Linux-2.6.12-rc2v2.6.12-rc2

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!

1 files changed, 53 insertions, 0 deletions

diff --git a/Documentation/sound/oss/Soundblaster b/Documentation/sound/oss/Soundblaster
new file mode 100644
index 000000000000..b288d464ba8b
--- /dev/null
+++ b/Documentation/sound/oss/Soundblaster
@@ -0,0 +1,53 @@
+modprobe sound
+insmod uart401
+insmod sb ...
+
+This loads the driver for the Sound Blaster and assorted clones. Cards that
+are covered by other drivers should not be using this driver.
+
+The Sound Blaster module takes the following arguments
+
+io		I/O address of the Sound Blaster chip (0x220,0x240,0x260,0x280)
+irq		IRQ of the Sound Blaster chip (5,7,9,10)
+dma		8-bit DMA channel for the Sound Blaster (0,1,3)
+dma16		16-bit DMA channel for SB16 and equivalent cards (5,6,7)
+mpu_io		I/O for MPU chip if present (0x300,0x330)
+
+sm_games=1	Set if you have a Logitech soundman games
+acer=1		Set this to detect cards in some ACER notebooks
+mwave_bug=1	Set if you are trying to use this driver with mwave (see on)
+type		Use this to specify a specific card type
+
+The following arguments are taken if ISAPnP support is compiled in
+
+isapnp=0	Set this to disable ISAPnP detection (use io=0xXXX etc. above)
+multiple=0	Set to disable detection of multiple Soundblaster cards.
+		Consider it a bug if this option is needed, and send in a
+		report.
+pnplegacy=1	Set this to be able to use a PnP card(s) along with a single
+		non-PnP (legacy) card.  Above options for io, irq, etc. are
+		needed, and will apply only to the legacy card.
+reverse=1	Reverses the order of the search in the PnP table.
+uart401=1	Set to enable detection of mpu devices on some clones.
+isapnpjump=n	Jumps to slot n in the driver's PnP table. Use the source,
+		Luke.
+
+You may well want to load the opl3 driver for synth music on most SB and
+clone SB devices
+
+insmod opl3 io=0x388
+
+Using Mwave
+
+To make this driver work with Mwave you must set mwave_bug. You also need
+to warm boot from DOS/Windows with the required firmware loaded under this
+OS. IBM are being difficult about documenting how to load this firmware.
+
+Avance Logic ALS007
+
+This card is supported; see the separate file ALS007 for full details.
+
+Avance Logic ALS100
+
+This card is supported; setup should be as for a standard Sound Blaster 16.
+The driver will identify the audio device as a "Sound Blaster 16 (ALS-100)".