kernel/linux.git/tools/testing/selftests/net/forwarding, branch linux-7.0.y

selftests: net: bridge_vlan_mcast: wait for h1 before querier check

2026-04-08T03:16:16+00:00

The querier-interval test adds h1 (currently a slave of the VRF created by simple_if_init) to a temporary bridge br1 acting as an outside IGMP querier. The kernel VRF driver (drivers/net/vrf.c) calls cycle_netdev() on every slave add and remove, toggling the interface admin-down then up. Phylink takes the PHY down during the admin-down half of that cycle. Since h1 and swp1 are cable-connected, swp1 also loses its link may need several seconds to re-negotiate. Use setup_wait_dev $h1 0 which waits for h1 to return to UP state, so the test can rely on the link being back up at this point. Fixes: 4d8610ee8bd77 ("selftests: net: bridge: add vlan mcast_querier_interval tests") Signed-off-by: Daniel Golle Reviewed-by: Alexander Sverdlin Link: https://patch.msgid.link/c830f130860fd2efae08bfb9e5b25fd028e58ce5.1775424423.git.daniel@makrotopia.org Signed-off-by: Jakub Kicinski

selftests: tc_actions: don't dump 2MB of \0 to stdout

2026-02-18T01:13:07+00:00

Since we started running selftests in NIPA we have been seeing tc_actions.sh generate a soft lockup warning on ~20% of the runs. On the pre-netdev foundation setup it was actually a missed irq splat from the console. Now it's either that or a lockup. I initially suspected a socket locking issue since the test is exercising local loopback with act_mirred. After hours of staring at this I noticed in strace that ncat when -o $file is specified _both_ saves the output to the file and still prints it to stdout. Because the file being sent is constructed with: dd conv=sparse status=none if=/dev/zero bs=1M count=2 of=$mirred ^^^^^^^^^ the data printed is all \0. Most terminals don't display nul characters (and neither does vng output capture save them). But QEMU's serial console still has to poke them thru which is very slow and causes the lockup (if the file is >600kB). Replace the '-o $file' with '> $file'. This speeds the test up from 2m20s to 18s on debug kernels, and prevents the warnings. Fixes: ca22da2fbd69 ("act_mirred: use the backlog for nested calls to mirred ingress") Reviewed-by: Simon Horman Link: https://patch.msgid.link/20260214035159.2119699-1-kuba@kernel.org Signed-off-by: Jakub Kicinski

selftests: forwarding: fix pedit tests failure with br_netfilter enabled

2026-02-17T12:34:18+00:00

The tests use the tc pedit action to modify the IPv4 source address ("pedit ex munge ip src set"), but the IP header checksum is not recalculated after the modification. As a result, the modified packet fails sanity checks in br_netfilter after bridging and is dropped, which causes the test to fail. Fix this by ensuring net.bridge.bridge-nf-call-iptables is set to 0 during the test execution. This prevents the bridge from passing L2 traffic to netfilter, bypassing the checksum validation that causes the test failure. Fixes: 92ad3828944e ("selftests: forwarding: Add a test for pedit munge SIP and DIP") Fixes: 226657ba2389 ("selftests: forwarding: Add a forwarding test for pedit munge dsfield") Signed-off-by: Aleksei Oladko Reviewed-by: Ido Schimmel Link: https://patch.msgid.link/20260213131907.43351-4-aleksey.oladko@virtuozzo.com Signed-off-by: Paolo Abeni

selftests: forwarding: vxlan_bridge_1d_ipv6: fix test failure with br_netfilter enabled

2026-02-17T12:34:11+00:00

The test generates VXLAN traffic using mausezahn, where the encapsulated inner IPv6 packet has an incorrect payload length set in the IPv6 header. After VXLAN decapsulation, such packets do not pass sanity checks in br_netfilter and are dropped, which causes the test to fail. Fix this by setting the correct IPv6 payload length for the encapsulated packet generated by mausezahn, so that the packet is accepted by br_netfilter. tools/testing/selftests/net/forwarding/vxlan_bridge_1d_ipv6.sh lines 698-706 )"00:03:"$( : Payload length )"3a:"$( : Next header )"04:"$( : Hop limit )"$saddr:"$( : IP saddr )"$daddr:"$( : IP daddr )"80:"$( : ICMPv6.type )"00:"$( : ICMPv6.code )"00:"$( : ICMPv6.checksum ) Data after IPv6 header: • 80: — 1 byte (ICMPv6 type) • 00: — 1 byte (ICMPv6 code) • 00: — 1 byte (ICMPv6 checksum, truncated) Total: 3 bytes → 00:03 is correct. The old value 00:08 did not match the actual payload size. Fixes: b07e9957f220 ("selftests: forwarding: Add VxLAN tests with a VLAN-unaware bridge for IPv6") Signed-off-by: Aleksei Oladko Reviewed-by: Ido Schimmel Link: https://patch.msgid.link/20260213131907.43351-3-aleksey.oladko@virtuozzo.com Signed-off-by: Paolo Abeni

selftests: forwarding: vxlan_bridge_1d: fix test failure with br_netfilter enabled

