diff options
| author | Roger Quadros <rogerq@ti.com> | 2014-08-26 03:15:32 +0400 |
|---|---|---|
| committer | Tony Lindgren <tony@atomide.com> | 2014-08-26 03:15:32 +0400 |
| commit | 7d5929c1f34304ca5a970cfde8044053e56aa8c9 (patch) | |
| tree | 411c3fa537815dd726d4123a59f208402260483f /arch/arm/mach-omap2/board-flash.c | |
| parent | 52addcf9d6669fa439387610bc65c92fa0980cef (diff) | |
| download | linux-7d5929c1f34304ca5a970cfde8044053e56aa8c9.tar.xz | |
mtd: nand: omap: Revert to using software ECC by default
For v3.12 and prior, 1-bit Hamming code ECC via software was the
default choice. Commit c66d039197e4 in v3.13 changed the behaviour
to use 1-bit Hamming code via Hardware using a different ECC layout
i.e. (ROM code layout) than what is used by software ECC.
This ECC layout change causes NAND filesystems created in v3.12
and prior to be unusable in v3.13 and later. So revert back to
using software ECC by default if an ECC scheme is not explicitely
specified.
This defect can be observed on the following boards during legacy boot
-omap3beagle
-omap3touchbook
-overo
-am3517crane
-devkit8000
-ldp
-3430sdp
Signed-off-by: Roger Quadros <rogerq@ti.com>
Tested-by: Grazvydas Ignotas <notasas@gmail.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Diffstat (limited to 'arch/arm/mach-omap2/board-flash.c')
| -rw-r--r-- | arch/arm/mach-omap2/board-flash.c | 2 |
1 files changed, 1 insertions, 1 deletions
diff --git a/arch/arm/mach-omap2/board-flash.c b/arch/arm/mach-omap2/board-flash.c index e87f2a83d6bf..2d245c2e641c 100644 --- a/arch/arm/mach-omap2/board-flash.c +++ b/arch/arm/mach-omap2/board-flash.c @@ -142,7 +142,7 @@ __init board_nand_init(struct mtd_partition *nand_parts, u8 nr_parts, u8 cs, board_nand_data.nr_parts = nr_parts; board_nand_data.devsize = nand_type; - board_nand_data.ecc_opt = OMAP_ECC_HAM1_CODE_HW; + board_nand_data.ecc_opt = OMAP_ECC_HAM1_CODE_SW; gpmc_nand_init(&board_nand_data, gpmc_t); } #endif /* CONFIG_MTD_NAND_OMAP2 || CONFIG_MTD_NAND_OMAP2_MODULE */ |