Merge branch 'mvebu/drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

Merge the mvebu/drivers branch of the arm-soc tree which contains
just a single patch bfa1ce5f38938cc9e6c7f2d1011f88eba2b9e2b2 ("bus:
mvebu-mbus: add mv_mbus_dram_info_nooverlap()") that happens to be
a prerequisite of the new marvell/cesa crypto driver.

1 files changed, 52 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7038-l1-intc.txt b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7038-l1-intc.txt
new file mode 100644
index 000000000000..cc217b22dccd
--- /dev/null
+++ b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7038-l1-intc.txt
@@ -0,0 +1,52 @@
+Broadcom BCM7038-style Level 1 interrupt controller
+
+This block is a first level interrupt controller that is typically connected
+directly to one of the HW INT lines on each CPU.  Every BCM7xxx set-top chip
+since BCM7038 has contained this hardware.
+
+Key elements of the hardware design include:
+
+- 64, 96, 128, or 160 incoming level IRQ lines
+
+- Most onchip peripherals are wired directly to an L1 input
+
+- A separate instance of the register set for each CPU, allowing individual
+  peripheral IRQs to be routed to any CPU
+
+- Atomic mask/unmask operations
+
+- No polarity/level/edge settings
+
+- No FIFO or priority encoder logic; software is expected to read all
+  2-5 status words to determine which IRQs are pending
+
+Required properties:
+
+- compatible: should be "brcm,bcm7038-l1-intc"
+- reg: specifies the base physical address and size of the registers;
+  the number of supported IRQs is inferred from the size argument
+- interrupt-controller: identifies the node as an interrupt controller
+- #interrupt-cells: specifies the number of cells needed to encode an interrupt
+  source, should be 1.
+- interrupt-parent: specifies the phandle to the parent interrupt controller(s)
+  this one is cascaded from
+- interrupts: specifies the interrupt line(s) in the interrupt-parent controller
+  node; valid values depend on the type of parent interrupt controller
+
+If multiple reg ranges and interrupt-parent entries are present on an SMP
+system, the driver will allow IRQ SMP affinity to be set up through the
+/proc/irq/ interface.  In the simplest possible configuration, only one
+reg range and one interrupt-parent is needed.
+
+Example:
+
+periph_intc: periph_intc@1041a400 {
+        compatible = "brcm,bcm7038-l1-intc";
+        reg = <0x1041a400 0x30 0x1041a600 0x30>;
+
+        interrupt-controller;
+        #interrupt-cells = <1>;
+
+        interrupt-parent = <&cpu_intc>;
+        interrupts = <2>, <3>;
+};