Merge remote-tracking branch 'origin/next' into kvm-ppc-next

Conflicts:
	mm/Kconfig

CMA DMA split and ZSWAP introduction were conflicting, fix up manually.

1 files changed, 35 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/sound/adi,adau1701.txt b/Documentation/devicetree/bindings/sound/adi,adau1701.txt
new file mode 100644
index 000000000000..547a49b56a62
--- /dev/null
+++ b/Documentation/devicetree/bindings/sound/adi,adau1701.txt
@@ -0,0 +1,35 @@
+Analog Devices ADAU1701
+
+Required properties:
+
+ - compatible:		Should contain "adi,adau1701"
+ - reg:			The i2c address. Value depends on the state of ADDR0
+			and ADDR1, as wired in hardware.
+
+Optional properties:
+
+ - reset-gpio: 		A GPIO spec to define which pin is connected to the
+			chip's !RESET pin. If specified, the driver will
+			assert a hardware reset at probe time.
+ - adi,pll-mode-gpios:	An array of two GPIO specs to describe the GPIOs
+			the ADAU's PLL config pins are connected to.
+			The state of the pins are set according to the
+			configured clock divider on ASoC side before the
+			firmware is loaded.
+ - adi,pin-config:	An array of 12 numerical values selecting one of the
+			pin configurations as described in the datasheet,
+			table 53. Note that the value of this property has
+			to be prefixed with '/bits/ 8'.
+
+Examples:
+
+	i2c_bus {
+		adau1701@34 {
+			compatible = "adi,adau1701";
+			reg = <0x34>;
+			reset-gpio = <&gpio 23 0>;
+			adi,pll-mode-gpios = <&gpio 24 0 &gpio 25 0>;
+			adi,pin-config = /bits/ 8 <0x4 0x7 0x5 0x5 0x4 0x4
+                                                   0x4 0x4 0x4 0x4 0x4 0x4>;
+		};
+	};