,7 +1040,7 @@ static int bcm2835_pinctrl_probe(struct platform_device *pdev)
 		return err;
 	}
 
-	pc->pctl_dev = pinctrl_register(&bcm2835_pinctrl_desc, dev, pc);
+	pc->pctl_dev = devm_pinctrl_register(dev, &bcm2835_pinctrl_desc, pc);
 	if (IS_ERR(pc->pctl_dev)) {
 		gpiochip_remove(&pc->gpio_chip);
 		return PTR_ERR(pc->pctl_dev);
@@ -1045,7 +1058,6 @@ static int bcm2835_pinctrl_remove(struct platform_device *pdev)
 {
 	struct bcm2835_pinctrl *pc = platform_get_drvdata(pdev);
 
-	pinctrl_unregister(pc->pctl_dev);
 	gpiochip_remove(&pc->gpio_chip);
 
 	return 0;