2026-02-17T12:34:11+00:00

The test generates VXLAN traffic using mausezahn, where the encapsulated inner IPv4 packet contains a zero IP header checksum. After VXLAN decapsulation, such packets do not pass sanity checks in br_netfilter and are dropped, which causes the test to fail. Fix this by calculating and setting a valid IPv4 header checksum for the encapsulated packet generated by mausezahn, so that the packet is accepted by br_netfilter. Fixed by using the payload_template_calc_checksum() / payload_template_expand_checksum() helpers that are only available in v6.3 and newer kernels. Fixes: a0b61f3d8ebf ("selftests: forwarding: vxlan_bridge_1d: Add an ECN decap test") Signed-off-by: Aleksei Oladko Reviewed-by: Ido Schimmel Link: https://patch.msgid.link/20260213131907.43351-2-aleksey.oladko@virtuozzo.com Signed-off-by: Paolo Abeni

selftests: forwarding: bridge_mdb_max: add tests for mdb_n_entries warning

2026-02-17T12:00:14+00:00

Recently we were able to trigger a warning in the mdb_n_entries counting code. Add tests that exercise different ways which used to trigger that warning. Reviewed-by: Ido Schimmel Signed-off-by: Nikolay Aleksandrov Link: https://patch.msgid.link/20260213070031.1400003-3-nikolay@nvidia.com Signed-off-by: Paolo Abeni

selftests: forwarding: update PTP tcpdump patterns

2026-01-10T01:35:23+00:00

Recent version of tcpdump (tcpdump-4.99.6-1.fc43.x86_64) seems to have removed the spurious space after msg type in PTP info, e.g.: before: PTPv2, majorSdoId: 0x0, msg type : sync msg, length: 44 after: PTPv2, majorSdoId: 0x0, msg type: sync msg, length: 44 Update our patterns to match both. Reviewed-by: Alexander Sverdlin Link: https://patch.msgid.link/20260107145320.1837464-1-kuba@kernel.org Signed-off-by: Jakub Kicinski

selftests: forwarding: vxlan_bridge_1q_mc_ul: Drop useless sleeping

2025-12-11T08:53:16+00:00

After fixing traffic matching in the previous patch, the test does not need to use the sleep anymore. So drop vx_wait() altogether, migrate all callers of vx{10,20}_create_wait() to the corresponding _create(), and drop the now unused _create_wait() helpers. Signed-off-by: Petr Machata Reviewed-by: Ido Schimmel Link: https://patch.msgid.link/eabfe4fa12ae788cf3b8c5c876a989de81dfc3d3.1765289566.git.petrm@nvidia.com Signed-off-by: Jakub Kicinski

selftests: forwarding: vxlan_bridge_1q_mc_ul: Fix flakiness

2025-12-11T08:53:15+00:00

This test runs an overlay traffic, forwarded over a multicast-routed VXLAN underlay. In order to determine whether packets reach their intended destination, it uses a TC match. For convenience, it uses a flower match, which however does not allow matching on the encapsulated packet. So various service traffic ends up being indistinguishable from the test packets, and ends up confusing the test. To alleviate the problem, the test uses sleep to allow the necessary service traffic to run and clear the channel, before running the test traffic. This worked for a while, but lately we have nevertheless seen flakiness of the test in the CI. Fix the issue by using u32 to match the encapsulated packet as well. The confusing packets seem to always be IPv6 multicast listener reports. Realistically they could be ARP or other ICMP6 traffic as well. Therefore look for ethertype IPv4 in the IPv4 traffic test, and for IPv6 / UDP combination in the IPv6 traffic test. Signed-off-by: Petr Machata Reviewed-by: Ido Schimmel Link: https://patch.msgid.link/6438cb1613a2a667d3ff64089eb5994778f247af.1765289566.git.petrm@nvidia.com Signed-off-by: Jakub Kicinski

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2025-11-20T17:13:26+00:00

Cross-merge networking fixes after downstream PR (net-6.18-rc7). No conflicts, adjacent changes: tools/testing/selftests/net/af_unix/Makefile e1bb28bf13f4 ("selftest: af_unix: Add test for SO_PEEK_OFF.") 45a1cd8346ca ("selftests: af_unix: Add tests for ECONNRESET and EOF semantics") Signed-off-by: Jakub Kicinski